2011 FORD EXPLORER Complaints

Car has a history of showing a P07AE-09 code in the power steering control module. When the code logs in the computer the car loses power steering assist while driving causing the steering to be hard to turn. Upon researching the cars recall work we seen that the car had the power steering control module software updated but no steering gear changed. My wife and children ride in this car and I'm afraid that this is going to cause a serious accident.

I am reporting a serious safety concern involving my 2011 Ford Explorer, VIN [XXX]. After recently filling the vehicle with fuel, I went to drive it and received a “Power Steering Assist Fault” message on the dashboard. The vehicle then lost power steering assistance, making the steering extremely difficult and requiring significantly more effort to control. The vehicle was inspected by a repair shop, and I was advised that the power steering/steering gear requires replacement at an estimated cost of $2,126.43. Because of the loss of steering assistance, I believe the vehicle is unsafe to drive and presents a serious safety risk, particularly during turns or emergency maneuvers. I understand that Ford previously recalled certain 2011–2013 Ford Explorers under NHTSA Recall 14V-286 (Ford Recall 14S06) for a defect involving the electric power steering gear that could result in loss of power steering assist. The symptoms I am experiencing appear very similar to the defect described in that recall. My vehicle does not appear to be covered by the existing recall based on its VIN. I am requesting that NHTSA review my vehicle and this failure to determine whether it should be included in the recall or whether additional action is warranted. I can provide the VIN, repair estimate, diagnostic information, photographs, and any other documentation needed. Thank you for investigating this potentially dangerous safety defect. Sincerely, [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The power steering has fully stopped working , the car cannot be steered, this started to happen on the road, I had to steer the entire weight of the car myself, at fast speed it was difficult but not impossible, at slow speed and zero speed or while the vehicle is stationary it was impossible or unmovable to steer. there were no warning lamps about this, the Ford dealer has not detect this in my vehicle's previous recall, further vehicle has two more recalls this year, that have been cited this year by the dealer. this needs to be addressed on their recalls because this can cause a very severe problem on the road

On Friday 7/24/2026, I was driving and all the sudden my steering went out. Dash flashed No Power Steering Assist / AdvanTrac System Fail. I pulled over immediately to turn around & get home with zero power steering. The amount of strength to steer/control was extreme. To turn was almost impossible. I took my car to Ford AutoNation on Arapahoe in Centennial on 7/27/26, they ran full diagnostics & it came back that the car suffered a hard internal failure (DTC U3000) of the electronic Power Steering Control Module, creating an immediate, dangerous loss of steering assist while driving. This vehicle was subject to Federal Safety Recall 14S06 (NHTSA Campaign 14V286000). According to official Ford OASIS data, Ford attempted to remedy this safety defect in 2014 using a software reflash shortcut (Labor Code 14S06A) rather than replacing the physical defective hardware. I have a text (via their service dept) from the service manager as well stating "it was a reflash" when I asked which labor code was done under the 14S06; "was it the software reflash or the full rack replacement?". I have a formal case with Ford Corporate created 7/31/26, and have that number as well. IBecause Ford's software patch completely failed to prevent the component's internal hardware failure, the original federally mandated safety defect remains active, unresolved, and dangerous in this chassis. Ford Corporate is refusing to honor the recall remedy because the vehicle is past an arbitrary 10-year limit on their internal customer satisfaction extensions, violating the permanent nature of safety recalls. I stated I would be filing with the NHTSA and they pushed my information on to the Safety Auto Office on 7/31/26.

The contact owns a 2011 Ford Explorer. The contact stated that while attempting to start the vehicle, the message "Power Steering Assist Fault" was displayed and the vehicle failed to start. The contact stated that the failure reoccurred after starting the vehicle, and the steering wheel locked up. The dealer was contacted, but the vehicle was not diagnosed or repaired. The contact related the failure to NHTSA Campaign Numbers: 14V286000 (Steering) and 14E001000 (Steering); however, the VIN was not included. The manufacturer was not contacted. The failure mileage was approximately 140,000.

The contact owns a 2011 Ford Explorer. The contact stated that while driving 25 MPH, the steering wheel became difficult to turn to the left or the right. The contact stated that while depressing the brake pedal, there was an abnormal rumbling sound coming from the vehicle and the steering wheel started shaking. No warning light was illuminated. The vehicle was repaired under NHTSA Campaign Number: 14V286000 (STEERING); but the repair failed to fix the vehicle. The contact stated that the failure had occurred after the recall repair. The manufacturer was not notified of the failure. The failure mileage was 199,455.

The pillar covers fell of the vehicle when driving last week. Both plastic covers are on the side of the interstate. I was told and found there is a recall for the clips on these covers, but when I searched, they are not listed for this vehicle. There appears to be an issue with this recall and the explorer.

The contact owns a 2011 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the dealer and manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact stated that the trim piece was almost detached. The vehicle was not repaired. The failure mileage was unknown.

While stopped at a stop sign my engine suddenly died, before restarting a low oil pressure light came on but went out immediately. I was approximately 40 miles from home when I got to my destination. The car was showing no signs of issues, no warning lights or errors. When I went back out to start it and head home it would not start. I had to pay additional expense beyond my insurance road side coverage due to the distance. I have had an independent mechanic going over the vehicle since it died. Starter has been replaced because it appeared to be the issue. (the original was bad) Once replaced while attempting to start it he found out the engine had locked up. I bought the vehicle March 30, 2026 & this happened on June 10, 2026. The vehicle had 132,344 miles on it when bought and 135,716 when it seized up. After looking through other reports I have found this to be a reported issue.

I contacted chapman ford in phila to have the recall corrected and it has been almost 2 yrs and no parts or follow up. They told me for months that the parts were backordered. My trim is loose and the rubber around my windshield almost gone. I also contacted ford main and was told an advisor would follow up and they did not.