1997 DODGE DAKOTA Complaints

PREMATURE WEAR AND FAILURE OF UPPER AND LOWER BALL JOINTS. TRUCK WAS MAKING POPPING NOISES WHEN YOU TURNED THE WHEEL OR WENT OVER BUMPS. TOOK TO LOCAL MECHANIC; MECHANIC STATED THAT THE BALL JOINTS WERE SCARY BAD. MECHANIC ALSO STATED THAT IF I HAD NOT BROUGHT THE VEHICLE IN THE FRONT WHEELS COULD HAVE BROKEN OFF CAUSING THE VEHICLE TO WRECK. *JS

TL* THE CONTACT OWNS A 1997 DODGE DAKOTA. THE CONTACT WAS DRIVING 30 MPH WHEN THE HEATER BLOWER MALFUNCTIONED. THE CONTACT WAS UNABLE TO HEAT THE VEHICLE INTERIOR OR UTILIZE THE DEFROSTER. THE VEHICLE WAS TAKEN IN FOR REPAIRS WHERE THE HEATER BLOWER, MOTOR AND BLOWER FAN WERE REPLACED. THE TECHNICIAN ALSO ADDED MORE ANTI-FREEZE TO THE VEHICLE BUT NONE OF THE REPAIRS REMEDIED THE FAILURE. THE MANUFACTURER WAS NOT CONTACTED TO REPORT THE FAILURE. THE VEHICLE WAS NOT FURTHER REPAIRED. THE FAILURE MILEAGE WAS 96,400. UPDATED 3/1/11 *CN UPDATED 07/01/11

TL*THE CONTACT OWNS A 1997 DODGE DAKOTA. UPON STARTING THE VEHICLE, THE CONTACT NOTICED A STRONG FUEL ODOR. THE CONTACT SHUT THE VEHICLE OFF AND DISCOVERED FUEL LEAKING UNDER THE VEHICLE. THE VEHICLE HAD NOT BEEN DIAGNOSED OR REPAIRED. THE CURRENT AND FAILURE MILEAGES WERE APPROXIMATELY 120,000. UPDATED 02/03/11*LJ UPDATED 03/17/11

DUE TO POOR CHOICE OF MATERIALS (I ASSUME) THE FRONT HUB AND SPINDLE ASSEMBLY WEARS. LEAVING FRONT BRAKE SLIDER PINS UNATTACHED TO CALIPER MOUNTING PLATE. WHEN THIS HAPPENS, THE FRONT CALIPER WOBBLES IN IT'S PLACE, POSSIBLY EJECTING THE SLIDEPINS BECAUSE THEY "WOBBLE" IN THE KNUCKLE HOLES DESIGNED TO RETAIN THEM. THIS CAUSES EXCESS WEAR ON THE FRONT HUB ASSEMBLY, INCREASED WEAR IN BRAKES, AND STRESS ON THE HUB BEARINGS. HAVING READ THE "ALLDATA" DATA BASE, THERE IS A REDESIGNED KNUCKLE WITH IMPROVED SLIDE PIN SUPPORTS. THERE ALSO IS A REPAIR KIT INVOLVING THE USAGE OF "HELI-COIL" INSERTS TO SECURE BRAKE PAD CARRIER TO SPINDLE ASSEMBLY. (SLIDE PINS) I FEEL TOTALLY UNSAFE WITH THIS ARRANGEMENT. I PREFER TO HAVE THE RE-DESIGNED SPINDLE ASSEMBLIES INSTALLED FOR FREE BY DEALER WITH UP-DATED PART NUMBERS. THE DEALER WANTS $1000 PER SIDE FOR THE REDESIGNED UNITS. I THINK THIS IS ABSURD. THIS IS A SAFETY HAZARD AND COULD CAUSE LOSS OF LIFE DUE TO LOSS OF CONTROL. THE ONLY THING HOLDING THE BRAKE ASSEMBLIES IN PLACE IS THE WHEEL, ITSELF!! *TR

