2013 FORD EDGE Complaints

i have ran my VIN on multiple site and the dealership said the did their inspection on the vehicle. The VIN is showing that there is no recalls on this car. However we noticed things going wrong with the Edge. Even though we bought the car as is, this shouldn't be happening if they did things right. The back up camera saying to contact the dealership, we have to go into the settings and switch from park to drive to somewhat fix the problem. The sync and myford touch has been update as of last week, to 3.10. However the system will switch songs, inputs and even go into the settings while the vehicle is on; without anyone touching the screen. The dealership has told me that they put in a new battery and that everything is fine when we bought it. Its not making any sense, i dont believe that they did the inspection the correct way or they wouldve noticed the issues and wouldve been resolved. I have even went so far as to take it to the dealer and show him but of course my car decided to work in that moment, until i left

The tailight bulbs are melting the plastic around the lights. This hss been an issue for me and millions of other drivers who own 2013 Ford Edges. https://www.fordedgeforum.com/topic/9037-burntmelted-taillight-bulbssockets/

The contact owns a 2013 Ford Edge. The contact stated while driving 30-40 MPH and making a turn, the brake pedal was depressed and went down to the floorboard, and the vehicle hesitated to respond. The contact stated that the failure recurred while driving. There was no warning light illuminated. The dealer was notified of the failure and referred the contact to the manufacturer for assistance. The vehicle was not diagnosed nor repaired. The manufacturer was notified of the failure and informed the contact that the vehicle could not be covered under Ford Service Campaign Number: 13N02 because the campaign had expired. The failure mileage was approximately 86,000.

When I hit a pot hole or bump I have no brakes. They go all the way to the floor. My mechanic will not touch them due to brake failure on all the Ford edges. I was told To contact you.

Since first purchasing the vehicle from Larry H. Ford in Mesa, AZ in 2019 and returning it for repair due to inoperable brakes, the issue has returned time and time again. It is now happening again where I either have to either press the brake peddle completely to the floor or the vehicle will not come to a complete stop at all. This has become extremely costly and I would like to know if this is an issue specifically associated with the 2013 Ford Edge and find some resolve.

I took very good care of my car's engine and while driving on the highway the engine block cracked open immediately shutting the car down, almost causing a crash and spilling oil all over the road for no apparent reason. There were no issues with the engine and no check engine lights were on.

2013 Ford edge sport water pump defect leaking into the engine causing it to stop in traffic which was dangerous because oil and antifreeze mixed together now it want run.

The contact owns a 2013 Ford Edge. The contact stated that while approaching a red traffic light, the brake pedal was depressed and went to the floorboard. The vehicle failed to come to an immediate stop and instead coasted at a low speed. The contact turned off the vehicle and the vehicle come to a complete stop. The vehicle was taken to a certified mechanic who replaced the rotors and brake pads. The contact stated that after the repairs the brakes started to lock-up. The service stabili-trac, stability failure, and other warning lights were illuminated. The vehicle was returned to the certified mechanic who replaced the brake booster and brake master cylinder. The failure persisted. The manufacturer was not made aware of the failure. The approximate failure mileage was 195,582.

The abs module has gone bad numerous times and is in a shop again for the third time in two month. I've havent been able to drive my car for two months at first it was the master cylinder and then the abs unit and then the brake booster and now the new abs unit again! After extensive research my husband and I found that this is very common in my vechile model but not enough cars to be issued a recall. Which I think is a massive safety issue because your brakes are very important. If your brakes fail you, you could not only injure yourself and your passengers but others around you. Right now my vehicle is at my local ford dealership and they also agree that this is a very common problem and ford isn't recalling them and making customers pay thousands of dollars for the new part and service. I was even told some times you don't get a working abs unit and have to keep going through the service part warranty until you get a good one. Which I feel causes more lost time with my vehicle staying in the shop until I get a good one.

when was driving pushed the brakes and it went straight to floor almost causing me to rear end the car in front of me. dealer said said it is the booster. no police or manufacturer inspection. no warning lights or any other symptoms