2013 FORD EDGE Complaints

I was issued a customer satisfaction program #13N02 while replacing brake booster helped, bypassing the fact the master cylinder fluid leaked into brake booster and was not part of repair is just ridiculous. Until master cylinder is repaired, problem will not be resolved! Please remedy by including master cylinder with brake booster 13N02. My brake pedal still goes to floor, I am requesting your immediate response

The contact owns a 2013 Ford Edge. The contact stated while driving the vehicle at an undisclosed speed the vehicle did not immediately stop when the contact depressed the brakes. No warning lights illuminated. The vehicle was taken to the dealer where a diagnostic was performed. The dealer stated the eco booster failed and needed to be replaced. The vehicle was not repaired due to cost. The contact referenced Ford's Customer Satisfaction Program 13N02 as a possible solution however, the VIN was not included in the recall. The manufacturer was notified of the failure. The failure mileage was approximately 110,000.

The rear driver side door Ajar light well come on when the door is closed and not making my doom lights come off and stay on and running down my battery

Put car in for regular service, and to investigate burning smell and transmission slippage. Mechanic found that the Power Transfer Unit (PTU) was completely filled with a paste-like sludge. (he has pictures) Mechanic says that the PTU is too close to the catalytic converter, therefore overheating the PTU and literally boiling the transfer fluid. He was able to clean the module, but says there's still a leak around the PTU seal. The work required to replace the seal, would also merit replacing the PTU. BUT, this is a $800 part! The safety risk would have been my transmission completely seizing up and causing an accident due to mechanical failure. The vehicle has had all of it's regular and milestone service work performed. No warning lights went off. I'm on borrowed time with this part and/or new transmission. Will there be a remedy to prevent this in the future?

The contact owns a 2013 Ford Edge. The contact stated that while decelerating from 45 MPH, the brakes failed to respond immediately. The contact continued depressing the brake pedal however, the pedal lost pressure. The vehicle was taken to the local mechanic and a diagnostic test was performed, the brake lines were bled, and it was determined the brake booster had failed. The contact stated the failure persisted. The contact went to the dealer and was informed to contact NHTSA Hotline for assistance. The manufacturer was not made aware of the failure. The vehicle was not repaired due to the cost. The approximate failure mileage was 86,000.

The contact owns a 2013 Ford Edge. The contact stated that, upon coming to a complete stop, the brake pedal felt abnormally hard. After shifting the vehicle into park, releasing the break pedal, and shifting back into drive, the vehicle returned to normal functionality, but the failure became a regular occurrence. No warning lights were illuminated. The vehicle was not taken to the dealer or an independent mechanic. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 179,000.

The contact owns a 2013 Ford Edge. The contact stated that upon entering the vehicle, she became aware that the driver's side door had not latched properly. Upon entering the vehicle, the contact observed that the ABS warning light was illuminated on the instrument panel. The vehicle was taken to an independent mechanic, who determined that the front brake rotors were cracked. Additionally, the vehicle was diagnosed with a door check arm failure. The vehicle was not repaired. After investigating the failure, the contact related the failure to NHTSA Action Number: PE16012 (Latches, Locks, Linkages, Interior Lighting). The manufacturer was notified of the failure but referred the contact to the NHTSA Hotline for assistance. The failure mileage was 100,000.

Purchased 2013 Ford Edge AWD Limited used 12/17 with 68,XXX miles. [XXX] began experiencing brake issues. When trying to stop brake pedal went to floor not slowing/stopping vehicle. Vigorously pumping brake stopped vehicle. Took vehicle to neighborhood shop, was informed of recall 13N02. Contacted Ford National Service center (800) 727-7000, confirmed my car covered by recall. Recall work was performed at Bellevue Ford, 411 116th Ave NE, Bellevue, WA 98004, United States, on September 28, 2020. Recently, [XXX] problems reoccured, this time brake failed and vehicle would not stop at busy Seattle intersection fortunately I wasn’t stuck/struck by other vehicles. Subsequently I again called Ford National Service center and was informed that recall/replacement parts are only warranted for 24 months. My car is currently in shop (for 3 days so far) . It seems that the brake booster that is the recall issue affects the entire braking system and pieces of the diaphragm within replaced brake booster are carried to the master cylinder, thru the brake lines and also affect the antilock computer components. Additionally, the Ford manufactured ‘replacement parts’ are often themselves defective. BRAKES ARE ARGUABLY THE MOST IMPORTANT SAFETY SYSTEM IN A PASSENGER VEHICLE! Obviously Ford has manufactured and is aware/responsible for this un-safe condition. They chose to ignore this situation. It seems Ford only manufactured 129,000 2013 Ford Edges. There are thousands of brake issue complaints listed the internet and many hundreds of Safety issues reported here at NHTSA. PLEASE INVESTIGATE THIS LIFE SAFETY ISSUE. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

While driving the 2013 Ford Edge, during a right turn, the brake pedal went to full hard to depress. The check engine light illuminated and the vehicle stalled. My daughter, a new driver, narrowly avoided an accident by pulling to the side of the road. Our local technician inspected the car and found the brake booster damaged. Ford is aware of this issue and has covered the replacement to SOME vehicles under their customer satisfaction program. The booster was replaced and the vehicle is operational now. Ford is very aware of this issue and this is an extremely dangerous situation to the driver of these automobiles and others on the road.

The contact owns a 2013 Ford Edge. The contact stated that while reversing, the rearview camera displayed a distorted image. The contact stated that the rearview camera had previously been replaced in 2020 under warranty. The vehicle was taken to the dealer; however, the vehicle was not diagnosed or repaired. The dealer informed the contact that there was no recall associated with the VIN and referred her to the manufacturer for assistance. The manufacturer was made aware of the failure and a case was opened. The contact was advised to file a complaint with the NHTSA Hotline. The contact related the failure to NHTSA Campaign Number: 20V575000 (Visibility); however, the VIN was not included in the recall. The failure mileage was approximately 135,000.