2004 CHEVROLET IMPALA Complaints

2004 CHEVROLET IMPALA, INSTRUMENT CLUSTER GAUGE MALFUNCTION, BEGINNING WITH TEMPERATURE GAUGE SHOWING INCORRECT TEMPERATURE (COLD START - TEMP READOUT 160 F), SUBSEQUENTLY SHOWING TRACTION SYSTEM FAILURE INDICATOR, FINALLY PROGRESSED TO SPEEDOMETER FAILURE AT HIGHWAY SPEED APPROXIMATELY ONE WEEK LATER - SPEEDOMETER BEGAN SHOWING RANDOM SPEEDS AT APPROXIMATELY-STEADY CRUISE, READING 42 MPH AT ABOUT 70 MPH. INTERNET RESEARCH DEMONSTRATES MULTIPLE SUCH INSTANCES. CHEVROLET HAS ADDRESSED IDENTICAL PROBLEM IN SILVERADO AND AVALANCHE MODELS, BUT REFUSES TO ACKNOWLEDGE THAT A PROBLEM EXISTS IN THE IMPALA. *TR

2004 IMPALA ODOMETER MALFUNCTION IN WINTER COLD WHETHER CONDITION MOST OF THE TIME.

HEAD LIGHTS WENT OUT COMPLETELY ON CAR. THE ONLY WAY TO HAVE HEAD LIGHT IS TO PULL THE BRIGHT LIGHT SWITCH BACK AND HOLD IT. SO ONE HAND FOR BRIGHT LIGHT AND ONE FOR STEERING. SO WITH ON COMING TRAFFIC ITS EITHER THE BRIGHT LIGHTS OR NO LIGHTS. HAPPENED ON A VERY DARK NIGHT ON A COUNTRY ROAD. COULD HAVE BEEN A VERY BAD ACCIDENT. LUCKY THAT MY 3 SMALL CHILDREN WHERE NOT WITH ME

TL*THE CONTACT OWNS A 2004 CHEVROLET IMPALA. WHILE DRIVING 2 MPH IN THE RAIN, THE SPEEDOMETER STOPPED WORKING. THE FAILURE HAD OCCURRED SINCE 2008 UNTIL THE SPEEDOMETER WAS REPLACED AT A LOCAL REPAIR FACILITY. THE CONTACT SENT THE MANUFACTURER THREE LETTERS REGARDING THE FAILURE BUT THE MANUFACTURER STATED THAT THEY WOULD NOT REPAIR THE VEHICLE FREE OF CHARGE. THE FAILURE MILEAGE WAS APPROXIMATELY 35,000. THE CURRENT MILEAGE WAS APPROXIMATELY 75,000. UPDATED 06/17/10. *LJ THE CONSUMER STATED THE NEEDLE WOULD NOT RETURN TO ZERO WHEN THE VEHICLE WAS STOPPED. UPDATED 07/26/10*JB

STEERING RACK,FIXED ON 8/27/09 ON 3/29/10 CANNOT STEER TO LEFT, LIMITED ON RIGHT TWICE TURNING TO LEFT CAR COULD NOT ALMOST HAD ACCIDENT WITH ON COMING CARS AND PARKED CARS CAR TOWED TO MY MECHANIC,SAYS WORK WAS DONE ON THIS, TO TAKE BACK TO THEM. HAD TO TOW TO DEALERS. WAS THE STEERING RACK ONCE MORE.

WAS DRIVING ALONG AND ALL OF A SUDDEN MY SPEEDOMETER STARTED "FLOATING". IT WOULD BE ALL OVER THE PLACE, SOME TIMES IT WOULD GO ALL THE WAY AROUND TO 120 AND OTHER TIMES IT WOULD BE RIGHT ON.

I WAS DRIVING MY CAR DOWN THE ROAD AND ALL OF THE SUDDEN MY SPEEDOMETER AND WATER GAUGE STOPPED WORKING. IT SAID I WAS GOING 120 MPH BUT I WAS ONLY GOING ABOUT 30 MPH. THE NEXT DAY I WENT OUT TO THE CAR AND STARTED IT WHILE IT WAS PARKED AND IT WAS STUCK ON 30 MPH AND THE TEMP GAUGE SHOWED THE NEEDLE IN THE RED, BUT IT WAS NOT STARTED FOR MORE THAN A MINUTE. I HAVE READ MANY COMPLAINTS ABOUT THIS AND THIS SEEMS TO BE A FAMILIAR COMPLAINT. *TR

2004 CHEVROLET IMPALA SPEEDOMETER QUICK WORKING, NO IDEA HOW FAST CAR IS GOING. THE TEMPERATURE GAUGE ALSO QUIT, CAR COULD OVERHEAT WITHOUT KNOWING. *TR

2004 CHEVROLET IMPALA SPEEDOMETER STOPPED WORKING PROPERLY. IT STICKS(DOES NOT RETURN TO 0 MPH WHEN STOPPED) AT THE CURRENT SPEED ON DECELERATION AND INCREASES READINGS FROM THE DECELERATION POINT. SO, CAR APPEARS TO GOING AT 60 MPH EVEN THOUGH IT IS MOVING SLOWLY IN TRAFFIC. CANNOT DETERMINE PROPER SPEED TO ADJUST SPEED TO SPEED LIMITS. MY CAR REGISTERED 120 MPH IN A SCHOOL ZONE, EVEN THOUGH I WAS TRYING TO MAINTAIN PROPER SPEED. THIS DEFECT MAKES THE DRIVER UNABLE TO DETERMINE ACTUAL SPEED VEHICLE IS MOVING AT. *TR

THE HEADLIGHTS ON MY 2004 CHEVY IMPALA RANDOMLY GO OUT AT NIGHT WITHOUT ANY WARNING. THIS SEEMS TO BE CAUSED BY A DEFECTIVE DIMMER SWITCH. THE ONLY WAY TO GET THE LIGHTS BACK ON IS BY ACTIVATING/FLICKING THE DIMMER SWITCH SO AS TO SWITCH BETWEEN HIGH/LOW BEAMS. NO SIGNIFICANT EVENTS LED UP TO THIS PROBLEM. IT APPEARED RANDOMLY AND WITHOUT ANY WARNING. THIS PROBLEM OCCURRED ROUGHLY ONCE EVERY TWO WEEKS THROUGHOUT SEVERAL MONTHS UNTIL THE DIMMER SWITCH HAD COMPLETELY FAILED. APPROXIMATELY HALFWAY THROUGH THE TIME PERIOD FROM ONSET OF THE PROBLEM UNTIL FAILURE OF THE SWITCH, THE SWITCH ITSELF BEGAN TO FEEL ODD. IT WOULD ALLOW THE HEADLIGHTS TO CHANGE BEAM WITHOUT ACTUALLY CLICKING INTO POSITION. DURING THE LATTER HALF OF THE FAILURE PERIOD, THE LIGHT FAILURE SEEMED CONSISTENT WITH THE IMPROPER OPERATION OF THE SWITCH. THE SWITCH NOW IS COMPLETELY FAILED WITH MY LIGHTS STUCK ON LOW BEAM. I CAN PULL BACK ON THE SWITCH TO ACTIVATE THE HIGH BEAMS, BUT THEY DO NOT REMAIN ON WHEN I RELEASE THE SWITCH. THE LIGHTS GO BACK TO LOW BEAM. I AM CURRENTLY IN THE PROCESS OF CHANGING THE SWITCH WHICH IS PROVING VERY COSTLY. *TR