2018 FORD EXPLORER Complaints

My 2018 Ford Explorer XLT 3.5L that we bought brand new from Bob Bell Ford/Glen Burnie Maryland had a water pump failure at only 72,344 miles, this was a safety concern when driving down the road that put us & others at risk. The only indication was dashboard warning that said (Engine coolant over temperature)This failure happened while taking daughter to college on 8/21/26 We had to get towed to independent service center 175 miles away & repaired at the cost of $2900.00.

At 30 to 40 mph, there is a shuttering or stutter in the transmission during acceleration. This is a problem when trying to enter traffic on the expressway (Interstate or other lanes of traffic). I have taken this to the dealer and they indicate that the transmission needs to be replaced. They indicate that there is metal shavings in the trans fluid. This is in line with similar Ford SUV and transmission problems. At this point in time there is no recall, but this matter should be address as it is in line with similar Ford transmission failures.

my transmission, like several others' I have spoken to, is about to lose reverse. The incident happened when i encountered a problem on the road and was UNABLE to put my car in reverse. I have taken it to several dealerships and nothing is ever done, it's been going on for years. Well now it's become more of a safety hazard since I do transport my children in the car.

The contact owns a 2018 Ford Explorer. The contact stated that while driving 55 MPH, the vehicle veered off the road toward the passenger’s side. The contact turned the steering wheel; however, the vehicle became uncontrollable, crossed into the opposite lane, and drove into a ditch. The vehicle was driven on a back road to the residence and was then towed to a dealer. The vehicle was diagnosed with a rear toe link failure associated with NHTSA Campaign Number: 26V101000 (Suspension). The VIN was included in the recall. The vehicle was being repaired. The manufacturer was notified of the failure but denied reimbursement for towing expenses.

IN SOME OF THE AFFECTED VEHICLES, IT MAY BE POSSIBLE THAT SOME OF THE EXTERIOR A-PILLAR APPLIQUE TRIM CLIP ATTACHMENTS ARE NOT PROPERLY ENGAGED DUE TO IMPROPER ASSEMBLY OR REPAIR. IF THIS OCCURS, THE A-PILLAR APPLIQUE TRIM, WHICH BORDERS THE RIGHT AND LEFT SIDE OF THE WINDSHIELD, MAY BE LOOSE, MISSING OR BECOME DETACHED. Safety Risk AN EXTERIOR A-PILLAR TRIM PART THAT DETACHES WHILE DRIVING CAN CREATE A ROAD HAZARD FOR OTHER ROAD USERS, INCREASING THE RISK OF A CRASH.

The contact owns a 2018 Ford Explorer. The contact received notification for NHTSA Campaign Number: 24V031000 (Structure); however, the parts to perform the recall repair were not yet available. The contact stated that in April, the vehicle was taken to a dealer for the recall repair. Although the recall database stated that the parts were available, the dealer advised the contact that the parts were unavailable. The dealer instructed the contact to return at a later date for the permanent repair; however, the dealer marked the recall as completed in the system without performing the repair. The contact had secured the trim pillar to the body of the vehicle using electrical tape. The vehicle was not repaired. The manufacturer was notified of the failure; however, no assistance was provided. The failure mileage was 140,852.

