2014 FORD F-150 Complaints

The truck will jump from sixth gear to first gear, or will go from first gear straight to fifth and be stuck in fifth , or be stuck in first, the truck will randomly take off on its own or come to a screeching stop on highways going 60 mph, the gear indicator will stop working, alongside all other gauges on the dash, such as gas mileage, RPM, speedometer, heat and oil gauge will all stop working, when the vehicle is pulled over and shut off, it will start normal and run normal for a short amount of time.

The contact owns a 2014 Ford F-150. The contact stated that while driving approximately 50-70 MPH, the vehicle decelerated to 0. The contact stated that the rear wheels locked up and the vehicle jerked and vibrated. The contact shifted to park and back into drive. There were no warning lights illuminated. The contact stated that on another occasion while driving at an undisclosed speed, the vehicle lost motive power and stalled. The vehicle failed to shift into gear. The vehicle was taken to the local dealer but was not diagnosed or repaired. The manufacturer was contacted and referred the contact to the NHTSA Hotline. The approximate failure mileage was 127,000.

RE: Safety Recall 16S24 Why is my 2014 F-150 not covered under Ford's safety recall (16S24) of a defective brake master cylinder? 16S24 covers defective master cylinders for the 3.5L V-6 Ecoboost engine, but not the 3.7L V-6 engine. Upon further research, it appears that both the aforementioned engines use the same master cylinder. See Motorcraft part no. BRMC203 (Brake Master Cylinder). According to Ford, the master cylinders' rear seal fails, thus leaking brake fluid into the attached brake power booster which causes pedal fatigue and possible loss of front brakes. My F-150 has a 3.7L V-6 engine, which is not covered under the recall. However, my F-150 is exhibiting the same master cylinder failure as is referenced in 16S24. My master cylinder has leaked into the power booster and the vacuum line attached the power booster has siphoned all brake fluid into the engine (approximately 60 ounces). The engine then expelled said brake fluid into the exhaust system causing white smoke to emit from the tail pipe. Please contact me at [XXX] [XXX] INFORMATION Redacted PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6).

When the battery dies and the vehicle doors are locked you can not unlock the door with the physical key. Doors will not open. I am thankful I was not inside or I would have to break the window to get out.

The contact owns a 2014 Ford F-150. The contact stated while driving 45 MPH, the vehicle went into LIMP Mode and decelerated. The contact stated no warning light was illuminated. The contact was able to park on the side of the road for 10 minutes and restarted the vehicle and continued driving to her destination. The contact stated that on one occasion after shifting into reverse(R) the vehicle failed to respond. The contact turned off and restarted the vehicle and shifted into other gears and back into reverse(R) and continued driving to her residence. The contact stated on another occasion while the vehicle was at a traffic light, the vehicle went into LIMP Mode and decelerated. The contact stated that the Maintenance warning light was illuminated. The contact was able to continue driving but was unable to accelerate over 30-35 MPH. The contact took the vehicle to Auto Zone but was unable to diagnose the failure. The vehicle was not repaired. The contact continued to drive to her residence. The contact stated an independent mechanic came to her residence and changed the engine oil and the engine oil filter. The contact took the vehicle to the local dealer and made them aware of the failure. The vehicle was not diagnosed or repaired. The contact called the second local dealer: Crossroads Ford of Prince George (4500 Whitehill Blvd, Prince George, VA 23875: (804) 862-1000), and made them aware of the failure. The manufacturer had been informed of the failure. The failure mileage was approximately 100,000.

The contact owns a 2014 Ford F-150. The contact stated that while attempting to stop the vehicle, the brake pedal was depressed and extended to the floorboard. The vehicle failed to stop immediately, causing the braking distance to be extended. The cause of the failure was not yet determined. The contact stated that the vehicle was previously serviced, and the brake master cylinder and vacuum pump were replaced. The manufacturer was notified of the failure. The local dealer was not yet contacted. The failure mileage was 52,000.

This has happened twice now. Driving to work accelerating after a red light and the truck losses all power, but stays running. To get it to operate normal you have to pull over shift into park, turn the truck off and wait a couple of moments. The truck will retire and drive like nothing happened. Trick has 78k miles and always maintained at local ford dealer

The contact owns a 2014 Ford F-150. The contact stated the vehicle was making an abnormal noise while starting the vehicle. The contact stated no warning light was illuminated. The contact took the vehicle to the local dealer, where it was diagnosed with needing the cam phaser to be replaced. The vehicle was not repaired. The manufacturer had been informed of the failure. The failure mileage was approximately 110,000.

The contact owns a 2014 Ford F-150. The contact stated while driving 15 MPH and approaching a stop light, the contact depressed the brake pedal however, the vehicle failed to slow down properly. The contact desperately depressed the brake pedal, and the vehicle came to a complete stop. The vehicle was taken to the dealer and the dealer stated that the vehicle had experienced the failure stated in the NHTSA Campaign Number: 20V332000 (Service Brakes, Hydraulic) however, the VIN was not included in the recall. The vehicle was taken to an independent mechanic and the mechanic replaced the brake master cylinder; however, the failure reoccurred. The manufacturer was not contacted. The failure mileage was 80,000.

While driving down the highway, the transmission line rapidly failed and caused the vehicle to stop the motor. This was a sudden and rapid loss of transmission fluid and we were very lucky to be able to control the vehicle over to the side of the road. There were ZERO indicator lights to indicate a transmission fluid leak or issue prior to this sudden issue. When researching online, a Ford Certified Technician confirms that there is one VERY specific place on the transmission lines that ALWAYS breaks on the 6R80 transmissions. It is where the line bends upward to an aluminium quick connect that has failed and does fail on a LOT of these vehicles. Photographic evidence sent to me by my mechanic proved that my lines failed in the exact same place. The video of this issue that was posted by a Ford technician can be found here: https://www.youtube.com/watch?app=desktop&v=xk8tBqh0Q7Y This is a huge safety issue as there is no warning before this fitting fails entirely. We were extremely lucky we were able to get to the side of the road safely.