TL*THE CONTACT OWNS A 1997 DODGE DAKOTA. THE VEHICLE HAS CONTINENTAL TIRES. WHILE DRIVING 65 MPH, THE TREAD FROM ONE OF THE TIRES BEGAN TO STRIKE THE DOOR AND FRONT FENDER OF THE VEHICLE BEFORE COMPLETELY SEPARATING FROM THE TIRE. THE REMAINDER OF THE TIRES REMAINED INFLATED. THE CONTACT DID NOT DRIVE OR ANY POTHOLES OR OTHER ROAD HAZARDS TO CAUSE THE FAILURE. HE TOOK THE TIRE BACK TO THE STORE FROM WHERE IT WAS PURCHASED AND WAS INFORMED THAT IT WAS DEFECTIVE. THE TIRE WAS REPLACED FOR FREE. THE TIRE SIZE, TIRE LINE, AND REMAINING TREAD DEPTH WERE UNKNOWN. THE FAILURE MILEAGE WAS 90,408. UPDATED 03/17/09. *LJ THE CONSUMER BELIEVED THE TIRE WAS DEFECTIVE. UPDATED 03/17/09. *JB

THE BALL JOINTS ON MY 97 DODGE DAKOTA ARE WORN OUT. APPARENTLY THIS IS A VERY COMMON PROBLEM AND SUPPOSEDLY THERE IS A RECALL IN EFFECT FOR NEWER DAKOTAS AS THOUGH THE PROBLEM DIDN'T START UNTIL AFTER 1997. THIS IS A FAULTY PART FROM THE MANUFACTURING PROCESS AND ITS REPAIR (AMONGST THE MANY OTHER MANUFACTURING FAULT REPAIRS ON THIS VEHICLE) IS RUINING ME FINANCIALLY IN THIS ECONOMY. I SHOULD NOT BE HELD FINANCIALLY RESPONSIBLE FOR A CAR MAKERS INEPT MANUFACTURING. *TR

THE FRONT BRAKE CALIPER BOLTS TO THE STEERING KNUCKLE ON A 1997 DODGE DAKOTA, 4WD. DUE TO THE NATURE OF THE DESIGN, THE THREADS THAT HOLD THE BRAKE CALIPER MOUNTING STUDS CAN STRIP OUT, THEREBY LEAVING THE CALIPER TO FLOAT ON THE KNUCKLE. UNDER PROLONGED USE, THESE STUDS CAN BACK OUT, LETTING THE CALIPER FALL OFF, WHICH COULD LEAD TO A CRASH. ON MY PARTICULAR VEHICLE, THIS HAS HAPPENED FOR THE THIRD TIME NOW, ONCE ON THE DRIVER'S SIDE AND TWICE ON THE PASSENGER SIDE. THE THREADS STRIP OUT, AND THE MOUNTING BOSS SECTION IS SO SMALL THAT A LARGER THREAD CANNOT BE RETAPPED WITHOUT DANGER OF BREAKING THE HOLE OUT. AUTO PARTS SUPPLIERS SELL SLIGHTLY OVERSIZE, SELF TAPPING STUDS, BUT THESE DO NOT LAST LONG. THE STEERING KNUCKLE IS A VERY PRICEY PART (ON THE ORDER OF $600 JUST FOR THE PART) AND CONTINUING REPLACEMENT IS COST PROHIBITIVE. MY VEHICLE IS APPARENTLY NOT THE ONLY ONE WITH THIS PROBLEM, AS A SEARCH OF SALVAGE YARDS REVEALED NUMEROUS STRIPPED OUT THREADS ON VEHICLES WHERE THE STEERING KNUCKLE WAS ACTUALLY AVAILABLE. *TR

MY BALL JOINTS AND TIE RODS WERE GOING BAD AT 54,000 MILES. DODGE WOULD NOT DO ANYTHING ABOUT THE PROBLEM. ALSO, MY TRANSMISSION STARTED TO GO BAD AT 74,000 MILES. 2ND GEAR WENT OUT, THEN IT WENT COMPLETELY OUT AT 91,000 MILES. OBVIOUSLY DODGE WASN'T GOING TO DO ANYTHING ABOUT IT. I WONT BUY ANOTHER DODGE AGAIN. *TR

