FORD E-150 Recalls

Jun 21, 2013 – Mobility Works is recalling certain model year 2006-2012 Ford E-150, E-250 and E-350 vehicles manufactured August 2006 through August 2012. The vehicles are equipped with certain Ricon S series and K Series wheelchair lifts with an optional armored pendant cable. The armored cable may be positioned such that it does not clear the wheelchair lift.

Nov 08, 2011 – FORD IS RECALLING CERTAIN REPLACEMENT FUEL TANKS THAT COULD BE INSTALLED INTO MODEL YEAR 2004 THROUGH 2008 E-150, E-250, AND E-350 VANS AND WAGONS. THE AFFECTED FUEL TANKS HAVE AN EXTRA OBDII SENSOR HOLE ON THE TOP OF THE TANK THAT MAY NOT BE PROPERLY SEALED AND MAY LEAK FUEL.

Aug 31, 2011 – ROUSH IS RECALLING CERTAIN AFTERMARKET ROUSH CLEAN TECH LIQUID PROPANE AUTOGAS FUEL SYSTEM KITS USED FOR INSTALLATION ON THE FOLLOWING VEHICLES: MODEL YEAR 2007 AND 2008 FORD E-350 (DUEL REAR WHEEL), MY 2009-2011 FORD E- 150, E-250, AND E-350, AND MY 2009-2011 FORD E-450 CUTAWAYS. THE FUEL RAILS INCLUDED IN THE KITS CONTAIN IMPROPERLY SEATED INJECTOR RETENTION CLIPS. THIS COULD RESULT IN LEAKAGE OF PROPANE AUTOGAS. THE PART NUMBERS OF THE AFFECTED KITS ARE: P07C2-176KIT-AB, P10C2-RCOMMKIT-AB, P10C2-R150KIT-AA, P10C2-R150KIT-AC, P10C2-R350KIT-AC, P11C2-R150KIT-AA, P11C2-R150KIT-AB, P11C2-R350KIT-AA, P11C2-R350KIT-AB, P10-SO-RKIT-BA, PBC2-RKIT158-AB, PBC2-RKIT176-AB, AND PBC2-RKITMB-AC.

Aug 31, 2011 – ROUSH IS RECALLING CERTAIN MODEL YEAR 2009-2011 FORD E-150, E-250, AND E-350 5.4L ENGIN VANS/WAGONS/CUTAWAYS, AND MODEL YEAR 2010-2011 FORD E-450 6.8L ENGINE CUTAWAY VEHICLES ALTERED BY ROUCH TO OPERATE USING THE ROUSH BRANDED CLEANTECH PROPANE AUTOGAS FUEL SYSTEM. THE FUEL RAILS INCLUDED IN THE KITS CONTAIN IMPROPERLY SEATED INJECTOR RETENTION CLIPS. THIS COULD RESULT IN LEAKAGE OF PROPANE AUTOGAS.

Aug 26, 2011 – Ford Motor Company (Ford) is recalling certain model year 2011 Ford E-150, E-250, E-350, and E-450 vehicles built from May 12, 2011, through May 26, 2011. Due to improper manufacturing conditions, some of the windshields may form bubbles after an extended time in hot temperatures. As such, these vehicles fail to conform to the requirements of Federal Motor Vehicle Safety Standard No. 205, "Glazing Materials."

May 31, 2011 – ROUSH PERFORMANCE PRODUCTS IS RECALLING CERTAIN 2011 FORD E-SERIES VANS EQUIPPED WITH 5.4 OR 6.8 LITER ENGINES THAT HAVE BEEN ALTERED BY ROUSH TO OPERATE USING THE ROUSH LIQUID PROPANE AUTOGAS FUEL SYSTEM. A VALVE IN THE SYSTEM MAY HAVE BEEN MISMACHINED ALLOWING A PROPANE LEAK.

May 31, 2011 – ROUSH IS RECALLING CERTAIN AFTERMARKET ROUSH CLEAN TECH LIQUID PROPANE AUTOGAS FUEL SYSTEM KITS PRODUCED BETWEEN DECEMBER 17, 2010, AND MAY 6, 2011, USED FOR INSTALLATION ON FLEET VEHICLES MODEL YEAR 2009 THROUGH 2011 FORD E-SERIES VANS/WAGONS/SHUTTLES/CUTAWAY (150, 250 AND 350) WITH 5.4L ENGINES ("E-SERIES"), AND MY 2011 FORD E-450 CUTAWAYS. THE VALVES INSTALLED IN THE SERVICE PORT OF THE FUEL RAILS OF THE KIT WERE UNDER MINIMUM SPECIFICATION FOR THE DIAMETER. THIS LED TO INSUFFICIENT COMPRESSION OF THE O-RING, ALLOWING LEAKAGE OF PROPANE AUTOGAS. THE PART NUMBERS OF THE AFFECTED KITS ARE: P10C2-R150KIT-AA, P10C2-R150KIT-AC, P10C2-R350KIT-AC, P11C2-R150KIT-AA, P11C2-R150KIT-AB, P11C2-R350KIT-AA, P11C2-R350KIT-AB, P-10-SO-RKIT-BA, PBC2-RKIT158-AB, PBC2-RKIT176-AB, AND PBC2-RKITMB-AC.

Apr 20, 2011 – FORD IS RECALLING CERTAIN MODEL YEAR 2011 E-150, E-250, E-350 AND E-450 TRUCKS FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, "SEATING SYSTEMS." IT MAY BE POSSIBLE THAT UNDER UNUSUALLY HIGH LOADS, SUCH AS DURING A CRASH, THE DRIVER POWER SEAT TRACK WORM GEAR MAY FRACTURE.

Jun 17, 2010 – ACCESS OPTIONS IS RECALLING CERTAIN TRUCKS AND VANS BUILT ON FORD E150, E350, TOYOTA SIENNA, AND DODGE GRAND CARAVAN CHASSIS AND EQUIPPED WITH VMI/RICON 6-WAY POWER SEAT BASES. THE SIX WAY POWER SEAT BASE MAY HAVE A DEFECTIVE (COLD) WELD ON THE PIVOT PIN WHICH IS WELDED TO THE SWIVEL PLATE. THE WELD COULD FAIL.

Jun 15, 2010 – ALL IN ONE MOBILITY IS RECALLING CERTAIN MODEL YEAR 1997 THROUGH 2008 CONVERSION VANS EQUIPPED WITH VMI/RICON 6-WAY POWER SEAT BASES. THERE IS A POSSIBILITY OF A DEFECTIVE WELD AT THE JOINT BETWEEN THE PIVOTING PLATE AND THE PIVOTING PLATE PIN.