2020 CHEVROLET BLAZER Complaints

| Issues first appeared recorded on 3/9/2026, while odometer read 49,663 miles. Check engine light was caused by error codes P0128 and P01F0. This causes the following issues: * Check engine light to appear on the dashboard. * Engine temperature gauges to be unreliable at times or completely non functional at others, as it will constantly read the engine temperature "Cold". * Air conditioning unit to become unreliable at times or completely non functional at others, and only blow hot air. * Radiator fan will be stuck running at max speed despite current engine temperature. * A "Reduced Steering Assist" message will periodically appear on the dashboard. * A "Service ESC" message will periodically appear on the dashboard. * Remote start will becomes non functional. | Car was taken to a license Chevrolet dealership and had full thermostat housing and thermostat sensors replaced. Dealership confirmed all replaced parts are working correctly and as intended. After picking up the vehicle from the dealership, and driving car for roughly 30 miles, the check engine light appeared on the dashboard again causing all previous issues to return. | Several other Chevy Blazer 2020 owners have complained of the same issue online, and in forums such as: [XXX] . | INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Just took my car to the Chevy dealership today and had them go over the car because I keep getting the message steering assist has been reduced and the fan is constantly running at the highest speed and it also makes it where I can not use the a/c or heat in the car! I don’t know the code off hand but it has something to do with the cam shaft and the thermostat for the antifreeze! From what Chevy told me today it is a $9000 job to tear down the left side of the engine because the camshaft carrier gasket is leaking oil! Which is probably why that code is popping up. Or from what I was told today it could be from the battery which I believe they were trying to shift blame. Either way this camshaft stuff really needs to be investigated!!

Vehicle has shift to park light and will not turn off even with the shifter in the park position.

P0128 code for thermostat issue. Fans run after shutting car off. Steering assist reduced message. Check engine light. Chevy knows this is a common issue. This needs to be investigated asap.

The contact owns a 2020 Chevrolet Blazer. The contact stated that while driving at an undisclosed speed, the check engine warning light illuminated. The vehicle was taken to an independent mechanic, where it was diagnosed with VVT sensor failure. The sensors were replaced; however, the failure recurred. The vehicle was taken back to the mechanic, where a solenoid was replaced. The vehicle was repaired. The contact was informed that if the failure recurred, there might be an internal engine failure. The dealer was not contacted. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline to report the failure. The failure mileage was approximately 70,000.

Driving down the road at 50 mpg when to car just shut off had a hard time getting it off the road and did still was all the way we almost got hit three times

Engine showing PO128 code. Steering Assist System reduced power. Engine fan constantly running. Engine temp on dash is stuck on the "C" mark, doesn't move. Thermostat and temp sensor replaced, issue continues. THIS IS A VERY COMMON PROBLEM ON GM VEHICLES WITH THE 3.6L AROUND THE 60,000 MILE MARK. GM NEEDS TO GET IT FIGURED OUT.

I received a check engine light which i took to Bell tire for diagnosis. Here is there diagnosis Comments: The P01F0 code on a 2020 Chevy Blazer means the engine coolant temperature is below the normal operating range, often due to a stuck-open thermostat (or both thermostats in models with dual units), a faulty Engine Coolant Temperature (ECT) sensor, or low coolant, leading to poor fuel economy and potential wear; fixing it usually involves replacing the thermostat(s) or sensor after checking coolant levels and wiring. After that i took the vehicle to GM Dealership. Even though this is a know issue with many vehicles from same year, i was told that my VIN is not part of recall and dealership ended up charging me 600+ to fix the issue. I am reaching out to seek help as i had exact same problem but GM is not covering the repairs because my VIN is not in the recall. How is that possible?

"I was in extreme danger while traveling with my [XXX] child in the vehicle on the day prior to the total failure. During that trip, the transmission began to slip significantly in active traffic, creating a terrifying loss of motive power and a high risk of a rear-end collision. Because of this dangerous incident, I attempted to reach the dealership the following morning to prevent a crash. Upon arrival, the transmission suffered a total catastrophic failure in the dealership lot. Had this final failure occurred just 24 hours earlier while my child was in the vehicle on the highway, the situation could have been fatal. The vehicle is currently inoperable due to the 'check ball' metallurgical defect (RO #XXX). INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The driver information center suddenly indicated steering assist disabled, temperature gauge drops to below cold, air conditioning blows warm air. This issue has happened several times and is able to be reset by disconnecting/reconnecting the battery or using a scan tool. Temperature sensor is not the cause in my opinion, and I have read that the harness for the temperature sensor also includes the coil wires, which can lead to electrical/rf interference, triggering this issue. I have read about many owners having this same issue, even after temperature sensor and thermostat replacement, at low mileages. This should be recalled and handled by GM, whatever the cause.