2021 CHEVROLET SILVERADO 1500 Complaints

Engine Temperature fluctuates. Check engine light comes on, prompt on dash will say engine is overheating. Engine fan stays on high. Code on scanner states Coolant Control Valve. GM has issued special coverage on this exact issue. However, they tell me my truck is not covered. I am very upset with GM as they are failing to address a known concern with my vehicle.

On my 2021 Chevrolet Silverado 1500 Custom, I began noticing an issue around 79,000 miles where the vehicle did not come to a complete stop as smoothly as expected. Initially, I suspected the brakes, as I purchased the truck new and had not performed any brake maintenance up to that point. I scheduled an appointment with the dealership to have all four brakes replaced; however, upon inspection, I was advised that the brakes were still in good condition, with approximately 90% life remaining. I then completed a test drive with the shop foreman, who was able to replicate the concern to some extent and suggested that the issue may be related to the transmission. At this time, the dealership is in the process of disassembling the transmission to determine whether the issue can be resolved with a repair or if a full replacement is necessary. It is concerning that such a significant issue would arise at approximately 80,000 miles. Based on similar reports I have reviewed, this appears to be a relatively common concern within the 80,000–90,000 mile range. Additionally, this poses a serious safety concern, as the vehicle’s hesitation in coming to a complete stop nearly resulted in a rear-end collision while en route to the dealership. There have been no dash lights on.

I was accelerating to 45MPH on a main road. My truck was running just fine. At about 45 MPH it felt like I hit a wall, and my truck started to rapidly decelerate and seemed to be downshifting very hard. A reduced engine power warning appeared in the message display, and the check engine light illuminated and began to flash. I luckly the car behind me was able to change lanes quickly and missed me and I was able to pull off the main road and turn off the truck. I let it sit for five minutes and restarted the truck. When I did, the truck seemed to drive at 25 MPH, and I kept it at that speed and was able to get it to my work down the road. When I got to work, my company's mechanic ran the code. A P2732:00 Transmission control solenoid valve 6 stuck off and P0700:00 transmission control module requested MIL illumination codes came up. We also noticed my truck no longer went into reverse and the engine would just rev and nothing else happened. I had the truck towed to the Chevy dealer who also got a P2732 error code. The truck as been at the dealer for the last two weeks and I have not told them to fix it yet.

On January 2, 2026, I brought my vehicle in for service to replace the upper and lower ball joints, as well as the control arms. I retrieved the vehicle from the repair shop on [XXX] and departed the same day for travel to Mississippi. Later that evening, while traveling southbound on [XXX] near Columbia, Tennessee, I stopped at [XXX]. Upon re-entering the highway and accelerating to merge into traffic, the vehicle began shifting through gears abnormally. While in approximately 6th gear at around 2,900 RPM, a loud banging noise occurred, followed immediately by a significant loss of engine power. At the same time, the check engine light illuminated. Due to the sudden and unexpected loss of power while actively merging into highway traffic, I was nearly rear-ended by another vehicle. I was forced to take immediate evasive action and pull onto the shoulder to avoid a collision. This incident created a highly dangerous situation not only for myself but for surrounding motorists. This lifter failure occurred without warning and directly impacted my ability to safely operate the vehicle in a high-speed traffic environment. I believe this presents a significant safety concern that warrants investigation. There have been over 600,000 recalls for this and Chevrolet's solution was an entire engine replacement. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Rough shifting in low gears, can be dangerous in intersections due to low acceleration ability. The check engine light is on for replacement of Transmission Valve Body Assembly.

All of a sudden my check engine light came on with the sudden loss of power steering. Almost impossible to steer at low speeds. After turning it off I waited about 15 minutes then restarted the engine and there was no problem steering. Concern about it happening again in the middle of traffic.

