2013 FORD EDGE Complaints

There is currently a recall on back up cameras for ford edges 2015-2019, the cameras are upside down, blacking out, lots of issues. My edge is a 2013 and I am having the same issue. I am unable to use the camera as it’s upside down and when it’s not upside down, it’s flashing off and on. It’s hazardous and this should fall under the recall as well. I was told since I have a 2013, it does not fall under the recall. Which it should.

The contact owns a 2013 Ford Edge. The contact stated that while attempting to reverse, the back over prevention camera malfunction and failed to display an image. There was no warning light illuminated. The vehicle was taken to a local auto body shop where it was diagnosed, and the contact was informed that the camera was faulty and needed to be replaced. The vehicle was not repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 60,953.

It is my rear view camera. I would put the vehicle in reverse and it will sometimes start to work and than it will shut off and a message comes across saying I need to contact dealership. It will sometimes come up and be upside down or I will put the vehicle in reverse and the back up camera just flashes while in use. I have not taken the vehicle to the shop. I have called and they said it sounds electrical. But the recall you just released on 2015 Ford edges for the back up camera is the same thing that is going on with my vehicle and I have a 2013.

Water pump failure coolant leaking out of it Was driving at 10mph in parking garage when temperature gauge went to hot on cluster instrument everyone was ok had have had vehicle for about a month before breakdown private dealer did say there were no issues car has not been checked by a certified dealership.

The contact owns a 2013 Ford Edge. The contact stated that while driving approximately 40 MPH, the brake pedal was depressed too slowly for traffic; however, the brake pedal was soft and went to the floorboard. The vehicle was steered to the right and rolled down into a ditch to avoid crashing into the vehicle in front. The contact stated that the engine was still running. There was no warning light illuminated. The vehicle was turned off and restarted to reset the braking system; however, the brake pedal was still soft. There was no damage to the vehicle, and the contact was able to drive out of the ditch and back to the residence. The vehicle was not yet taken to a local dealer or independent mechanic to be diagnosed or repaired. The contact stated that in 2024, the vehicle was repaired under Customer Satisfaction Program: 13N02 - Brake Booster (Service Brakes, Hydraulic). The manufacturer was informed of the failure. The failure mileage was approximately 110,000.

Replaced Master Brake Cylinder and Brake Booster due to hard Braking. Also, ABS Control lights are illuminated. Codes show failed ABS module creating safety issue when fast breaking. Brake pushes down to the floor periodically Repair is very costly to fix.

Water pump replacement needs to be done on my ford edge. Driving down the highway my ford edge started over heating out of no where. When I pulled over check everything out. Discovered I was leaking antifreeze, and the leak was coming from the water pump area. Now my car is sitting due to can’t find a shop to replace it for a decent price . Was told this was common issue with my car and there’s big lawsuit over it due to not being a recall issue

The contact owns a 2013 Ford Edge. The contact stated that while driving at an undisclosed speed, the vehicle inadvertently lost motive power. The contact was able to pull over to the shoulder of the roadway, where the vehicle failed to restart. The check engine warning light was illuminated. The vehicle was towed to an independent mechanic, who diagnosed a failure with the fuel pump. The contact was informed that the fuel pump and fuel lines needed to be replaced. The vehicle was repaired, but the failure reoccurred. The vehicle was taken back to the independent mechanic, who was unable to duplicate the failure. The manufacturer was not notified of the failure. The failure mileage was unknown. The VIN was not available.

The contact owns a 2013 Ford Edge. The contact stated that while shifted into reverse(R), the camera image on the front display screen was black and the message "Contact Dealer" was displayed. The contact stated that the image was constantly black, and the camera or the display had stopped functioning. The contact researched online and related the failure to NHTSA Campaign Number: 25V442000 (Back Over Prevention); however, the VIN was not included in the recall. The contact notified the manufacturer and was informed that the VIN was not included in the recall. The manufacturer referred the contact to the NHTSA Hotline. The failure mileage was approximately 122,000.

The contact owns a 2013 Ford Edge. The contact stated there was an abnormal air hissing sound coming from the vehicle while depressing the brake pedal. There was no warning light illuminated. In addition to the sound, the brake pedal was firm, requiring extra force on the brake pedal while attempting to stop the vehicle. The contact called a dealer, and an appointment was scheduled for a diagnostic test to be performed on the vehicle. The vehicle was not repaired. The manufacturer was notified of the failure, and the contact was informed that the VIN was not under recall. The manufacturer referred the contact to the NHTSA Hotline to report the failure. The failure mileage was approximately 146,000.