CHEVROLET Recalls

Feb 14, 2003 – ON CERTAIN VANS WITH A GROSS VEHICLE WEIGHT OF LESS THAN 8,500 POUNDS, DURING A VEHICLE CRASH SUFFICIENT ENOUGH TO DEPLOY THE SAFETY BELT PRETENSIONER, THE FRONT SAFETY BELT BUCKLES MAY NOT RELEASE AFTER THE VEHICLE CRASH, OR ALTERNATELY MAY EJECT THE SAFETY BELT LATCH DURING THE VEHICLE CRASH.

Feb 14, 2003 – ON CERTAIN MINI VANS, PASSENGER AND SPORT UTILITY VEHICLES, SOME OF THESE VEHICLES HAVE A DRIVER'S SIDE AIR BAG THAT MAY NOT DEPLOY AS DESIGNED. IN ADDITION, THE AIR BAG INFLATOR COULD RUPTURE.

Feb 06, 2003 – CERTAIN SPORT UTILITY VEHICLES FAIL TO COMPLY WITH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 214, "SIDE IMPACT PROTECTION." THESE VEHICLES ARE BUILT WITH FOUR WELDS ON THE REAR DOOR UPPER HINGE. ON SOME OF THESE VEHICLES, ONE OR TWO OF THE WELDS MAY NOT BE TO SPECIFICATION.

Jan 27, 2003 – ON CERTAIN PICKUP TRUCKS AND SPORT UTILITY VEHICLES, VEHICLES, DURING A 30 DEGREE LEFT ANGLE FRONTAL IMPACT OF SUFFICIENT SEVERITY, A TEAR COULD DEVELOP IN THE MID-FRAME CROSS MEMBER AT ITS ATTACHMENT TO THE LEFT FRAME RAIL. IF THE MID-FRAME CROSS MEMBER TEARS DURING FRONTAL IMPACT AND PRODUCES A SHARP EDGE, CONTACT OF THE SHARP EDGE WITH THE FUEL TANK COULD RESULT IN A PUNCTURE OF THE FUEL TANK AND POSSIBLE FUEL LEAKAGE.

Jan 23, 2003 – CERTAIN PICKUP TRUCKS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 212, "WINDSHIELD MOUNTING." SOME OF THESE VEHICLES LACK A CONTINUOUS URETHANE BONDING BEAD BETWEEN THE BODY SURFACE AND THE WINDSHIELD.

Dec 12, 2002 – ON CERTAIN VANS WITH AN 8,500 LB. OR 8,600 LB. GROSS VEHICLE WEIGHT RATING, THE NUT ATTACHING THE PITMAN ARM TO THE STEERING LINKAGE MAY NOT BE TIGHTENED ADEQUATELY RESULTING IN A POSSIBLE SEPARATION.

Dec 09, 2002 – ON CERTAIN PASSENGER, SPORT UTILITY VEHICLES AND MINI VANS, SOME OF THESE VEHICLES HAVE A PASSENGER AIR BAG THAT WAS MANUFACTURED WITHOUT A CHECK VALVE PIN. AN AIR BAG WITHOUT THE CHECK VALVE PIN COULD PRODUCE INCREASED PRESSURE AT THE ONSET OF THE AIR BAG DEPLOYMENT AND REDUCED PRESSURE AFTERWARD.

Dec 02, 2002 – ON CERTAIN VANS, THE RIGHT-HAND TIE ROD END NUT MAY NOT BE TIGHTENED ADEQUATELY. THE NUT CAN LOOSEN RESULTING IN SEPARATION OF THE TIE ROD FROM THE STEERING KNUCKLE.

Nov 14, 2002 – CERTAIN VANS WERE BUILT WITHOUT A WHEEL BEARING ASSEMBLY RETAINING NUT, WHICH COULD LEAD TO A POSSIBLE BEARING SEPARATION.

Nov 04, 2002 – CERTAIN PASSENGER VEHICLES AND MINI VANS HAVE LOWER PINION BEARINGS IN THE POWER RACK AND PINION ASSEMBLY IN WHICH THE RETAINER TABS WERE NOT CRIMPED PROPERLY. THESE AND SOME OTHER RETAINERS USED IN VEHICLES ASSEMBLED BETWEEN JANUARY 1, 1996 AND OCTOBER 31, 1997, COULD FAIL AND PERMIT THE BALL BEARINGS TO ESCAPE.