CHEVROLET Recalls

Jul 15, 2003 – CERTAIN MINIVANS, PASSENGER AND SPORT UTILITY VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 225, "CHILD RESTRAINT ANCHORAGE SYSTEM." THE OWNER'S MANUAL DOES NOT EXPLAIN THE MEANING OF THE LOCATION SYMBOLS FOR THE CHILD RESTRAINT LOWER UNIVERSAL ANCHORAGE SYSTEM.

Jun 10, 2003 – CERTAIN VANS HAVE A CONDITION IN WHICH WATER MAY ENTER AND CORRODE THE REAR LICENSE PLATE LAMP SOCKET. IF THE LAMP SOCKET WERE TO CORRODE, THE REAR LICENSE PLATE LAMP MAY OPERATE INTERMITTENTLY OR NOT AT ALL, AND THE LEFT REAR TAIL LAMP MAY BECOME INOPERATIVE. THE TEMPERATURE OF THE LICENSE PLATE LAMP SOCKET COULD INCREASE TO THE POINT THAT IT MAY BEGIN TO SOFTEN AND MELT.

May 12, 2003 – REMANUFACTURERD REAR BRAKE CALIPERS, PART NOS. 18-7019, 18-7020, 16-7019, AND 16-7020, MANUFACTURED FROM FEBRUARY 1, 2002, TO APRIL, 25, 2003., AND FOR USE ON 1965 THRU 1982 CHEVROLET CORVETTES. THE SUBJECT BRAKE CALIPERS WERE MANUFACTURED USING IMPROPERLY MANUFACTURED PISTON SEALS. THESE SEALS ARE INTENDED TO PREVENT FLUID LEAKAGE BETWEEN THE CALIPER HOUSING AND THE PISTONS. THESE BRAKE CALIPERS ARE FOR USE ONLY ON 1965 THRU 1982 CHEVROLET CORVETTE VEHICLES. THIS RECALL DOES NOT INVOLVE GENERAL MOTORS CORPORATION OR ANY OF ITS PRODUCTS.

Apr 28, 2003 – ON CERTAIN MINIVANS, PICKUP TRUCKS, AND SPORT UTILITY VEHICLES WITH CERTAIN MODEL-ENGINE COMBINATIONS, THE WINDSHIELD WIPER MOTOR MAY FAIL DUE TO CRACKED SOLDER JOINTS ON THE CONTROLLER CIRCUIT BOARD. THE WINDSHIELD WIPERS COULD WORK INTERMITTENTLY OR NOT AT ALL.

Apr 23, 2003 – CERTAIN SPORT UTILITY VEHICLES WERE BUILT WITH A LEFT-FRONT BRAKE PIPE WITH A CIRCUMFERENTIAL SCORE AT A RANDOM LOCATION ALONG THE LENGTH OF THE PIPE AS THE RESULT OF THE MANUFACTURING PROCESS. IF THE BRAKE PIPE PARTIALLY OR FULLY FRACTURED, BRAKE PEDAL TRAVEL WOULD IMMEDIATELY INCREASE AND FRONT BRAKE PERFORMANCE WOULD BE REDUCED.

Mar 31, 2003 – CERTAIN SPORT UTILITY VEHICLES WERE BUILT WITH A DRIVER'S SEAT BELT BUCKLE ASSEMBLY THAT CONTAINS AN ENERGY-ABSORBING LOOP. SUSTAINED LOADS OF SUFFICIENT MAGNITUDE AND DURATION ON THE BELT IN SEVERE CRASHES COULD FULLY DEPLOY THE BUCKLE ENERGY-ABSORBING LOOP, INTRODUCING A TOTAL OF 10 ADDITIONAL INCHES OF WEBBING INTO THE SEAT BELT SYSTEM. THE FREE FALLING LATCH PLATE USED IN THIS SYSTEM MAY ALLOW WEBBING TO DYNAMICALLY DISTRIBUTE BETWEEN THE LAP AND SHOULDER BELT AS THE DRIVER'S POSITION CHANGES DURING A MULTIPLE ROLLOVER EVENT.

Mar 19, 2003 – CERTAIN SPORT UTILITY VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARDS NO. 101, "CONTROL LOCATION, IDENTIFICATION, AND ILLUMINATION" AND NO. 208, "OCCUPANT CRASH PROTECTION." THESE VEHICLES HAVE AN INTERMITTENT CONDITION DURING VEHICLE START-UP IN WHICH THE INSTRUMENT PANEL CLUSTER MAY NOT PROPERLY POWER UP, RESULTING IN MOST OF THE DISPLAYS, TELLTALE LIGHTS, AND FUNCTIONS (EXCEPT THE SERVICE ENGINE LIGHT, TURN SIGNAL INDICATORS, AND THE INSTRUMENT PANEL CLUSTER BACKLIGHTING) BEING INOPERATIVE.

Mar 07, 2003 – CERTAIN SPORT UTILITY VEHICLES, MINI VANS, AND PICKUP TRUCKS MAY DEVELOP A SHORT CIRCUIT IN THE ELECTRIC OUTSIDE REARVIEW MIRROR SWITCH.

Mar 07, 2003 – CERTAIN PICKUP TRUCK, VAN, AND MINI VAN CONVERSIONS EQUIPPED WITH SOUTHERN COMFORT BUILT RUNNING BOARDS THAT CONTAIN CERTAIN COURTESY LIGHTS MANUFACTURED BY AMERICAN TECHNOLOGY COMPONENTS, INC. THESE UNITS CONTAIN A COURTESY LIGHT OR LIGHTS THAT MIGHT OVERHEAT WHEN THE WIRE HARNESS IS EXPOSED TO EXCESSIVE MOISTURE AND ROAD SALT.

Mar 06, 2003 – CERTAIN SPORT UTILITY VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 114, "THEFT PROTECTION." THESE VEHICLES ARE EQUIPPED WITH A MECHANICAL OVERRIDE THAT COULD ALLOW THE IGNITION KEY TO BE REMOVED WITH THE SHIFT LEVER IN A POSITION OTHER THAN PARK. IN ADDITION, THESE VEHICLES HAVE AN OVERRIDE THAT CAN ALLOW THE TRANSMISSION TO BE SHIFTED OUT OF PARK WITH THE IGNITION IN THE OFF POSITION.