CHEVROLET Recalls

Nov 01, 2004 – CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 124, 'ACCELERATOR CONTROL SYSTEMS.' IN HOT AMBIENT CONDITIONS, THE ACCELERATOR PEDAL ARM MAY STICK AT THE ATTACHMENT TO THE BRACKET AND NOT RETURN TO THE ENGINE IDLE POSITION WHEN THE OPERATOR LIFTS HIS FOOT FROM THE ACCELERATOR PEDAL.

Nov 01, 2004 – ON CERTAIN PASSENGER VEHICLES, THE REAR LAMPS THAT PROVIDE STOP AND TURN SIGNALS AND TAIL LAMP FUNCTIONS STOP WORKING BECAUSE OF INADEQUATE CONTACT BETWEEN THE BULB AND SOCKET. IN ADDITION, IF ONE BULBS WERE TO BECOME INOPERATIVE WHILE THE VEHICLE WAS OPERATING IN CRUISE CONTROL, THE CRUISE CONTROL WOULD DISENGAGE WHEN THE REMAINING BULB WAS ACTIVATED. IF BOTH LAMPS WERE TO BECOME INOPERATIVE, THE CRUISE CONTROL WOULD NOT ENGAGE.

Aug 17, 2004 – ON CERTAIN PASSENGER VEHICLES, THE REAR SAFETY BELT CAN BECOME TWISTED.

Aug 02, 2004 – ON CERTAIN SPORT UTILITY VEHICLES AND PICKUP TRUCKS EQUIPPED WITH 5.3L (RPO L59) V8 ENGINES, THE ENGINE FUEL RAIL CROSSOVER TUBE RETAINER SCREWS WERE NOT MANUFACTURED TO SPECIFICATIONS AND MAY BREAK.

Jul 06, 2004 – CERTAIN VANS WERE BUILT WITH A TRANSMISSION SHIFT CABLE ASSEMBLY THAT MAY SEPARATE. IF THE CABLE ASSEMBLY SEPARATES, THE TRANSMISSION SHIFT LEVER POSITION AND THE TRANSMISSION INDICATOR MAY NO LONGER CORRELATE.

Jun 30, 2004 – CERTAIN PASSENGER VEHICLES MAY HAVE BEEN BUILT WITH A FUEL TANK THAT DOES NOT MEET SPECIFICATION. A WELD ON THESE FUEL TANKS MAY BE INSUFFICIENT, RESULTING IN A FUEL LEAK.

Jun 30, 2004 – CERTAIN SPORT UTILITY VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 114, 'THEFT PROTECTION.' AN IGNITION KEY PARK LOCK CABLE END FITTING WAS NOT FULLY SEATED ON THE AUTOMATIC TRANSMISSION SHIFTER NAIL HEAD DURING INSTALLATION.

Jun 23, 2004 – CERTAIN PASSENGER VEHICLES WERE PRODUCED WITH LOWER THAN SPECIFIED TORQUE ON BOTH FRONT BRAKE CALIPER TO STEERING KNUCKLE ATTACHMENT BOLTS. WITH IMPROPER TORQUE, THE CLAMP LOAD AT THE JOINT MAY NOT BE ADEQUATE TO PREVENT MOVEMENT BETWEEN THE CALIPER BRACKET AND KNUCKLE.

Jun 23, 2004 – CERTAIN PASSENGER VEHICLES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, 'SEAT BELT ASSEMBLY ANCHORAGES.' THE PASSENGER-SIDE REAR SAFETY BELT MAY HAVE BEEN INSTALLED WITH AN INCORRECT NUT AND BOLT.

Jun 09, 2004 – ON CERTAIN PASSENGER VEHICLES INVOLVED IN THIS CAMPAIGN, THE LOWER CONTROL ARM BALL STUD NUT/WASHER ASSEMBLIES WITH WASHERS WERE MADE OF THE WRONG MATERIAL. THE WASHERS MAY FRACTURE AND BECOME LOOSE OR FALL AWAY FROM THE VEHICLE, REDUCING CLAMP LOAD. SEPARATION OF THE CONTROL ARM BALL STUD AND STEERING KNUCKLE, DUE TO DISENGAGEMENT OF THE TAPERED ATTACHMENT AND RETAINING NUT, IS POSSIBLE.