2000 FORD F-350 Complaints

I HAVE AN F350 DIESEL YEAR IS 2000. IN 2003 I HAD ENGINE-SENSOR FAILURE. FORD SAID IT WAS THE CAM SENSOR AND CHARGED APPROX. $400 TO REPAIR. THIS STARTED HAPPENING AGAIN IN FEB. 2006. I HAD PRIVATE REPAIR SHOP REPLACE CAMS, STILL STALLS,TOOK TRUCK TO FORD REPAIR, REPLACED GLOWPLUGS AND CHARGED SEVERAL HUNDRED DOLLARS, STILL HAVING TROUBLE. SEEMS TO BE WORSE IN MORNING AFTER NON USE FOR 12 HOURS. *NM

DT*: THE CONTACT STATED SINCE PURCHASE THE VEHICLE HAS A SHIMMY IN THE FRONT END PASSENGER SIDE. THIS OCCURS AT 35-45 MPH, WHEN THE TIRES HAVE AT LEAST 10,000 MILES WORTH OF WEAR. THE TIRE BRAND HAS BEEN CHANGED MULTIPLE TIMES AND THE TYPE OF TIRE DOES NOT AFFECT THE PROBLEM. THE VEHICLE HAS NOT BEEN TO A DEALERSHIP OR MECHANIC, BUT THE CONTACT REPLACED THE TIE ROD END TWICE, CENTER LINK, AND SPINDLE ON THE PASSENGER SIDE. THESE EFFORTS HAVE NOT CORRECTED THE PROBLEM.

FRONT BRAKES, FADE AND EXTENDED STOPPING DISTANCE; THERE ARE FLOAT PINS WHICH KEEP THE CALIPERS CENTERED OVER THE ROTORS . THEY HAVE SEIZED UP. THE VEHICLE BREAKING WAS BECOMING SLUGGISH. REPEATED INSPECTION OF THE FRONT BRAKE PADS INDICATED THEIR CONDITION TO BE GOOD. EVENTUALLY I DECIDED TO ORDER NEW CALIPERS WITH PADS. THESE UNITS CAME WITH 'NEW FLOAT PINS'. MUCH TO MY SURPRISE MY CALIPERS WERE GOOD BUT THEY WERE LOCKED IN POSITION BECAUSE OF THE SEIZED FLOAT PINS. WHEN THE BRAKES WERE APPLIED THE PRESSURE WAS TO THE INSIDE PAD ONLY GREATLY LENGTHENING THE STOPPING DISTANCE. AS THE PROBLEM CAME ON GRADUALLY I DIDN'T REALIZE HOW POOR THE BRAKING HAD BECOME UNTIL I REBUILT THE SYSTEM. THE PINS WHICH NEED TO SLIDE FOR PROPER BRAKING HAVE LITTLE RUBBER BOOTS TO KEEP OUT ROAD DEBRIS AND WATER. THESE BOOTS WERE NOT SEATED ON THE GROVE ON THE ORIGINAL CALIPER BODY. AS THE SYMPTOMS COME ON GRADUALLY THERE ARE OTHER VEHICLES OUT THERE WITH SEVERELY DEGRADING BRAKE PERFORMANCE. CURIOUSLY THE REPLACEMENT CALIPERS HAD A BAG OF SPARE PARTS. *NM

DT*: THE CONTACT STATED WHEN THE BRAKE PEDAL WAS DEPRESSED; THE BRAKE PEDAL WENT TO THE FLOOR. THE VEHICLE WAS TAKEN TO THE LOCAL DEALERSHIP FOR INSPECTION AND REPAIR. THE SERVICE PERSONNEL DISCOVERED THE BRAKE LINE WAS FRACTURED DUE TO CORROSION.