BALL JOINT FAILURES: TRUCK FAILED STATE INSPECTION DUE TO DEFECTIVE UPPER AND LOWER BALL JOINTS OR BALL JOINT AND LOWER CONTROL ARM. ANOTHER BALL JOINT HAD BEEN REPLACED THE PREVIOUS YEAR. ALL DEFECTS OCCURRED AT ABOUT 50,000 MILES. THIS IS COMMON PROBLEM WITH DODGE DAKOTA AND CHRYSLER WILL NOT PAY FOR REPAIRS. PROBLEM IS WELL DOCUMENTED ON DOZENS OF INTERNET SITES, BLOGS, ETC AND ALL MECHANICS AND STATE INSPECTORS ALL NOD KNOWINGLY ABOUT THE DODGE PICKUP. THIS IS SAFETY ISSUE AND FAILURE OF BALL JOINTS IS NOT A PROBLEM IN ALMOST ANY CAR EXCEPT CHRYSLER PRODUCTS. HOW DO THEY GET AWAY WITH THIS SAFETY ISSUE WHICH CAN CAUSE LOSS OF CONTROL AND CRASHES AND AT UNDER 50,000 MILES. IT IS TIME NHTSA FORCES DODGE TO RECALL AND REIMBURSE ALL COSTS TO THOSE ALREADY HAVING PAID FOR SUCH REPAIRS. THIS SHOULD BE APPLICABLE FOR ANY YEAR VEHICLE UP TO AT LEAST 100,000. I HAVE OWNED OVER A DOZEN VEHICLES AND MOST DRIVEN OVER 100,000 AND ONE AT 145,000 AND ONE 200,000 AND HAVE NEVER REPLACE BUT ONE BALL JOINT ON A 1970 CUTLASS. ONLY ONE HIGH MILEAGE VEHICLE WITH CV JOINTS BUT MAYBE NO BALL JOINTS HAD TO HAVE A CV JOINT REPLACED. THIS DOES NOT SPEAK WELL OF CHRYSLER/DODGE. *TR

TRANSMISSION FAILURE AT 50,000 MILES. TRANSMISSION BEGAN TO BOG DOWN WHILE DRIVING ABOUT 40 MPH. AFTER ABOUT 5 MINUTES IT WOULD ONLY GO ABOUT 5 MPH WHILE REVING ABOUT 3500 RPM. PAID FOR TOW TO DODGE DEALER IN HAMPTON VA FOR ANALYSIS AND REPAIR. TOW OPERATOR REMARKED ALMOST ALL DODGE DAKOTAS TOWED FOR TRANNY WORK ENDED UP COSTING $2300-$2900 FOR A REPLACEMENT. I WAS LUCKY AND ONLY HAD TO REPLACE ALL PRESSURE REGULATING VALVES FOR ABOUT $670 (FUNNY HOW THEY ALL WENT BAD AT THE SAME TIME BUT I WOULD NOT ARGUE THE POINT SINCE THE PARTS WERE CHEAP COMPARED TO DOING IT OVER IN A FEW MONTHS). DEALER INDICATED THIS WAS A YEARS OLD PROBLEM WHICH WAS COMMON TO REPLACE THESE TRANSMISSIONS AND THAT MY $600 REPAIR WAS NOT GUARANTEED TO PREVENT TOTAL FAILURE. DODGE HAS NOT AGREED TO ANY RECALL TO FIX BUT SHOULD DO THIS. THEREFORE, I WILL NEVER OWN ANOTHER DODGE OR CHRYSLER OF ANY SORT. UPPER AND LOWER BALL JOINTS ALSO FAILED AT UNDER 50,000 MILES AND NO REPAIR RECALL ON THIS LONG STANDING PROBLEM AS WELL. SUBJECT ON ANOTHER COMPLAINT. *TR