2000 CHEVROLET MALIBU Complaints

#5 FUEL INJECTOR HAS HAD TO BE REPLACED AT 27,963 MILES AND AT 58,736 MILES. REPAIR SHOP STATED THAT #5 FUEL INJECTOR IS LOCATED CLOSE TO THE EGR VALVE WHICH PUTS OFF A LOT OF HEAT AND MAY BE CONTRIBUTING TO THE PREMATURE FAILURE. *NLM

WHILE THE VEHICLE WAS BEING SHIFTED INTO PARK THE VEHICLES FRONT AIRBAGS DEPLOYED. *NLM

CONSUMER STATES THAT WHILE DRIVING AT ANY SPEED AND NO WARNING THE VEHICLE WOULD JERK AND THEN THE ENGINE LIGHT WOULD ILLUMINATE AND STAY ON THE REMAINDER OF THE TIME VEHICLE WAS BEING OPERATED. *NLM

CONSUMER STATED THAT WHEN APPLYING THE BRAKES THE BRAKE PEDAL WOULD GO TO THE FLOOR CAUSING THE VEHICLE TO HAVE EXTENDED STOPPING DISTANCE. DEALER NOTIFIED. *NLM

WHEN THE BRAKES WERE APPLIED, THE BRAKE TRAVELED TO THE FLOOR, WHICH CAUSED EXTENDED STOPPING DISTANCE. *JB

I BOUGHT MY CHEVY MALIBU 02/01 AND I HAVE 39,000 MILES AND ALREADY I HAD PROBLEMS WITH THE AIR CONDITION SWITCH. THE AC SETTINGS CHANGE ON THEIR OWN AS YOU ARE DRIVING THE CAR. THIS CAUSES THE COMPRESSOR TO TURN ON AND OFF, EVENTUALLY CAUSING PREMATURE COMPRESSOR FAILURE. MY BRAKES WERE SQUEAKING SO I WENT TO JUST BRAKES TO GET THEM CHANGED AND IT COST 636.00. I HAD TO HAVE A FOUR WHEEL FRICTION RELINE, DISC PADS RF AND LF, BRAKE SHOES RELINED RR AND LR, ROTORS WERE NEW (COULD NOT CUT) MACHINE RF LF, DRUM MACHINE RR LR, WHEEL CYLINDERS NEW RR LR, BLEED, FLUSH, FILL AND ADJUST BRAKE SYSTEM, ETC. I WENT TO THE DEALER AND THEY SAID "BECAUSE I DID NOT BRING THE VEHICLE TO THEM, TO GET SERVICED THERE WAS NOTHING THEY COULD DO ABOUT IT BECAUSE THEY DID NOT LOOK AT THE MATERIAL." EVEN THOUGH I HAD THE MATERIAL FOR THEM TO LOOK AT. SO I GUESS I HAVE TO EAT THE $700.00 JUST BECAUSE OF THEIR DEFECTIVE MATERIAL. *JB

MY CAR KEPT DYING WHILE DRIVING DOWN THE ROAD. MY MECHANIC TOLD ME TO CONSIDER 1/4 TANK EMPTY, BECAUSE WHEN THE CAR GOT DOWN TO EMPTY, ALL THE GAS WAS IN THE LINES AND IT RUINED THE FUEL PUMP. IT HAS NOT HAPPENED SINCE I GOT A NEW FUEL PUMP. 8JB

THE ENGINE STALLED WHILE DRIVING DUE TO A FAULTY IGNITION SWITCH. THE STEERING WHEEL WAS LOUD DUE TO AN IMPROPERLY INSTALLED CAM/HORN CONTACT. SCC *NLM

THE STEERING BOLT BECAME LOOSE, WHICH CAUSED CONSUMER TO LOOSE CONTROL OF THE VEHICLE.*JB

THIS COMPLAINT STEMS FROM THE TIME I HAVE HAD THIS CAR. A POPPING NOISE THAT COMES FROM THE REAR OF THE VEHICLE FROM EITHER BOTH THE TRUNK AREA AND OR SUSPENSION, A HOLLOW SOUND NOT VERY LOUD THOUGH. IT HAPPENS ON UNEVEN SURFACES AT VERY LOW SPEEDS. I BROUGHT THE CAR TO THE DEALER FOUR TIMES AND SOMETIMES THE SOUND OR SOUNDS ARE NOTICED BUT NOTHING IS DONE,EXCEPT FOR LUBRICATION. SOMETIMES IT IS HARD TO DUPLICATE AND AT OTHER TIMES IT CAN. ALSO IT NEVER HAPPENS AT HIGHWAY SPEEDS. ONLY SLOW SPEEDS AND ON RIGHT OR LEFT TURNS. I HOPE THAT THE ENGINEERS CAN DISCOVER IT. THE CAR IS A 2000 CHEVROLET MALIBU. VIN [XXX]. THE CAR IS STILL UNDER WARRANTY. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6). *TR