2000 F350 TIRE BLEW OUT. *TS WHEN THE TIRE BLEW OUT, THE CONSUMER LOST CONTROL OF THE VEHICLE, WENT THROUGH A MEDIAN INTO A DITCH AND SUBSEQUENTLY THE TRUCK TURNED OVER. *JB

WHEN UP-SHIFTING GEARS, THE SERVICE ENGINE LIGHT WOULD ILLUMINATE AND ACCELERATOR IS NON-RESPONSIVE AS ENGINE IDLES AROUND 1K RPM CAUSING LOSS OF MOMENTUM. AFTER A FEW SECONDS, THE ACCELERATOR CAN BE USED TO INCREASE SPEED, BUT DEPRESSING THE CLUTCH STARTS THE CYCLE OF NON-RESPONSIVE ACCELERATOR ACTION ALL OVER. THE TRUCK HAS DIED ON CURBS, IN INTERSECTIONS, AND WHILE GETTING ONTO ON RAMPS. FORD HAS REPLACED SOME MAGNETS WHICH JUST DELAYED THE ACTION FOR A FEW WEEKS. THE LONGER IT GOES WITHOUT REPAIR, THE WORSE IT BECOMES. *NM

DT: THE CONTACT SAID THE VEHICLE WAS SHUTTING OFF WHILE DRIVING DUE TO CAM SHAFT SENSOR FAILURE. THE ENGINE DIED IN THE MIDDLE OF MAKING A RIGHT TURN. HE ALMOST HIT ANOTHER VEHICLE, TO MISS THE OTHER VEHICLE HE WENT OVER AN EMBANKMENT. AFTER THE INCIDENT THE VEHICLE WAS TOWED TO A FORD DEALERSHIP. THEY DIAGNOSED THE PROBLEM AS THE CAM SHAFT SENSOR. THE CAM SHAFT SENSOR WAS REMOVED AND REPLACED WITH A NEW ONE. THE REPAIR WAS MADE AT THE CONTACT'S EXPENSE AS FORD OFFERED NO FREE REMEDY. *AK UPDATED 12/7/2005. THE CONSUMER REQUEST REIMBURSEMENT FOR THE COST OF A NEW CAM SENSOR AND TOW TRUCK SERVICE (PART # F7TZ12K073-A, SYNCRO 997690). *NM

CPS(CAM POSITION SENSOR) THERE ARE NO EVENTS THAT LEAD UP TO THE FAILURE OF THIS SENSOR. (EXPECT THE SENSOR TO FAIL ANY WHERE BETWEEN 80,000 TO 120,000 MILES)...YOUR FORD 7.3L POWER STROKE ENGINE WILL SIMPLY JUST SHUT DOWN LEAVING YOU WITH NO POWER TO STEER OR STOP YOUR VEHICLE. THE VEHICLE'S ENGINE MAY OR MAY NOT RESTART UNTIL THE FAILED SENSOR IS REPLACED. ONCE REPLACED, THE VEHICLE CAN BE DRIVEN ANOTHER 80,000 TO 120,000 MILES (WHO KNOWS). MANY PEOPLE CARRY A SPARE SENSOR IN THE VEHICLE AS YOU NEVER KNOW WHEN OR WHERE THIS FAILURE WILL OCCUR. *JB

F-350 CAMSHAFT POSITION SENSOR FAILED PREMATURELY (28,000 MILES). ENGINE SHUT DOWN WITH NO WARNING, BRAKES FAILED. ROLLED TO A STOP, THE ENGINE WOULD NOT RESTART. NO TRAFFIC AROUND. FORD REPLACED THE PART UNDER WARRANTY. *JB

ON MY 2000 FORD F350 DIESEL, THE CAMSHAFT POSITION SENSOR FAILED AS I WAS ENTERING THE HIGHWAY. THE ENGINE STALLED AND I HAD NO POWER TO THE ENGINE. THE POWER STEERING AND POWER BRAKES FAILED AND I COULD NOT GET THE TRUCK TOTALLY OFF THE HIGHWAY. LUCKILY A POLICE OFFICER ON THE HIGHWAY PULLED IN BEHIND ME AND STAYED WITH ME WITH HIS LIGHTS ON UNTIL A TOW TRUCK ARRIVED. IT WAS A SCARY SITUATION. THEN I FIND OUT THAT THE PROBLEM IS VERY COMMON, VERY DANGEROUS, AND VERY IGNORED BY THE MANUFACTURER. IF THE POLICE OFFICER WAS NOT THERE QUICKLY, OR IF HE HAD A CALL TO ATTEND TO, SOMEONE COULD HAVE BEEN KILLED. *JB