2011 BMW X3 Complaints

The contact owns a 2011 BMW X3. The contact stated that upon starting the vehicle, the check engine warning light illuminated. The vehicle was taken to an independent mechanic, who informed the contact that the failure was due to the PCV. The local dealer was not contacted, but the vehicle was not diagnosed or repaired. The manufacturer was contacted, but no assistance was provided. The contact stated that the failure was related to NHTSA Campaign Number: 17V683000 (Engine and Engine Cooling). The approximate failure mileage was 100,000.

The contact owns a 2011 BMW X3. The contact stated that the vehicle was experiencing electrical failures. The contact stated that the door lock pins failed to go up or down while using the key fob. The vehicle was taken to the dealer, where it was diagnosed that the door lock actuator had failed. The vehicle was repaired; however, the failure recurred two weeks later. Additionally, the turn signals and the windshield wipers were inoperable while driving. The vehicle was taken back to the dealer, who informed the contact that the battery needed to be replaced; however, the contact declined the battery replacement because the battery was 5-month-old. AAA inspected the vehicle at the residence and informed the contact that the battery was in good condition. The vehicle was taken to an independent mechanic, who made the same assessment and diagnosed that the failure was related to the footwell module. The vehicle was not repaired. The contact related the failure to an unknown warranty extension program. The manufacturer was not notified of the failure. The failure mileage was approximately 57,486.

Went to have hesitation when accelerating checked with my mechanic. This problem called for ignition coil and spark plugs to be replaced. During final test drive -- check engine light illuminated. Vehicle was scanned for stored fault codes. During this scan it was found faults for intake vanos not controllable. Inspected camshaft gears via bore-scope. Found vanos securing bolts to be broken. This was a recall issue on this particular model except for the engine that is in my vehicle. Feel as though this issue should be addressed for all vehicles that are this model. The recall was faults stored in DME, Vanos and camshaft position. I realize that BMW is not responsible for my particular vehicle but feel that someone should be looking at why ONLY this specific engine was not included?? I did have my mechanic fix the issue which incurred an expense of $2499. If this problem could be looked into further, I would appreciate your help. (I do have invoice from mechanic, but I don't know how to upload file.

The contact owns a 2011 BMW X3. The contact stated that the check engine warning light was illuminated on the instrument panel. The contact initially took the vehicle to an independent mechanic and was informed that there was an unknown sensor fault with the vehicle. The contact then took the vehicle to another independent mechanic who informed him that the camshaft bolts were loosened, and the contact was instructed to no longer drive the vehicle. The mechanic informed the contact of NHTSA Campaign Number: 14V176000 (Engine and Engine Cooling) which he linked to the failure. The vehicle was then towed to a dealer and the contact was informed that the vehicle was not under recall. The vehicle was towed back and remained at the residence. The manufacturer was notified of the failure. The vehicle was not repaired. The failure mileage was approximately 149,000.

The bolts backed out of my camshaft (VANOS) adjustment units. The related "warranty (not a recall)" information is found here: https://static.nhtsa.gov/odi/tsbs/2018/MC-10135011-9999.pdf. I purchased a 2011 X3 28i last May (2022) with ~110k miles, and there was no open recall information attached to the vehicle. Inspecting prior service records the VANOS bolts were never replaced. After a few thousand miles the bolts backed out and sheared. BMW NA said it was out of warranty and would not be covered. There was no information found when searching the VIN for necessary repairs. I've seen 10+ reports in online forums in the past two years explaining they needed or got the repair and BMW NA told them it would not be covered. I don't understand how I was to know, or even the past owner (2nd owner, I'm the third), that this engine part failure would or could occur. If the "warranty (not a recall)" was recalled on other models it seems nefarious that a warning wouldn't be attached to the vehicles. The vehicle was inspected and passed, and then inspected by a indie BMW technician who used to work for BMW as well. The vehicle had repairs done, but even he did not suspect any engine issues. This issue is a matter of when and not if with the vehicles within the "warranty" time span. My request would be that BMW reopen the warranty or rightfully claim it a recall as it should have been in the beginning. I would appreciate any guidance on the matter. Thank you.

I parked my vehicle in front of my house for the night after driving for only about 15-20 minutes. Maybe less. Roughly 3-4 hours later, I was alerted to my car being completely up in flames by the sounds of fire trucks / police sirens. Flames were 20-30 feet in the air coming from the engine compartment area. Fire department / police worked to extinguish the flames, but the vehicle is totally destroyed.

The contact owns a 2011 BMW X3. The contact stated while driving 40 MPH, the "Steering Response Affected!" and "Chassis Stabilization" messages displayed and the steering wheel seized. The contact used physical strength to steer the vehicle and veered to the side road. The contact stated upon turning off and restarting the vehicle, the warning messages disappeared. The vehicle was towed to the dealer, who informed the contact that they could not duplicate the failure. However, the failure reoccurred while driving. The vehicle was taken back to the dealer who informed the contact that they could not duplicate the failure. The vehicle was not repaired. The contact referenced NHTSA Campaign Number: 11V341000 (Steering). The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline. The failure mileage was approximately 106,000.

The contact owns a 2011 BMW X3. The contact stated that while driving at an undisclosed speed, the vehicle experienced a loss of power steering assist. The vehicle was taken to an independent mechanic who related the failure to NHTSA Campaign Number: 11V341000 (Steering) however, the VIN was not included in the recall. The vehicle was not repaired. The manufacturer was made aware of the failure and informed the contact that there was no recall associated with the VIN. The failure mileage was approximately 135,000.

The passenger side weight sensor that indicates whether it is safe for the airbag to fire is failing, giving a repeat error. It has put individuals sitting in the passenger side in potential harm's way if we were to get in an accident. It is available for inspection upon request. The problem has been reproduced by the dealer. They want an exorbitant amount of money to fix it. Prior models had the same defect, and were subject of recalls/repairs/warranty extensions. Not so for this model-year. The dashboard warning lamp indicating that the passenger airbag sensor is defective has lit intermittently.

The contact owns a 2011 BMW X3. The contact stated while driving approximately 30 MPH, the vehicle stalled without warning. The contact pulled over but was unable to restart the vehicle. The contact stated no warning light was illuminated. The vehicle was not taken to be diagnosed or repaired and was towed to the residence. Upon investigation, the contact associated the failure with NHTSA Campaign Number: 14V176000 (Engine and Engine Cooling) however, the VIN was not included. The manufacturer was informed of failure and confirmed that the VIN was not included in the recall. The failure mileage was approximately 146,590.