2002 CHEVROLET SILVERADO 1500 Complaints

RIGHT SIDE SPRING SHACKLE FAILED DUE TO EXCESSIVE CORROSION RIGHT SIDE OF REAR BUMPER CORRODED TO THE POINT THE MOUNT FAILED. *TR

I WAS QUITE FORTUNATE TO HAVE BEEN LEAVING A PARKING SPOT AND HAD JUST LEFT "PARK" SHIFTED INTO DRIVE AND APPLIED THE BRAKE BECAUSE A PEDESTRIAN STEPPED OUT. AT THAT TIME THE PEDAL HIT THE FLOOR, I STEERED THE TRUCK IN THE OPPOSITE DIRECTION FROM THE PERSON, HEADED FOR A PART OF THE LOT WHERE THERE WERE NO CARS, APPLIED THE PARKING BRAKE, IT DID'NT WORK EITHER, SO I PUT IT INTO PARK. ALL THIS AND I HADNT APPLIED THE GAS TO THE VEHICLE. ONLY MOMENTS BEFORE I PARKED, I HAD BEEN TRAVELING ON THE EXPRESSWAY AT 70 MPH. WHEN I GOT OUT OF THE TRUCK, ALL THE BRAKE FLUID WAS ON THE GROUND. UPON CLOSER INVESTIGATION, WE NOTICED THE BRAKE LINES WERE ROTTED OUT COMPLETELY. WE FEEL LUCKY THAT NO ONE WAS INJURED OR KILLED. VERY ANGRY AT CHEVROLET. *TR

THIS VEHICLE, AT 46,000 MILES HAD TO HAVE ALL THE ROTORS AND BRAKE PADS AND TWO CALIPERS REPLACED BECAUSE THEY RUSTED UP AND LOCKED UP. HAD TO DO IT AGAIN ABOUT 65,000 MILES, THEN HAD A BACK CALIPER SEIZE UP AND REPLACED BOTH ROTORS AND ONE CALIPER ALONG WITH NEW PADS. I THEN HAD TO HAVE ALL THE ROTORS REPLACED, BOTH FRONT HUBS, ONE NEW CALIPER AND PADS AGAIN AT BECK CHEVROLET A YEAR AGO. ON MY WAY DOWN TO FL THIS PAST FALL, WITH ABOUT 84,000 ON THE TRUCK, ANOTHER CALIPER SEIZED UP AND HAD TO REPLACE THE CALIPER, BOTH BACK ROTORS AND BRAKE PADS. YESTERDAY, 3/27/13, ON MY WAY HOME FROM TOWN, WITH 85,000 MILES ON THE TRUCK, THE PEDAL WENT TO THE FLOOR AND NO BRAKES. INSPECTION SHOWED A RUPTURED BRAKE LINE ON THE DRIVER'S SIDE. MY REPAIRMAN SAID EVERY BRAKE LINE IS SWISS CHEESE AND NEED TO BE REPLACED. THIS IS RIDICULOUS. I'VE SPENT SEVERAL THOUSAND DOLLARS AND HAVE REPLACED BRAKES 3 TIMES, ALL ROTORS, MOST CALIPERS AND TWO FRONT HUBS BECAUSE OF RUST. THE FRAME AND EVERYTHING UNDER MY TRUCK IS RUSTED VERY BADLY. I'VE OWNED THIS TRUCK SINCE 2004, AND BOUGHT IT WHEN IT HAD 26,000 MILES ON IT. IT DRIVES BEAUTIFUL AND IS LIKE NEW, BUT IT'S GOING TO ROT RIGHT OUT FROM UNDER ME. PLEASE HELP! *TR

I WAS DRIVING MY 2002 SILVERADO ON A NARROW TWO LANE ROAD WITH A FEW STEEP GRADES AND MY BRAKES WENT TO THE FLOOR ON ONE OF THE DOWN GRADES. I PUMPED THE BRAKES BUT NOTHING HAPPENED. LUCKILY, I HAD ENOUGH TIME TO REACT AND USE THE EMERGENCY BRAKE TO GET STOPPED AT THE BOTTOM OF THE GRADE BEFORE RUNNING THROUGH THE STOP SIGN AT THE T INTERSECTION AND POSSIBLY OVER THE EMBANKMENT DIRECTLY ACROSS FROM ME. ONCE I GOT HOME I REALIZED THAT ALL THE LINES RUNNING ALONG THE FRAME TO THE ABS BOX WERE CORRODED AS WELL AS THE ONES GOING TO THE FRONT CALIPERS. ONCE I STARTED RESEARCHING THIS I FOUND OUT THAT IT WAS A KNOWN PROBLEM. ALSO, ONE THAT JUST ABOUT EVERONE THAT I KNOW WITH A SILVERADO AROUND THAT SAME YEAR HAS HAD. I'M JUST GLAD THAT MY WIFE OR MY 16 YEAR OLD STEP-DAUGHTER WASN'T DRIVING WHEN THIS HAPPENED! *TR

