2016 FORD EXPLORER Complaints

Roof rail on passenger side flew off. Clips were broken but some clips still in place. This part is in a recall for other 2016 Explorers but was excluded on models with the chrome roof rail. The rail is the same plastic as the recalled vehicles and should have been included. See Ford 21S22 / 20N11. The chrome is not structural. The drivers side will eventually detach too as it is loose. It will fly off at some point. I already had silicone on the rail and it does not hold. These should be recalled as the plastic is the same as the rails that were included in the recall.

The driver side B pillar applique is loose and I fear it may become completely dislogdged or blow off during high speed highway travel and cause some sort of accident. This recall has been open since May of 2025 and Ford Motor Company still has no remedy or fix for it yet. In addition -and not included in this recall- the driver side A piller applique on the windshield has also come loose and may also fly off during travel. This too should be fixed. Can you help?

The current b-pillar trim issue that Ford hasn't remedied. In October 2025 my b-pillar broke off my car while driving, shatteringagainst the car behindme. When it did that the wiring immediately caused my liftgate to think it was open and I have not been able to access that back of my suv since then. In order to do so a piece in the door had to be removed and I have to crawl thru the vehicle to manually find a switch to release it. This has gone on for 5 months with me being unable to use the entire back half of the vehicle. If I open it manually it risks not getting shut fully and popping open. It's ridiculous it has taken this long for a fix.

The contact owns a 2016 Ford Explorer. The contact received notification of NHTSA Campaign Number: 25V347000 (Structure); however, the part for the recall repair was not yet available. The vehicle was taken to the dealer, but was not diagnosed or repaired. The dealer confirmed that the parts were not yet available. The manufacturer was made aware of the issue. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact had not experienced a failure.

The contact owns a 2016 Ford Explorer. The contact had received notification of NHTSA Campaign Number: 24V031000 (Structure); approximately 2 years ago. The contact stated that the A-pillar trims on the driver's and passenger’s side were loose. The contact used caulk to temporarily hold the trims in place. The contact called a local dealer and the manufacturer several times and was informed that the part was not yet available for the recall repair. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The failure mileage was approximately 80,000.

The Passenger side A-Pillar cover detached from the vehicle and was recovered on the road right of way.

The contact owns a 2016 Ford Explorer. The contact received notification of NHTSA Campaign Numbers: 24V031000 (Structure) and 25V347000 (Structure); however, the parts to do the recall repairs were unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated that the B-pillar trim on the rear driver’s side had started to detach from the vehicle. The vehicle was taken to the dealer, and a replacement trim was sold to the contact; however, it was not the part approved for the recall repair. The vehicle was not repaired due to the replacement part not being covered under the recall. The manufacturer was made aware of the issues and confirmed that the part was not yet available. The failure mileage was approximately 130,000.

The contact owns a 2016 Ford Explorer. The contact received notification of NHTSA Campaign Number: 24V031000 (Structure); however, the part to do the recall repair was not yet available. The contact had received the notification 2 years prior. The contact stated that while driving approximately 75 MPH on the highway, the A-pillar trim clip detached on the passenger’s side of the vehicle. The A-pillar trim struck the vehicle behind, but had not cause any damage to the vehicle. The vehicle was taken to the dealer, where it was confirmed that the replacement part was still not available. The manufacturer was not notified of the failure. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The approximate failure mileage was 155,000.

The contact owns a 2016 Ford Explorer. The contact stated that while driving approximately 30 MPH, the driver's side roof rack cover panel ejected from the vehicle and made contact with a second vehicle. The driver of the second vehicle swerved to avoid the airborne projectile and crashed into a third vehicle. During the incident, no damage to the vehicles or injuries to the occupants in either vehicle were reported. No police report was taken. The local dealer was informed of the failure. The contact was informed that the VIN was not included in the NHTSA Campaign Number: 21V316000(STRUCTURER). The contact indicated that the vehicle had experienced the same failure listed in the recall. Also, the front driver's door exterior A-Pillar Trim had detached and was snapped back into position, and both the driver side and passenger side exterior B-Pillar Trim had come loose. The vehicle was not repaired. The manufacturer was not notified of the failures. The failure mileage was 70,000.

The contact owns a 2016 Ford Explorer. The contact received notification of NHTSA Campaign number: 25V347000 (Structure); however, the part to do the recall repair was not yet available. The contact stated that while the vehicle was parked in the rain, water leaked inside the vehicle. There was water accumulating on the floor on the driver’s and the passenger’s side of the vehicle. The contact was unsure of where the water was entering the vehicle. The contact stated that on a separate occasion, while driving 60 MPH, the driver's side A-pillar trim and the passenger's side A-pillar trim had detached from the vehicle. The local dealer was not contacted. The vehicle was not repaired. The contact was unsure if the water was entering from the A-pillar trim. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The failure mileage was unknown.