2011 FORD EXPLORER Complaints

The contact owns a 2011 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure.

The contact owns a 2011 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V301000 (Structure) in February 2024. The contact had been calling a dealer for several months but was informed that parts were not yet available. The manufacturer was contacted for parts availability and was informed that parts were anticipated by April 2025. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact had not experienced a failure.

The contact owns a 2011 Ford Explorer. The contact stated that while driving at an undisclosed speed, the A-pillar trim on both sides of the windshield started to detach. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The vehicle was taken to the dealer, where it was determined that the A-pillar trims needed to be replaced. The dealer informed the contact that the parts for the repair would not be available until December. The vehicle was not repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The approximate failure mileage was 120,000.

The contact owns a 2011 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The contact stated that upon further inspection, the front driver’s side and passenger’s side A-pillar trims were loosened. The contact used super glue to perform a temporary repair. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was approximately 120,000.

Safety Recall 24S02/NHTSA Recall 24V031, this recall hasn’t been fixed until now. The part has been on back order since 2024. It just seems like there’s no solution, it’s always been back order, and I was always advised to call and check back. This has been an ongoing issue, since the recall came out.

The contact’s daughter owns a 2011 Ford Explorer. The contact was informed by his daughter that while driving at various speeds, the vehicle lost power steering functionality. During the failure, the vehicle had to be turned off and restarted to regain power steering functionality. On another occasion, the vehicle lost power steering functionality; however, after a restart, the vehicle failed to regain power steering assist functionality. The vehicle was taken to the dealer and the rack and pinion was replaced; however, the battery failed afterwards. The vehicle was repaired but the failure persisted. The vehicle was taken to the dealer approximately three times. The vehicle was not repaired again. The manufacturer was informed of the failure, and a case was opened. The manufacturer referred the contact to the NHTSA Hotline to report the failure. The failure mileage was unknown.

I’m the original and only owner of a 2011 Ford Explorer (VIN [XXX]). Although Ford Recall 14S06 (NHTSA 14V-286) was marked complete by AutoNation Ford of Bellevue, I’m now experiencing the same issue: loss of power steering assist while driving, which creates a safety hazard. On July 29, 2025, a certified DTC scan at Pierre Ford of Seattle revealed three Power Steering Control Module (PSCM) codes: U3000:49, U3000:72, and U3000:96. These codes are explicitly listed in Ford’s own bulletin (RCMN-14V286-7022) as qualifying for steering gear replacement under Customer Satisfaction Program 15N01, which Ford issued as an extension of Recall 14S06. Despite this, Ford denied the dealer’s request to perform the repair, citing that the CSP period had ended. However, Ford’s bulletin states that repairs should still be approved via SSSC request if DTCs are present — which they are. I believe Ford is failing to honor its own published recall repair procedure. This is not wear-and-tear; it is a continuation of a known safety defect. The steering intermittently becomes difficult to control — especially at low speeds — putting my family and others at risk. I’m requesting NHTSA investigate Ford’s denial of valid repair claims tied to Recall 14S06/15N01 and hold them accountable for unresolved safety issues. Documentation available upon request. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2011 Ford Explorer. The contact stated that while attempting to make a right turn at 20 MPH, the power steering assist failed to operate as needed with the "Steering Assist Fault Service Required" message displayed on the instrument panel. The contact stated that her left arm had been fractured before the failure and that the loss of power steering assist almost caused a crash. The contact had the vehicle towed to a mechanic and was provided information on NHTSA Campaign Number: 14V286000 (STEERING). The mechanic linked the failure to the recall and referred the contact to the dealer for assistance. The dealer and the manufacturer informed the contact that the VIN was not included in the recall. The manufacturer referred the contact to the NHTSA Hotline to report the failure. The vehicle was not repaired. The failure mileage was unknown.

When the vehicle is put in reverse, the backup camera blacks out and if it comes back on, the picture is reversed horizontally. This is causing a hazard when backing up as the camera shows what's actually on the left side to be on the right and vice versa. There are many recalls for the same complaint of Ford's back up system, yet nothing has been addressed for the 2011 model. Thank you!

The contact owns a 2011 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The contact stated that while driving at various speeds, the front driver’s side A-pillar trim became loosened and was temporarily repaired using tape. In addition, the contact stated that the sealant on the driver's side A-pillar trim was deteriorating. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The failure mileage was approximately 105,000.