2002 CHEVROLET SILVERADO 2500 Complaints

I HAVE A 2002 CHEVY SILVERADO 2500 HD 4X5 8.1, I HAVE REPLACED THE CRANKSHAFT POSITION SENSOR A YEAR AGO AND NOW I AM GETTING THE ERROR CODE AGAIN STATING ITS IS BAD AGAIN. THIS IS NOT A CHEAP PART AND VERY DIFFICULT TO CHANGE, WHAT IS THE PROBLEM. *TR

BROKEN EXHAUST BOLTS ON MY 2002 CHEVY 2500 HD TRUCK, I WENT TO THE LOCAL GARAGE AND THEY TOLD ME THEY HAD WORKED ON 6 OTHER TRUCKS WITH THE SAME PROBLEM. THERE WAS A GM SALES MEN THERE AND SAID THEY HAVE BEEN HAVING ALOT OF TROUBLE WITH THE BOLTS BREAKING ON THE 6.0 MOTORS. *TR

TL*THE CONTACT OWNS A 2002 CHEVROLET SILVERADO 2500 HD. WHILE BACKING UP THE VEHICLE AT 1 MPH, THE REARVIEW MIRROR BECAME UNSTABLE. THE CONTACT CRASHED INTO A TELEPHONE POLE AND THE BRAKE LIGHTS CRACKED. THE VEHICLE WAS TAKEN TO A LOCAL DEALER AND THEY STATED THAT GM WAS AWARE OF THE REARVIEW MIRROR FAILURE; HOWEVER, THERE WAS NO CURRENT REMEDY. THE COST TO REPAIR THE DAMAGES MADE TO THE VEHICLE WOULD BE $4,500. THE VEHICLE HAS NOT BEEN REPAIRED. THE MANUFACTURER STATED THAT SOMEONE WOULD CALL THE CONTACT. THE FAILURE MILEAGE WAS 14,593 AND CURRENT MILEAGE WAS 14,661.

WHEN STEPPING ON BRAKES AT A LOW SPEED, I HAVE VERY LITTLE BRAKING. FEW TIMES CAUSED ME TO COME VERY CLOSE TO VEHICLE IN FRONT OF ME. LOOKED UP ON INTERNET PROBLEMS FOR THIS VEHICLE & FOUND RECALL 05068C. CALLED CHEVY & THEY SAID VEHICLE DOES NOT HAVE RECALL FOR BRAKES. *TR

TL*THE CONTACT OWNS A 2002 CHEVROLET SILVERADO 2500. WHILE DRIVING APPROXIMATELY 5 MPH ON NORMAL ROAD CONDITIONS, THE CONTACT HEARD A LOUD GRINDING NOISE WHEN THE BRAKE PEDAL WAS DEPRESSED. THERE WERE NO WARNING INDICATORS ILLUMINATED ON THE INSTRUMENT PANEL. THE VEHICLE WAS TAKEN TO AN AUTHORIZED DEALER AND THEY STATED THAT THE FAILURE WAS RELATED TO THE ANTILOCK BRAKE SYSTEM. THE VEHICLE HAS NOT BEEN REPAIRED. THE CONTACT WAS CONCERNED OF THE SAFETY RISK INVOLVED. THE FAILURE MILEAGE WAS 51,000 AND CURRENT MILEAGE WAS 53,000.

TL*THE CONTACT OWNS A 2002 CHEVROLET SILVERADO 2500 HD. WHILE DRIVING APPROXIMATELY 40 MPH, THE CONTACT NOTICED THAT THE VEHICLE WOULD VIBRATE WHEN THE BRAKE PEDAL WAS DEPRESSED. THE FAILURE OCCURRED ON SEVERAL OCCASIONS WHILE BRAKING AT LESS THAN 10 MPH. SEVERAL MECHANICS STATED THAT HE NEEDED TO REPLACE THE FRONT WHEEL SPEED SENSORS LOCATED IN THE HUB. THE MANUFACTURER HAS NOT BEEN NOTIFIED. THE VEHICLE HAS NOT BEEN REPAIRED OR PROPERLY DIAGNOSED. THE CURRENT MILEAGE WAS 49,080 AND FAILURE MILEAGE WAS 47,000.

