2003 TOYOTA SEQUOIA Complaints

UNKNOWN I'm unsure of what is causing it but it is a very common issue with the 03-04 sequoia. The brake light will come on like on mine and apparently it's a failure in one of the brake components. It's either the brake booster or the master cylinder in most cases is starting to g out. I've done research on this issue and it's a very common problem costing people thousands to get fixed. I feel like if it's that huge of a problem like I've seen with sequoia owners than it's needs to be addressed in a better manner

I want to bring attention to the a fatal flaw designed into Toyota truck frames. I understand Toyota denied my claim and I am out of luck with the repairs on my truck. However it is morally responsible for me to bring awareness to this deadly issue. Since most owners don't know they have a problem until the frame breaks, it is worth raising awareness to save human life. This is not a cosmetic issue, its a life or death issue for the consumer. The frame on my truck is completely rusted. In 2013, a Toyota dealership did a frame inspection on my 2003 truck per the recall notice to the previous owner. Toyota had a safety recall for a two step frame replacement for 12 years. The inspection noted an excessive amount of corrosion and rust on the frame components. In 2014, another Toyota dealership decided to spray a sealer over the rust instead of replacing the frame. The sealer trapped moisture and accelerated the oxidation process. This made the problem worse and the rust spread and destroyed the metal to a point its not repairable or safe to drive. The frame of the truck is only 20 years old and was garage kept. However it was operated in a cold climate where salt is applied to the roadways. After filing a several cases with Toyota US I was told its the consumers responsibility and the case was denied. Me and the previous owner did follow the guidelines set forth by the safety frame recall. Since Toyota worked on the frame during the time of the recall they should be held responsible for any liability to human life. Now that these vehicle are starting to age we will start see fatalities on our roadways that will be directly linked to bad frame design. Crumple zones and vehicle safety systems are not effective when the structure they are built upon are defective. I have attached pictures and dealer paperwork for review.

I recently purchased my 2003 Toyota Sequoia SR5 4WD that had the manufacturer’s undercoating done as a result of the LSC in 2013. The coating has failed and water was able to seep in causing massive rust on the frame. It is a safety hazard to drive at this point.

I have a 2003 Toyota Sequoia 167k miles that has major frame rust. This is now becoming a safety issue and Toyota needs to be held accountable!

The contact owns a 2003 Toyota Sequoia. The contact stated while parking the vehicle, the contact noticed smoke coming from under the hood of the vehicle. The contact stated while depressing the brake pedal, he felt the vehicle made a sudden stop. The contact checked under the hood and noticed that the VSC box was melting. The contact disconnected the battery to the vehicle and the smoke stopped. The vehicle was not diagnosed. The manufacturer was not contacted. The failure mileage was 200,000.

Undercarriage frame found to be badly rusted, by a AAA Driver who came to my roadside assistance following a brake failure due to rusted and leaky brake lines.

"VSC OFF, VSC TRAC, and ABS" indicators on the dash. YAW sensor failure which controls wheel speed which will cause vehicle to decelerate and possibly cause an accident. Toyota should issue a nationwide recall. Toyota is aware of the issue but has failed to issue a nationwide recall.

Abnormal rust all over underside of vehicle including frame, structural components, brake lines, steering components … etc. FRAME and steering/suspension components rusting out. Rear differential rusting out. Cab mounts rusting out. Spare tire hardware rusting out. Transmission cooler lines about to burst from corrosion. Rear tow assembly rusting out. Entire underside is rotting out. Known issue which has plagued hundreds of owners, but Toyota has not recalled this model year. Extremely dangerous; one brake line has already gone out resulting in a loss of braking. Toyota applied an undercoating circa 2013 but they just sprayed over an already rusted frame and other components without proper preparation which actually accelerated the corrosion and rot. Deceptive and unethical business practices. Vehicle cost over $50,000 new in 2003 and only has just over 120,000 miles on it. This should NOT be happening. Please help. Please investigate.

Hello, I am writing to you to have an investigation started on 2003 Toyota Sequoia, I own one and there has been concerns with the Frame of the vehicle rotting out, there was Warranty Enhancement Program sent out in United States to cover frames of 2001 to 2004 Toyota Sequoias which replaced severely rusted out frames at the dealership. I use this vehicle for my family and I do not want to endanger the lives of them and the people around the community where the frame may break due to rust and cause a severe accident. Please take a look at the details below and get back to me. Subject: Limited Service Campaign (LSC) CSD Certain 2001 through 2004 Model Year Sequoia Vehicles Frame Inspection I am located in Canada would like NHSTA to investigate and see if this program can be administered to vehicles in Canada since I have severe rotting of the frame and I have had to have it welded many times to not compromise the safety of the vehicle

My gas gauge sensor consistently drops below the “E” marker when the truck has gas in it and especially when it is filled up. After driving about 50 miles or so, the gauge will move up some ; however, I have been relying on my DTE monitor to let me know about gas. I have taken it to the dealer twice and both said “the gas tank needs to be dropped in order for repair” I was About to pay for the service but was told I had to make an appointment. However the service advise ask had I had it replaced before because there was a recall on that particular part several years ago. Please note I have never received any notice about a recall regarding the issue. Please advise.