2023 CHEVROLET COLORADO Complaints

Intermittent break failure service dealer could not duplicate contacted GMC they say call back if it happens again.

Vehicle accelerated on its own at a stop and then at highway speeds. Took it to dealership who experienced the same thing and confirmed the issue and could not find the reason why.

Roof dents when going through car wash and blowers will dent the roof. GM has a service bulletin on this lbulletin number 23-NA-209 DATED March 24. Bulletin says that all Colorados built before Feb 3rd 2025 should be repaired and gives a part list and how to fix it 9 pages long. BUT GM says my vin number is not showing a recall and will not fix it My Colorado HAS NO DAMAGE BECAUSE I HAVENT PUT IT THROUTH A CAR WASH TRYING TO GET THEM TO FIX WITHOUT PUTTING A DENT IN IT. THE FIX IS PUTTING SUPPORTS IN THE ROOF TO REINFORCE IT.

The right turn signal will click for a left turn after completing its right turn without physically pressing the turn signal. Has happened since buying vehicle, continues to happen now. Turn signal was replaced by dealership, problem not resolved. Have reconfirmed problem with dealership service manager as well as video evidence of issue. Issue happens at all speeds, idle to freeway speeds.

What component or system failed or malfunctioned, and is it available for inspection upon request? To my knowledge, which is limited on vehicle diagnosis, the engine valve body is having an issue finding a gear when starting from a stop. How was your safety or the safety of others put at risk? The vehicle engine will sputter and jolt forward and attempt to go to a higher or lower gear when approaching the stop . Has the problem been reproduced or confirmed by a dealer or independent service center?The problem is reproducible, but the dealership is stating i would need a check engine light to have it serviced or seen. Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others? No. Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear? No visible alerts of fault when issue occurs or thereafter.

The right front brake caliper failed with 15747 miles. Local dealer made repairs and said the caliper was not the cause. Their cause was blaming a brake controller used in towing the vehicle. If the controller had caused the failure more than one wheel would of been effected. The three remaining wheels all showed fine and had over 7mm of brake lining remaining. The wheel effected had ZERO pad remaining. I have replaced parts in my possession for evidence.

The contact owns a 2023 Chevrolet Colorado. The contact stated that several sensors were activated with contact being alerted to an issue with the Lane Keep Assist, and the vehicle veering out of the intended lane. The contact stated that while driving 45 MPH, the Forward Collision Avoidance: Automatic Emergency Braking activated unintendedly. The contact stated that the failure was self-corrected. The dealer was contacted, and an appointment was scheduled. The contact inquired of the the dealer if the VIN was included in NHTSA Campaign Number: 24V133000 (Electrical System, Forward Collision Avoidance). The dealer informed the contact that the VIN was not included. The manufacturer was not informed of the failure. The failure mileage was approximately 15,000.

The contact owns a 2023 Chevrolet Colorado. The contact stated that while driving, the vehicle decelerated from 70 MPH to 30 MPH. During the failure the check engine and traction control warning lights were illuminated. The vehicle was towed to the local dealer who diagnosed an engine cylinder misfire. No further information was available. The contact stated that the vehicle was serviced by the dealer on several occasions for the failure however, the failure persisted. The contact stated that the vehicle was unsafe to drive. The manufacturer was notified of the failure. The failure mileage was 3,000.

The contact owns a 2023 Chevrolet Colorado. The contact had taken the vehicle to the dealer for a routine oil change and after the vehicle was serviced, the contact was provided a multi-point vehicle inspection sheet which showed that the brake pads had received a green check mark and that the brake pads were 7-millimeters or greater on both the driver’s and passenger’s side. The next day upon start of the vehicle, the contact stated that a message "New Brake Pads Detected" question was displayed on the instrument panel. The contact selected the "No" option followed by another question to service the brake pads. The contact then stated that a "Service Brake Pad Monitoring System" message appeared on the instrument panel. The vehicle was taken back to the dealer where the dealer was informed of the messages. A mechanic inspected the vehicle and informed the contact that both the brake pads and rotors needed to be replaced. The contact was also informed that the brake pads were 2 millimeters or less, despite the contact receiving information the day prior which stated otherwise. The contact questioned the dealer about the discrepancy and was informed that the computer provided the results for the multi-point vehicle inspection. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 27,000.

Vehicle shaking very badly when braking. Then “Service Brake Monitor” message displays. Took it to a Chevy dealership who said my rotors were warped. Turns out many people are complaining about it on Reddit. I purchased vehicle with less than 20k miles on it and it was a Chevy certified used vehicle. I don’t feel safe driving it and Chevy will not foot the bill. This could potentially be dangerous for other drivers and my guess is the parts are defective or something other than “driving conditions” are at play. This should not be happening!