2014 FORD EDGE Complaints

1) my rear view camera is disoriented when car is in reverse. Sometimes the picture on the screen is upside down or doesnt show anything at all. 2) drivers seat belt does not clip in correctly. I have to push the red button in for the seat belt to clip into place.

I purchased my 2014 Ford Edge in December 2023. March 2023, I started having issues with the driver side door lock sensor malfunction as shown in the last photo. The door would not automatically lock when I started driving, sensing that the driver’s side door was still open. It was not. I kept pushing the lock button to lock it, but it kept unlocking even while driving. Eventually it would lock. The cost to fix that was around $600 which I could not afford, and my limited warranty expired. July/August 2025 my ABS and traction control sensor lights were lit on my dash. I took the car for service and my very reputable mechanic diagnosed with no codes showing up a few times. Performed a reset twice and the lights came back on after only driving a couple of miles. He contacted Ford who advised he couldn't sell the part because there was a "national hold" on the part. On 9/2 my brakes and traction control failed resulting me rear ending another vehicle. The other safety issue is that my airbags did not deploy upon the collision. I contacted Ford Corporation and was advised that Ford will not do anything since my vehicle was older than 10 years. The vehicle is a total loss leaving me with a loan balance of approximately $4,700.00. This is neither fair nor right for a multimillion-dollar company that will not or choose not to address or acknowledge their responsibility regarding these two very serious safety issues. Since I didn’t die or get seriously hurt, I guess it’s not that big a deal to Ford.

The contact owns a 2014 Ford Edge. The contact stated that the rearview camera was working periodically while reversing. There were no warning lights illuminated. The contact called the local dealer, who confirmed there were no recalls associated with the VIN related to the failure. The vehicle was not diagnosed or repaired. Upon further research, the contact linked the failure to NHTSA Campaign Number: 25V572000 (Back Over Prevention). The manufacturer was contacted, who filed a claim and referred the contact to the BBB, who referred her to the NHTSA Hotline to report the failure. The failure mileage was approximately 100,000.

When in reverse, the backup camera in my vehicle no longer functions. The view is displayed upside down which is very disorienting or the screen rapidly flashes.

My Ford has the rear view camera which at the time was an upgrade. Unfortunately it has not worked in the last 1 year. It has blanked out and shows upside down. According to the dealership only the 2015 and up had the recall. I understand that in 2014 was the year that back up cameras were required in cars. That is why we paid for an upgrade and purchased hours. And now all cars have them. I like to have ours fixed if at all possible without out of pocket.

The contact owns a 2014 Ford Edge. The contact stated that while attempting to reverse, the rear-view camera displayed an upside-down image. Occasionally, the picture or the view was distorted. The vehicle was taken to a local dealer, where it was diagnosed, and the contact was informed that the camera was faulty and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 194,000.

The backup camera has stopped working. Sometimes it appears fuzzy when the car is put into reverse, other times the screen is black and says I need to contact my local dealership. The screen can also stay that way after I place the vehicle back into drive for several minutes before it goes back to the accessory screen. This issue started out as just sometimes a problem and sometimes the camera would work fine. It is at the point now that it never works anymore. I also have had issues with the rear cross traffic sensors "detecting" things when the car is in reverse that aren't there. It can be very dangerous because you think something is behind the car that is not there and can cause the driver to slam on the brakes. This issue does not happen on a regular basis, just sometimes. The vehicle is available for inspection for all problems. None of the problems have been inspected by anyone professionally yet. A Dealership has not confirmed the issues either.

The contact owns a 2014 Ford Edge. The contact stated that the back over prevention camera intermittently failed to operate as needed. The contact stated that the failure was related to NHTSA Campaign Number: 25V572000 (Back Over Prevention); however, the VIN was not included. The local dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 64,000.

Back up camera stopped working. Back up sensors either don’t work or will just beep when nothing is behind the car. Don’t have exact date it stopped working because it started working for 1 day and then stopped working again. It has been probably 8 or 9 months since it has worked.

The contact owns a 2014 Ford Edge. The contact stated that while shifted into reverse(R), the rear-view camera image was either black or displayed upside down. The contact stated that the failure was intermittent. There was no warning light illuminated. The contact had not taken the vehicle to a local dealer or independent mechanic. The vehicle was not diagnosed or repaired. The manufacturer was informed of the failure and referred the contact to the NHTSA Hotline to report the failure. The failure mileage was approximately 98,000.