2018 FORD FLEX Complaints

There's been a recall for the rear backup camera since October of last year. Although there hasn't been any particular incidents, there's been some close calls because the fix is still not available. Any help would be appreciated

Rear passenger door fails to latch properly. The door falls open on left turn.Warnings are unclear or non-existant

The contact owns a 2018 Ford Flex. The contact stated that while attempting to reverse, the rearview camera became inoperable. The contact stated that the rearview camera image would appear blank and other times the camera not available warning message would display. The contact received notification of NHTSA Campaign Numbers: 25V829000 (Structure) and 25V695000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The dealer was not contacted. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The approximate failure mileage was 150,000

Recall has not been remedied, and it has been over six months.I was told it would be remedied by june or ford would be held accountable for compensating for repairs on the.Recall. #25SA9/25v695 The recall addresses the camera for backing up witch is still not functioning in a safety risk.

Wile driving 40 mph, the right rear tire locked up and I had to counter steer aggressively to avoid spinning out and hitting oncoming traffic. The car was flat bed delivered to Ford and they recommended the following repairs. "Control Arm- Rear: rear suspension lateral links. The rear upper and lower control arms not only provide suspension travel but also secure the rear end to the vehicle." "*Tires - 4: passenger rear inner sidewall damaged."

An antifreeze leak is very hard to locate because Ford’s design placed the water pump INside the engine rather than on the OUTside, which would be more the norm. If antifreeze leaks enough, it gets into the oil and the entire engine stands to be destroyed. Our heater quit blowing warm air recently and after intently searching we discovered that we had an antifreeze leak inside of our engine, and antifreeze was slowly leaking out through a weephole in the engine. The water pump had gone bad and needed replacing. The hours required to replace this water pump are intense and they are long. Almost the entire engine needs to be dismantled in order to perform the work. Not only does the pump need changed, but so does the timing chain, hoses, seals, gaskets, tensioners and other engine parts, all at the same time, making this a VERY costly out-of-pocket expense for us elderly people who have long relied on Ford’s standard of doing what’s right by its people. In our research we found that the water pumps in Flex engines are failing, regularly, once the vehicle is close to having 80,000 miles on it. This repair most DEFINITELY should be covered by recall since it is happening so regularly. We have just been forced to pay for this repair on our own and I would like to please ask for your help in recovering what we’ve had to spend. Will you please provide contact information as to where we can reach out for assistance in this matter? Your help is VERY much appreciated! Thank you!

The contact owns a 2018 Ford Flex. The contact received a notification of NHTSA Campaign: 25V732000 (Structure); however, the part to do the recall repair was not yet available. The contact stated that while driving at an undisclosed speed, the front driver-side B-pillar trim with the Security Key pad had detached and almost struck nearby vehicles. The contact stated that she managed to pull over on the shoulder of the road; however, the vehicle independently locked, leaving the occupants on the shoulder of the road temporarily. In addition, the contact stated that while driving at an undisclosed speed on another occasion, the front Passenger-side B-Pillar trims had detached. The vehicle was taken to a local independent mechanic, where it was repaired out of pocket; however, the front Driver-side B-Pillar trim had detached, and upon further inspection, water would intrude through the missing, failed parts. The local dealer was contacted. It was unknown whether the vehicle was diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The manufacturer was made aware of the failure. The failure mileage was approximately 60,000.

The contact owns a 2018 FORD Flex. The contact stated while using the back up camera on the vehicle it ends to shutoff randomly causing a back over prevention issue. The contact received notification of NHTSA Campaign Number: (25V695000 (BACK OVER PREVENTION) however, the part to do the recall repair was not yet available. The local dealer was/was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was 60,000.

The contact owns a 2018 Ford Flex. The contact stated while reversing, the rear view camera displayed a solid green screen. The contact stated that because of the failure, the contact almost crashed into another vehicle. The contact stated that the failure occurred intermittently. In addition, the B- Pillar on the driver's side rear door was detached. The vehicle was taken to the dealer, however the vehicle was not inspected. The contact was informed that the parts were unavailable. The vehicle was not diagnosed or repaired by an independent mechanic or the dealer. The contact received recall notifications: NHTSA Campaign Number: 25V695000 (Back Over Prevention) and NHTSA Campaign Number: 25V732000 (Structurer) however the parts were unavailable. The manufacturer was not made aware of the failure. The failure mileage was approximately 75,000.

The contact owns a 2018 Ford Flex. The contact stated that while attempting to reverse the vehicle, the rearview camera became inoperable and the camera image appeared blurry. The contact received notification of NHTSA Campaign Number: 25V695000 (Back Over Prevention) and 25V732000 (Structure); however, the parts required to complete the recall repairs were not yet available. The dealer was contacted and confirmed that the remedy parts were currently unavailable for the vehicle, although the contact was informed that remedy parts were available for the Mustang models. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The contact stated that the manufacturer had exceeded a reasonable amount of time to provide a remedy for the recall repairs. The approximate failure mileage was 145,000.