2009 FORD F-150 Complaints

This vehicle has been a lemon ever since we purchased it new. To start the 3rd brake light would always leak during rain and ruined the headliner took it back to andy mohr ford were we purchased approx 25 times for this issue. Then we have had oil leaks about a year after purchase and it still leaks. Third the fender wells are rusting. And also all the lights on the dash are lit because the computer board failed. To date the truck only has 147k miles. This truck has been a lemon the whole time we have owned it and i am tired of sinking money in this junker. Ford needs to be held responsible for every vehicle off there assembly line.

The contact's son owned a 2009 Ford F-150. The contact stated that while approximately 10 MPH, he observed smoke emanating from the glove box and the check engine warning light illuminated. The contact steered the vehicle to the side of the road, and he observed a small fire by the accelerator pedal. The contact exited the vehicle and opened the hood. The contact stated that flames erupted from the engine compartment when the hood was opened, and he called 911. The fire department arrived and extinguished the fire. A police report was taken, but the info was not available at this time. The vehicle was towed to a tow lot where it was deemed totaled. There were no injuries. The manufacturer was not notified of the failure. The failure mileage was approximately 201,000.

The contact owns a 2009 Ford F-150. The contact stated that while driving at an undisclosed speed, the brake pedal was depressed; however, the vehicle failed to stop as intended. Additionally, the ABS and TPMS warning lights were illuminated. The contact stated that the vehicle slowed down; however, the brake pedal needed to be depressed to the floorboard to stop the vehicle. The vehicle was taken to Auto Zone and O’Reilly’s where it was diagnosed with a failed ABS module. The contact was informed that the ABS module needed to be replaced; however, the vehicle was not repaired. The contact stated that it was a known failure for similar vehicles. In addition, the contact referenced an unknown recall; however, the VIN was not included in a recall related to the failure. The contact stated that it was difficult to locate the part needed to repair the vehicle. The manufacturer was not made aware of the failure. The failure mileage was approximately 129,000.

The contact owns a 2009 Ford F-150. The contact stated while 45 MPH and depressing the accelerator pedal, the vehicle failed to respond as intended. The contact pulled over to the side of the road and waited for towing assistance to tow the vehicle to the residence. An independent mechanic was contacted. The vehicle was taken to the independent mechanic and was diagnosed with an ABS module failure. The contact was informed that the ABS module needed to be replaced. The vehicle was not repaired. The contact related the failure to the Customer Satisfaction Program: 09C07 (Brake Stop lamp Switch Adjustment); however, the VIN was not included in the Customer Satisfaction Program. The manufacturer was notified of the failure but offered no assistance. The contact stated that the failure persisted since November 2022. The contact was referred to the NHTSA Hotline for assistance. The failure mileage was 183,000.

My pickup truck at only 23 thousand miles in the engine, it's module went bad and brake and ABS lights came on on the dashboard. I took the car to the dealer and they said that I have to replace it and they are charging me 5,400 dollars. They said that some 2009 F150 module were bad from factory, but there's not recalls for it to be fixed by them.

The contact owns a 2009 Ford F-150. The contact stated that the engine warning light was intermittently illuminated. The contact stated while driving at undisclosed speeds and making sharp turns, the vehicle stalled. The contact was able to pull over to the side of the road and depressed the brake pedal until the vehicle responded as needed. The contact stated that the failure had been recurring while making sharp turns and while coming to a stop at traffic lights. The vehicle was taken to the dealer, and the contact was informed that the failure could not be duplicated. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was approximately 60,000.

My airbag warning light came on. The dealer found 2 codes and replaced the parts. When they were done another code came up for weight sensor which is the seat frame. I was told that the part has been discontinued. I have searched for an aftermarket part with no luck. I purchased a used seat but it was not compatible I have a16 year old truck. The service life is as I understand it is 14-20 years. I don’t understand how the manufacturer can stop making safety parts while the vehicle is still in its service life

The contact owns a 2009 Ford F-150. The contact stated while starting the vehicle, the engine rattled. No warning light was illuminated. The vehicle was taken to the dealer, but the dealer was unable to duplicate the failure. The failure recurred. The vehicle was then taken to an independent mechanic, who diagnosed that the cam phasers needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure and a case was opened. The contact was advised to file a complaint with the NHTSA Hotline. The failure mileage was approximately 115,000.

The contact owns a 2009 Ford F-150. The contact stated that while his son was driving at approximately 25 MPH, the steering wheel detached. The driver was able to reattach the steering wheel and safely pull over. There were no warning lights illuminated. The contact called the local dealer, who referred him to an independent mechanic for assistance. The vehicle was towed to an independent mechanic, who replaced the standard clockspring in the steering wheel, part number CSP200. The manufacturer was contacted, and the contact was informed that the vehicle was too old, and no assistance was provided. The failure mileage was approximately 128,000.

AC electric wiring becomes hot and only blows at 1 speed, also with time has become corroded diplaying a live open wire under passanger area, seems it is the following Block Heater Cable Splice Connector May Corrode Prolonged corrosion of the connector may cause a resistive short, overheating or melting the wiring and increasing the risk of a fire. safety recall 19V048 below Also I can not find an open recall for the following issue my vehicle still has now that I researched it, it is a recall and my ford has not been fixed inregards to the following, Block Heater Cable Splice Connector May Corrode THE INTERIOR DOOR HANDLE HOUSING EMBOSSMENT RETAINING THE INTERIOR DOOR HANDLE SPRING MAY FRACTURE DURING NORMAL USAGE RESULTING IN INSUFFICIENT SPRING FORCE TO RETURN THE HANDLE TO THE FULLY STOWED POSITION.