I am filing this safety complaint regarding a documented engine wire harness chafing defect in my 2021 Chevrolet Silverado 1500 with the 2.7L L3B Turbo engine. While driving, my truck experienced erratic acceleration, engine throttling to 3,000 RPM without returning to idle after releasing the accelerator, engine misfires, sudden loss of engine power, stalling, and multiple simultaneous warning lights. These conditions created immediate safety and collision risks on public roads. GM issued TSB 21-NA-149 in June 2021 and a second bulletin September 17, 2021, both before my November 2021 purchase, identifying wire harness chafing in the L3B engine caused by a manufacturing error. A wire harness clip was removed during production creating an uncontrolled harness branch that contacts sharp edges on the ECM/TCM bracket, upper control arm, and shock tower during normal engine vibration. This defect was built into the vehicle at the factory and was never disclosed to me at point of sale. The defect manifested after warranty expiration causing cascading failures; wire harness, catalytic converter, and transmission, all within five weeks. Vehicle has been inoperable since January 8, 2026. Defect confirmed by independent mechanic and by Ancira-Winton Chevrolet (authorized GM dealer) in their own repair documentation referencing GM Bulletin 21-NA-149. Dealer documented catalytic converter failure as consequential damage from wire harness repair. GM created Customer Satisfaction Program N192219370 for this exact defect. My VIN was excluded despite experiencing identical symptoms. No safety recall has been issued. Loss of throttle control and stalling at highway speeds represents an imminent collision risk. I request NHTSA investigate a formal safety recall for 2019-2023 Silverado 1500 and Sierra 1500 vehicles equipped with the L3B engine.

The contact's father owns a 2021 Chevrolet Silverado 1500. The contact stated that while driving approximately 70 MPH, the check engine warning light illuminated. The vehicle started losing automotive power. The contact pulled over and turned off and restarted the vehicle, but the check engine warning light remained illuminated, and while the vehicle was shifted to drive(D), the vehicle failed to accelerate above 40 MPH. The contact stated that the vehicle was taken to a dealer who diagnosed the vehicle and determined that the lifters and cam shaft had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was informed of the failure. The failure mileage was approximately 63,000.

The transmission has been having issues for the past couple days. It is the 10 speed model and I have noticed everyday for the last couple days that there is an unusual shifting pattern between 25-60mph. This is sometimes accompanied with a shudder that feels like going over rumble strips without the sound. The feeling is not constant, but I will come to a complete stop and under light acceleration it will return. Under hard acceleration it is not noticeable. However, I am concerned with the unusual shifting. It can happen at a constant speed where it will do a random shift up or down or under light acceleration it will feel like it’s slipping for just a second. The vehicle has 99,900 miles on it and there are no warning signs or lights active. The vehicle is about to be serviced to do an inspection to find the underlying issue. This is a safety concern because the vehicle could potentially cause more damage to the transmission and with the random shifting, could potentially cause an accident.

COMPLETE ENGINE POWER LOSS. I WAS DRIVING MY TRUCK TO WORK. I PULLED OUT TO THE DOUBLE LANE HWY TO MAKE MY WAY TO WORK. AS I WAS EXCELERATING UP THE HILL THE ENGINE JUST STOPPED, FULL POWER LOSS. PRIOR TO THE POWER LOSS THERE WERE NO WARNING LIGHTS OR ALARMS. ENGINE LIGHT WAS NOT ON. LUCKILY IT WAS EARLY IN THE MORNING AND THE ROAD WAS NOT BUSY. I WAS ABLE TO COAST MY TRUCK TO THE SIDE OF THE ROAD AND LATER HAD IT PULLED TO THE SHOP. I WAS TOLD THE ENGINE FAILED. THERE WAS AN ENGINE ERROR CODE P0016. I WAS TOLD THE ENGINE WAS SHOT AND WOULD BE BETTER OFF REPLACING. i WS ALSO TOLD THIS WAS NOT COVERED UNDER THE CURRENT RECALL. THE ESTIMATE TO REPLACE IS $9500. MY TRUCK HAS 93,XXX MILES ON IT. iT IS CURRENTLY AT VOGELS CHEVROLET IN KIEL, WI 53042