The contact owned a 2018 Ford Explorer. The contact stated that while driving at various speeds, a message displayed on several occasions instructing the driver to pull over and shut off the vehicle because the battery would shut off. Upon pulling over and turning off the vehicle, the vehicle failed to restart and required towing on several occasions. The vehicle was towed to the dealer, where a wiring failure was determined. The dealer attempted to repair the vehicle, but the failure persisted. While driving approximately 25 MPH, the infotainment screen turned blank, and a large wrench warning light illuminated. The vehicle independently accelerated, became uncontrollable, and drifted out of the intended lane. The contact regained partial control as the vehicle continued accelerating toward an embankment. The front driver's side wheel was caught in the gutter of the embankment, causing the driver's side of the vehicle to crash into the embankment. The contact's head struck the driver's side window, which was fractured, allowing branches to enter the cabin. The driver's side curtain air bags deployed for the second and third rows but failed to deploy properly for the front driver's side, causing the contact to hit her head a second time on a sail that had deployed. The contact became pinned between the driver's seat and the driver's side window area, with her hair caught and pulled in the seat belt pretensioner, causing significant pain. EMT personnel cut the contact's hair to free the contact from the vehicle. The contact was assisted from the vehicle, fitted with a neck brace, placed on a stretcher, and transported to the hospital. The contact sustained head and neck injuries, as well as a concussion. Additionally, the contact suffered from pre-existing auto-immune lumbar stenosis L1–L5, osteoarthritis L5–S1 with bone-on-bone contact, and sacroiliac joint disease, and experienced increased pain after missing a scheduled appointment for sacroiliac joint injections due to the crash. A Police report was filed but

Failure in the adhesion of the dash cover and is available for inspection. My safety is at risk due to vision impairment from the white padding reflecting on the inside of the car window. I have not taken my vehicle to a dealer yet. No inspection has happened. The first bit of white in my vision I thought was a reflection of the hood of my car because my car is white. And I thought why as of recently is my view through the windshield all of a sudden being impaired every time I drive, I thought maybe it was sun direction or something like that. Then it worsened and the white gap became worse which is making it more difficult to see through my windshield. And recently I noticed the cause was the padding under the dash cover and the sun reflecting off of it is reflecting on the inside glass of the car.

I purchased this 2018 Ford Explorer from Speedway Motors in Murfreesboro, TN back in July 2026. Within a month I notice that the windshield was whistling. I took it back and they told me that it was a recall on the "A pillar exterior trim." I contacted the Murfreesboro Ford dealership and was told that the Ford dealership in Franklin had done a recall "check" in 2024 and it "passed" the recall. They did NOT replace seal the parts. Now two years later, the recall is supposedly not considered "open" by Ford Manufacturing. When I contacted their customer service to ask how a recall can be closed or ignored, they simply will not answer the question. My understanding is that a recall technically can not be "closed" if it a safety issue. In this case, the trim pieces come loose and become a road hazard. The pieces are not attached correctly or completely and the adhesive comes apart. This allows the trim and even the windshield to come off while driving down the road. There are hundreds of complaints and threats of class action lawsuits on line where people had to wait two years for the dealership to get the parts and replace them. Some people ended up ordering the trim pieces from Amazon and doing the work themselves. I do not feel it is my responsibility to have to fix this issue when clearly it is a safety recall by Ford. They should be held responsible for the repairs. If the windshield or trim were to come off and damage another car or injure someone, I would be held responsible. I am able to provide photos or bring the vehicle to any office for inspection if requested. I am happy to help in any way. Especially if I am able to get a resolution with this situation. I do not have money to fix this and do not want to report it to my insurance. Date of recall was January 2024 as far as I can tell. It was checked by Franklin Ford also in 2024.

The contact owns a 2018 Ford Explorer. The contact stated that upon taking the vehicle to the dealer for service, the contact was made aware of NHTSA Campaign Number: 26V101000 (Suspension). The contact agreed to have the recall repair performed. The contact stated that approximately one month later, the contact discovered that the tread on the rear tires was shredding along the inner sidewalls. The vehicle was taken back to the dealer, and the tire failure was confirmed; however, the dealer stated that the work performed on the vehicle was not associated with the tire failure. The vehicle was later taken to an independent mechanic, and the contact paid out-of-pocket for two new tires and a rear wheel alignment. The contact stated that after the repair, the OBD2 scanner indicated that the rear wheel alignment was not properly performed. The contact stated that due to the failure, the tread on the new tires had started to shred. The manufacturer was notified of the failure and provided a case number. The vehicle was not repaired. The failure mileage was approximately 102,000.