2018 CHEVROLET SILVERADO 1500 Complaints

I was driving on the highway at about 70 mph and the passenger side lower control arm where the ball joint sits broke. It messed up the passenger fender and tire along with the steering link. It also bent the upper control arm as well. The ball joints were replaced about 6 months ago.

A known radiator issue, with microcracks in radiator is producing a leak and will require replacement. There are many examples of this online for the model years 2014-2018, and are known by the manufacturer. I am having mine replaced with 95,000 miles on my truck.

I am very certain that I have proof that from the dealership a Cable Dahmer and Kansas City Missouri did break work concerning the brake master cylinder booster was replaced and it still has problem which should have been under a recall and I would like to get that corrected and received my service funds back

The truck dies when you turn the steering wheel all the way. When that happens the steering wheel jerks and could cause a crash. This appears to be a common electrical problem that currently has no recall from the manufacturer.

Vehicle was determined to be unsafe to operate per inspection performed by Mike Maroone Chevrolet on 8/26/24 immediately after I purchased from Rocky Mountain Auto Brokers in Colorado Springs on 8/8/26. It was discovered by customer immediately after sale that bank 2 catalytic converter was restricted internally (after Rocky Mountain failed to correctly diagnose and repair 3 times before and after purchase). Customer discovered emissions warranty extension and took to Maroone Chevrolet. After warranty repair inspection of vehicle determined it was not safe for customer to pick up and drive vehicle and generated a report and video showing front suspension damage so loose that could cause crash and vehicle was towed back to Rocky Mountain for repairs. Rocky Mountain has failed to provide any documentation on these repairs and many subsequent repairs including transmission replacement after many written requests. Customer cannot verify if vehicle repairs brought vehicle back to a safe condition. Almost anll repairs by Rocky Mountain has failed resulting in missing bolts, bolts falling out after transmission replacement As well as failure of many CV Axel replacements documented in their own records. Extended Warranty Company also refuses to provide documentation of transmission replacement after they supplied the part (transmission) to Rocky Mountain for installation. Customer cannot verify if in fact transmission was replaced as it was painted black. Any warranty on replaced transmission cannot be verified and they also have refused to provide documentation or serial number verifying same after many written requests. Customer would like to submit a detailed letter and safety inspection report with further info and details in addition to this online form complaint as this is a complex case and additional info will further prove up these allegations. Some documents provided by Rocky Mountain are inconsistent with customer complaints and do not reflect accurate info.

The frame of my 2018 Chevrolet Silverado 1500 has rusted through to the point of failing Maine state safety inspection at only 41,000 miles. A licensed Maine inspection station identified structural frame corrosion and determined the vehicle is unsafe to operate. A Chevrolet dealer confirmed the frame rust and stated the truck must have rusted sections cut out and welded to be made roadworthy. The vehicle is available for inspection upon request. Safety risk: A rusted-through frame on a pickup truck is a serious structural defect. Frame failure while driving could cause loss of vehicle control, separation of suspension or drivetrain components, or catastrophic structural collapse, particularly at highway speeds or under load. The vehicle is currently unregisterable in Maine due to this safety failure. The failure has been confirmed by both an independent licensed inspection station and by a Chevrolet dealership service department. This failure is consistent with a known manufacturing defect documented in GM Technical Service Bulletin 19-NA-255, which acknowledges that the wax coating applied to the frames of 2011–2024 Silverado and Sierra trucks was improperly applied by a third-party frame supplier, causing the coating to peel and exposing bare steel to premature corrosion. GM has issued this TSB but has not issued a recall, and Chevrolet dealers are not consistently performing the repair. I contacted GM Customer Assistance to request goodwill repair and was refused; the representative also declined to open a case. There were no warning lamps or dashboard messages prior to discovery, as frame corrosion is not monitored by vehicle systems. The defect was identified visually during state safety inspection. I am requesting that NHTSA investigate this defect pattern and consider a recall, as was ultimately ordered for the similar frame corrosion defect on Toyota Tacoma trucks.

I was driving on highway 20 in Cartersville ga at speeds around 55-60 mph with both of my kids the vehicle. All of a sudden my rpm’s shot up to over 5000 while losing acceleration control of the vehicle. I attempted to slow down and pull over on the side of the road to get out of traffic and was unable to get the vehicle to move forward or backwards at all. The rpm’s continued to rev out of control unless I was park. I had to shut the vehicle off for a few minutes, erase codes and attempt to move it again. I got it to move another few feet to just clear the roadway. I had to leave the vehicle on the side of the road and get both my kids out on the highway and wait for someone to come pick us up. The truck is now in the shop and I’m told that the torque converter shred to pieces and the my transmission was shot. This was a $7000 fix and the vehicle hasn’t even hit 100,000 miles yet. I also did the recommended service at 80,000 miles following the Chevy guidelines for my truck.

The contact owns a 2018 Chevrolet Silverado 1500. The contact stated that while driving at various speeds, there was an abnormal whining sound coming from the vehicle. There was no warning light illuminated. The contact called an independent mechanic to inspect the vehicle. The independent mechanic discovered that the camshaft and lifters were inoperable. The mechanic stated that the issue would worsen if the vehicle were continually driven. The manufacturer was notified of the failure and informed the contact that there were no recalls associated with the VIN. The vehicle was not repaired. The failure mileage was 147,000.

the paint on my vehicle has been bad since purchased, complained to dealership several times about this issue. one time when i complained the paint was touched up at dealership the issue has continued and became worst over time, my truck is a 2018 only 19,000 miles and the paint chips on the front where it looks like red paint speckled with white contacted the dealer as well as general motors corporate and the refuse to do anything i have complained about the paint every time the oil is changed at dealership after no help, i found a lawsuit was pending covering paint issues and the website recommend to register a complaint with NHTSA for recording issues thank you [XXX] [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Failed/collapsed lifters associated with known Active Fuel Management (AFM) issues. These issues are documented in Technical Service Bulletins and I believe there are Special Campaigns for 2014-2018 L83 engine, but my VIN does not have a Special Campaign attached to it for some reason. I believe there are also class action lawsuits associated with these known issues, but a recall has not been issued.