WHILE EXITING FREEWAY, ON "OFF RAMP" REMOVED FOOT FROM GAS PEDAL TO START BRAKING AND PEDAL WENT TO FLOOR. LITERALLY STOPPED TWO (2) FEET FROM REAR OF ALREADY STOPPED CAR. UPON UNDERNEATH INSPECTION FOUND LEAKING BRAKE FLUID AT REAR, SEVERELY CORRODED BRAKE LINE. *TR

TWICE I HAVE HAD THE SPARE TIRE WINCH CABLE BREAK ON ME,IF THIS WAS TO HAPPEN IN HEAVY TRAFFIC OR HIGH SPEEDS IT COULD CAUSE SERIOUS INJURY OR DEATH,AND I WAS NEVER AWARE IT WAS GONE UNTIL I NEEDED THE SPARE. *TR

I HAVE A BROKEN EXHAUST MANIFOLD BOLT WHICH IS ALL TOO COMMON ON ALL V-8 GM ENGINES ON THE SILVERADO SIERRA SERIES TRUCKS. THERE ARE OFTEN MULTIPLE BROKEN BOLTS MOST COMMONLY THE FRONT OR REAR BOLTS. THIS SHOULD BE UNDER RECALL BECAUSE IT CREATES EXHAUST LEAKS AND CATALYTIC CONVERTER FAILURE WHICH ADDS A SAFETY ISSUE AND FINANCIAL BURDEN BECAUSE IT IS A VERY EXPENSIVE AND LABOR INTENSIVE REPAIR. COMPLAINTS ARE ALL OVER THE INTERNET AND YOUTUBE. AS AN ASE MASTER AUTO AND TRUCK TECH I'VE REPAIRED DOZENS AND SEEN DOZENS MORE BEING IN A GOVERNMENT FLEET OPERATION. GM SHOULD CARRY THE FINANCIAL BURDEN TO REPAIR THESE VEHICLES NOT PUT THE BURDEN ON THE CONSUMER. PLEASE GET THE WORD OUT AND LETS GET GM TO PAY UP. *TR

BRAKE LINE RUPTURED. MECHANIC SAID IT HAD RUSTED THROUGH. THIS HAPPEN IN 2009 AND AGAIN TODAY 2/23/2013. *TR

I WAS TRAVELING SOUTHBOUND ON CT. RTE. 8 AT APPROX 6AM AT 55 MILES PER HOUR. STATE MAINTENANCE VEHICLES HAD PARTIALLY OBSTRUCTED THE ROAD AS I ROUNDED THE BEND APPROACHING THE TRUMBULL TOWN LINE THIS IN TURN CAUSED AN ABRUPT HALT OF TRAFFIC. I APPLIED MY BRAKES RATHER HARD WHICH DID SLOW THE VEHICLE BUT I STILL HAD TO SWERVE INTO THE BREAKDOWN LANE IN ORDER TO AVOID A COLLISION WHEN THE BRAKE PEDAL WENT TO THE FLOOR. UPON INVESTIGATION I HAD FOUND THAT THE STEEL HARD LINE RUNNING ALONG THE FRAME RAIL FOR THE REAR BRAKES WAS BADLY CORRODED AND HAD BUST. THE REST OF THE STEEL LINES WHICH ALL RUN TO AND FROM THE ABS PUMP ARE ALSO IN BAD SHAPE. IT IS MY OPINION THESE LINES BE MADE FROM STAINLESS STEEL IN THE INTEREST OF SAFETY. AFTER ALL THEY MAKE MOST MODERN EXHAUST IN STAINLESS AND THAT IS NOT AS IMPORTANT AS STOPPING YOUR VEHICLE!!! *TR

TRAVELING DOWN HILL ON SNOW COVER ROADS AT ABOUT 40 MPH, THE LIGHT TURNED AND I HIT THE BRAKES AND THE PEDAL WENT TO THE FLOOR, THE REAR WHEELS STARTED SLIDING. I WAS NOT ABLE TO STOP IN TIME TO MAKE THE LIGHT, BUT WAS ABLE TO GET ON THE SHOULDER TO AVOID AN ACCIDENT AND COME TO A STOP. AFTER INVESTIGATION I FOUND THE STEEL BRAKE LINES THAT WERE BADLY CORRODED HAD RUPTURED. *TR