2016 TOYOTA TUNDRA Complaints

The frame of the truck is extremely rusted. I am unsure if it can be fixed. It is available for inspection. This 2016 Tundra has 71,000 miles and is used as a third car. It has been serviced at the same dealership (Northshore Toyota, Covington, LA) and we were never informed of the damage by the dealership. My safety is at risk because the extensive rust could cause the frame to fail. Previous Tundra models have been recalled because of the same issues. No warnings were issued even after the dealership serviced the truck on a lift numerous times (approximately 9 years). The only previous warning by the dealership was on 1/29/2025 when the dealership informed us of a rusty trailer hitch. The truck was brought to 4 body shops in the local area after the owner went to work on the trailer hitch and saw the damage. All 4 shops confirmed that the rust was extensive. 3 shops would not fix the damage because it would be an expensive/extensive fix. We are waiting on what shop #4 says.

Problem Parts?? At around 70,000 miles I was told that there was an engine oil leak ... camshaft area... and the engine needs to pulled out with a repair cost of about $5,000 dollars. (Reseal both cam towers, replace gaskets, etc.) A bit ridiculous. Is there now a possible engine fire risk? At 70,000 miles there was obviously a manufacturing mistake or a defective part used during assembly.

Peeling paint. White paint is separating from primer on hood, and adjacent to windshield on a pillars and the leading edge if the roof.

1)Over 60 MPH with new tires the vehicle pulses & shakes on front end, checked alignment everything OK per Mechanic. Just started to occur 2)Bluetooth when on iPhone will at any time cut out guaranteed to occur when using at any time been occurring for 2 + years. 3)Trailer brake warning light (Idiot light) comes on dashboard does not recommend trailering due to electrical issue. occurring for 2+ years Bought vehicle used in 2017 with 13k on Truck now 2024 has 91K on truck love the truck but zero recalls for any of the above?

The contact owns a 2016 Toyota Tundra. The contact stated that while driving at an undisclosed speed, the vehicle ran off the road during a thunderstorm, causing the driver's and passenger's side curtain air bags to deploy. The vehicle was towed to the dealer, who informed the contact that the headliner needed to be replaced; however, the part to complete the repair was not available. The manufacturer was made aware of the failure and confirmed that parts were not yet available. The failure mileage was approximately 99,000.

Seat heater stopped working. Turns out there is a burnt connector leading to part number 87501-0C020, which appears to be a seat heater amp. One pin of the connector is completely melted. I've purchased this truck brand new from Toyota. Nobody has ever touched this part. Scared that it could have caught fire.

I was stopped at a turn light to merge left onto freeway and the truck steering went out when trying to turn, it led me into oncoming traffic that was just coming to a stop light, I was able to crank my wheel with all my strength to get to the side of the uphill freeway merge ramp. There were no warning signs. It was so scary and thank goodness I hadn't merged onto the freeway. The component that failed was the power steering assembly, rack and pinion with inner and outer tie rods. I don't believe the parts will be available for inspection since the truck was towed to repair shop. Overall, I was lucky to be alive. My safety was put at risk being unable to properly steer, if I had been going any faster, or even on the freeway there would be no way to control the vehicle. Initially, I was put into oncoming traffic that was coming to a stop. It put myself and everyone around me in danger. The problem has been confirmed by an independent repair shop that truck was towed to. They immediately saw the problem and took several days to fix. Even questioned what I was doing at the time of this event, because something like this just doesn't typically happen. It concerned them so much, that United Wheels and Tires suggested I reach out to Toyota. The vehicle has not been inspected by anyone but the dealer and the tow truck services. Insurance was notified of situation and services dispatched, since the truck was not drivable. There were NO warming lamps, messages or anything on truck. Truck is in perfect condition and drove only on roads (no off-roading or towing, etc.).

The integrated brake controller does not apply enough power to the trailer brakes.

Gas tank no longer fills completely in a single squeeze. Each squeeze of the pump only fills up maybe a .25 gallon at a squeeze if I am lucky, but typically less. This results in a complete fill up taking close to a half hour. There are numerous posts on forums such as https://www.tundras.com/threads/gas-filling-problem.38449/, https://www.tundras.com/threads/gas-tank-roll-over-valve-stuck-causes-hard-fuelling-anyone-else.42535/, and many others regarding this issue, with no response from dealers other than sorry. This sounds like a pure manufacturing issue if so many people have issues with their tanks, in a similar fashion.

Fuel gauge provides false inaccurate reading, resulting in stranded situation when fuel runs out. Toyota is aware is issue and has only issued a TSB for limited years when the problem is more wide spread. My daughter has been stranded several times.