UPON BRAKING PEDAL WENT TO FLOOR. RUSTED, PITTED MAIN BRAKE LINE FROM MASTER CYLINDER TO ABS PUMP. NO BRAKES. LINE REPAIRED. WHEN BLEEDING BRAKES ANOTHER LINE BURST. ALL LINES VERY RUSTED AND PITTED. ALL REPLACED. *TR

CHEVROLET 2500HD W/ 8.1 LITER ENGINE, STALLS AND HESITATES. THE ENGINE WILL USUALLY RESTART BUT WILL STALL AGAIN. I STALLED IN AN INTERSECTION AND WAS NEARLY STRUCK BY A FORD MUSTANG. DEALERSHIP DIAGNOSIS - CRANKSHAFT POSITION SENSOR. *TR

TL*THE CONTACT OWNS A 2002 CHEVROLET SILVERADO 2500 HD. WHILE DRIVING APPROXIMATELY 20 MPH AND APPROACHING A STOP SIGN, THE ANTILOCK BRAKING SYSTEM BEGAN TO PULSATE WHEN THE BRAKE PEDAL WAS DEPRESSED. THE VEHICLE WAS UNABLE TO STOP AND THE FAILURE PERSISTED. THE CONTACT TOOK THE VEHICLE TO A LOCAL REPAIR SHOP AND THE MECHANIC STATED THAT THE FAILURE WAS DUE TO CORROSION OF THE ANTILOCK BRAKE SYSTEM. SHE WAS INFORMED THAT THERE WAS A RECALL FOR THIS SPECIFIC COMPONENT AND WAS ADVISED TO TAKE THE VEHICLE TO THE DEALER. THE DEALER STATED THAT HER VIN WAS NOT INCLUDED IN NHTSA CAMPAIGN ID NUMBER 05V379000 (SERVICE BRAKES, HYDRAULIC:ANTILOCK). THE MANUFACTURER CONFIRMED THAT THE VEHICLE WAS EXCLUDED AND STATED THAT THEY WERE NOT LIABLE FOR THE REPAIRS. THE CURRENT MILEAGE WAS 38,000 AND FAILURE MILEAGE WAS 37,000.

I HAVE A 2002 CHEVY SILVERADO 2500HD WITH A 8.1. TWO MONTHS AGO THE TRUCK JUST STALLED WHILE I WAS DRIVING IT AND THEN IMMEDIATELY RE-STARTED. SINCE THEN THERE HAVE BEEN SEVERAL OCCASIONS WHERE THE TRUCK SIMPLY SHUTS OFF WHILE I AM DRIVING. IT HAS BECOME PROGRESSIVELY DIFFICULT TO RESTART THE ENGINE. I STALLED OUT IN THE MIDDLE OF AN INTERSECTION THE OTHER DAY AND SAT THERE FOR 2-3 MINUTES TRYING TO START THE TRUCK. THERE SEEMS TO BE NO RHYME OR REASON TO WHEN OR WHY THIS HAPPENS. MY ENGINE LIGHT HAS NEVER BEEN TRIPPED BY THIS PROBLEM. AFTER READING THE TROUBLE CODES AND CONSULTING WITH SEVERAL MECHANICS WE DETERMINED THE PROBLEM TO BE THE CRANK SHAFT POSITION SENSOR. AS I READ THROUGH COMPLAINTS ON THIS WEBSITE I NOTICE THIS IS A FAIRLY COMMON PROBLEM. IT IS ALSO VERY DANGEROUS. WITH THE AMOUNT OF COMPLAINTS AND THE LEVEL OF DANGER ASSOCIATED WITH THIS I WOULD HOPE THIS WOULD BE RECALLED FOR THE SAFETY REASONS. *TR