ISUZU Recalls

Jun 05, 2003 – CERTAIN SPORT UTILITY VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 114, "THEFT PROTECTION." THESE VEHICLES ARE EQUIPPED WITH A MECHANICAL OVERRIDE THAT COULD ALLOW THE IGNITION KEY TO BE REMOVED WITH THE SHIFT LEVER IN A POSITION OTHER THAN PARK. IN ADDITION, THESE VEHICLES HAVE AN OVERRIDE THAT CAN ALLOW THE TRANSMISSION TO BE SHIFTED OUT OF PARK WITH THE IGNITION IN THE OFF POSITION.

Jun 02, 2003 – ON CERTAIN PICKUP TRUCKS WITH CERTAIN MODEL-ENGINE COMBINATIONS, THE WINDSHIELD WIPER MOTOR MAY FAIL DUE TO CRACKED SOLDER JOINTS ON THE CONTROLLER CIRCUIT BOARD. THE WINDSHIELD WIPERS COULD WORK INTERMITTENTLY OR NOT AT ALL.

Mar 24, 2003 – AS A RESULT OF INFORMATION OBTAINED FROM A HEAD IMPACT TEST CONDUCTED BY THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION (NHTSA) TO EVALUATE COMPLIANCE WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 201, "OCCUPANT PROTECTION IN INTERIOR IMPACT," ISUZU HAS DESIGNED A MODIFICATION FOR CERTAIN 2002 MODEL YEAR ISUZU AXIOM VEHICLES. THE PURPOSE OF THIS MODIFICATION IS TO ENHANCE HEAD IMPACT CRASH PROTECTION FOR FRONT SEAT OCCUPANTS.

Oct 15, 2002 – ON CERTAIN SPORT UTILITY VEHICLES AND PICKUP TRUCKS, THE LATCH PLATE USED IN THE SEAT BELT BUCKLE WAS NOT MANUFACTURED ACCORDING TO DESIGN DIMENSIONS. IF THE SEAT BELT TONGUE IS INSERTED SLOWLY AT AN ANGLE INTO THE BUCKLE, THERE IS A POSSIBILITY OF PARTIAL ENGAGEMENT.

Aug 09, 2002 – ON CERTAIN SPORT UTILITY VEHICLES, THE PASSENGER-SIDE AIR BAG INFLATOR MODULES WERE MANUFACTURED AND SHIPPED WITHOUT A NECESSARY COMPONENT KNOWN AS A CHECK VALVE PIN.

Jun 03, 2002 – ON CERTAIN SPORT UTILITY VEHICLES THAT ARE EQUIPPED WITH AN ANTI-LOCK BRAKING SYSTEM (ABS), THE VEHICLES CAN EXPERIENCE EXTENDED STOPPING DISTANCES IN CERTAIN TYPES OF BRAKING EVENTS.

May 16, 2002 – ON CERTAIN SEDANS, COUPES, HATCHBACKS, AND SPORT UTILITY VEHICLES, ELECTRICAL CONTACTS IN THE IGNITION SWITCH CAN DEGRADE DUE TO THE HIGH ELECTRICAL CURRENT PASSING THROUGH THE SWITCH WHEN THE VEHICLE IS STARTED.

Feb 12, 2002 – CERTAIN MEDIUM DUTY TILT CAB TRUCKS EQUIPPED WITH MANUAL TRANSMISSIONS HAVE A CONDITION IN WHICH THE CLUTCH MASTER-CYLINDER PUSHROD END THAT ATTACHES TO THE CLUTCH PEDAL PIN CAN WEAR PREMATURELY. THE FIRST NOTICEABLE EFFECT OF THIS WEAR COULD BE THE CLUTCH PEDAL NOT RETURNING COMPLETELY TO THE FULL-UP POSITION.

Jun 15, 2001 – VEHICLE DESCRIPTION: COMMERCIAL VEHICLES EQUIPPED WITH AXLE ASSEMBLIES WHICH MAY HAVE BEEN MANUFACTURED WITH TRW MODEL 20EDL BALL SOCKETS/DRAG LINKS. THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW SPECIFICATION CASE DEPTH AND/OR HARDNESS WHICH CAN LEAD TO PREMATURE WEAR OUT OF THE SOCKET IN SOME APPLICATIONS.

Jun 15, 2001 – VEHICLE DESCRIPTION: COMMERCIAL VEHICLES EQUIPPED WITH TIE ROD ASSEMBLIES CONTAINING 24-DL MODEL BALL SOCKETS AND MANUFACTURED BY TRW. CERTAIN OF THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW-SPECIFICATION CASE DEPTH AND/OR HARDNESS, WHICH CAN LEAD TO PREMATURE WEAR OF THE SOCKET.