2002 TOYOTA TUNDRA Complaints

I was doing maintenance on front and lifted splash guard for access to bolt. On top of the frame, near the firewall, was severe rust. It looks as if the frame could crack at any time. If this happened in highway speed or in traffic, severe risk of injuries. These are known to have issues in salt states (had recalls) and I thought I checked it pretty good before buying. I think this may be from the air conditioning drain system.

There are several issues with these seatbelts. They either lock before we can get them buckled or once we unbuckle them, they do not retract and hang out the door, thus draining the battery. They get twisted and stuck in the plastic guide toward the top of the door. The last time this happened, I could not get the seatbelt unstuck despite working on it for almost an hour. I ended up cutting the seatbelt to get it unstuck. Now it is EXTREMELY difficult to use. I need to get it replaced ASAP at my own expense. Very unsafe not to mention frustrating. Also, worth noting is this has been an ongoing problem for years.

The contact owns 2002 Toyota Tundra. The contact stated that upon taking the vehicle to an independent mechanic for an oil change and tire rotation, she was informed that the subframe was severely corroded, and the vehicle was unsafe to be driven. The dealer and the manufacturer were not notified of the failure. The vehicle was not repaired. The failure mileage was approximately 250,000.

The contact owns a 2002 Toyota Tundra. The contact stated that while the vehicle was in for routine maintenance, the mechanic discovered severe rusting and corrosion on the subframe of the vehicle. The vehicle was taken to the local dealer who determined that the vehicle was unsafe to drive due to the severe rusting of the subframe. The contact was informed that the subframe needed to be replaced. The vehicle was not yet repaired. The manufacturer was not yet notified of the failure. The failure mileage was 200,000.

The contact owns a 2002 Toyota Tundra. The contact stated that while driving at an undisclosed speed, the vehicle began to vibrate, prompting the contact to maintain low speeds. After a visual inspection, the contact observed that the front passenger wheels had a negative toe. No warning lights were illuminated. The vehicle was taken to the dealer, who determined that the lower ball joint had separated from the knuckle. The vehicle was not repaired. After investigating the failure, the contact related it to NHTSA Campaign Number: 05V225000 (Suspension), but the VIN was not included. The manufacturer was notified of the failure but provided no assistance. The failure mileage was 249,000.

Sudden maximum acceleration accompanied by brake failure, without warnings, occurred on my 2002 Toyota Tundra 4.7L V8 causing loss of control of the vehicle, which ended in a rollover crash, resulting in total loss of the vehicle and injury to me. While departing a 25 mph zone (sign read "END 25 SPEED LIMIT") on a relatively straight section of the road, I very gently accelerated from 20 mph to 30 mph. As soon as the vehicle reached 30 mph, sudden maximum acceleration occurred. Taking my foot off of the gas pedal, first I verified that the gas pedal was not stuck or blocked, but the gas pedal was in the fully up position. I then pressed the brake pedal very hard, but it was locked in the fully up position and the brakes would not engage. I then verified that nothing was blocking the brake pedal underneath it. At that point, around 3 to 4 seconds after the sudden acceleration began, I had entered the first turn of a 30 mph "S" turn at a high rate of speed, while acceleration continued at the vehicle's maximum acceleration rate beyond my control with the brakes not engaging. In order to avoid collision with a camper motor home and a small car following it, I went into the oncoming traffic lane at the second turn of the "S" turn. My truck fish tailed and struck a reflector marker on the left side of the road. To avoid going down a 50+ foot, nearly straight down drop on the left side of the road, I turned right. To avoid striking the motor home, I turned left, then right again to try to gain control. My truck rolled on its left side and landed upright on the right side of the road. It had been accelerating at its maximum acceleration rate with the brakes failing to engage and fish tailing the entire time. The problem appeared to be a catastrophic failure of the electronic throttle control and/or related electronic systems.

I purchased 4 new Michelin P245/70 R16 from Costco 12/5/2011with 31250 miles. I am a career auto mechanic for 39 years at an independent auto shop (retired, due to disability, 9/2011). I noticed sidewall cracking within about 2 years, but dismissed it because I have never heard/seen an air pressure loss due to sidewall cracking. The cracking worsened over the years, but the air pressure was even for all 4. Fast forward to 2020, I noticed my RF tire very low, looked for punctures, none found while submerged in water. November 2022 the RF tire was totally flat (parked). I found the sidewall had failed. This was a first for me in my experience. I certainly do not trust the remaining tires. I found a recall on the same brand/model but not my size. I have only 13350 miles on these tires. Tread is very good. I don't drive this truck often, but I maintain my vehicles well. Air pressure has been maintained at 40PSI, 4PSI under the max. pressure. In my opinion this is an obvious case of a defect in materials. I have not contacted Michelin yet.

My frame is to the point that it can not be repaired. It was coated by Toyota years ago as a safety recall but it is to the point now that my mechanic says it is to bad to repair. I have called Toyota and they say there have been frame issues that have been recalled but not with this year and model. only 135,000 miles on the truck

The contact owns a 2011 Dodge Durango. The contact stated that there was severe corrosion on the entire under carriage and subframe and struts. The contact received notification of NHTSA Campaign Number: 09V444000 (Structure) however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The failure mileage was unknown. Parts distribution disconnect.

The contact called on behalf of a friend who owns a 2002 Toyota Tundra. The contact stated in 2012 there was an unknown under coding and a plug was repaired on the vehicle. The driver experienced shaking and vibration from the rack and pinion steering while driving at approximately 35 MPH. The driver found power steering fluid leakage and there was a crack in the front passenger side of the engine frame. The contact was unaware of any failure warning lights. The contact stated the transmission functionality was great. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 200,000