2015 FORD FUSION Complaints

While driving car it begins to shaking and unable to accelerate than cuts off, will sometimes restart and can drive but does the same thing again, during this process a wrench symbol and check engine light come on. Had spark plugs replaced the first time, still was doing it. Also the throttle body removed and cleaned continued, so replaced throttle completely it’s been 2 days no issue so far, but the car belongs to my daughter and it happened while she was driving car was purchased used a year ago, this is the first time we had this issue not sure if previous owners experienced same issues.

My 2015 Ford Fusion with the 1.5L EcoBoost engine experienced a complete engine failure due to a coolant intrusion in cylinder 3, which is consistent with Ford TSB 20-2100. In December 2023, I brought the car to the dealership due to rough starting and a non-start issue. No coolant related codes were detected at the time. In May 2025, the vehicle began running roughly and showed codes PO316 and PO303. The dealership diagnosed low coolant and coolant intrusion into cylinder 3, with a rust and fouled spark plug. I believe this is a progressively safety-related engine defect that can lead to sudden loss of power and unsafe driving conditions.

I only have 85k miles on my 2015 Ford Fusion. One day the check engine light came on, my car started stalling, shaking, and making noise. I stopped the car and checked the engine- coolant was exhausted. Upon taking to get it checked- the head gasket and short block were blown/cracked. The coolant had leaked into the engine. This should not have happened on a car with this low of mileage. I did my research and this is a well known issue for Ford Fusions during this time range. I called Ford and they told me there is nothing that they could do.

After check engine light and the coolant fluid low light came on, I took it to a ford dealership and was told that they found there was a coolant leak which caused the engine to fail and that the short engine block needed to be replaced and it would be 9000 dollars to repair. so we are now faced with paying for a repair that is double what the car is worth or get a new car. there was never a recall for the coolant leak even though Ford knows its a known issue.

Rear camera will go black and say contact dealer. Other times images will appear distorted or will be reversed where left and right are mixed up

Cable and bushing detached for a third time. I called ford and they said there was not a recall for this issue. I’ve read in multiple places that this has happened to a lot of ford fusions.

The contact owns a 2015 Ford Fusion Energi. The contact stated while driving at various speeds, the steering wheel became difficult to turn to the left or the right. The contact stated that the ABS and traction control warning lights were illuminated. The vehicle was towed to a local dealer where it was diagnosed and determined that the electrical rack and pinion needed to be replaced and recalibrated. In addition, the contact linked the failure to NHTSA Campaign Number: 15V340000 (Steering); however, the VIN was not included. The vehicle was not repaired due to costs. The manufacturer was made aware of the failure. The failure mileage was approximately 100,008.

The contact owns a 2015 Ford Fusion. The contact stated while driving approximately 40 MPH, the message that the engine was overheating was displayed. The contact stated that the temperature gauge indicated that the engine was hot(H). The contact drove the vehicle to an independent mechanic who diagnosed the vehicle and determined that there was coolant into the cylinder. The contact was advised that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was informed of the failure and referred the contact to the Hotline to report the failure. The failure mileage was approximately 113,000.

When starting the car this morning, I noticed that the steering wheel was driving kind of stiff and the car was kind of losing control while I was accelerating down the street. A while later in the day, my wrench light came on and then turned off, but a couple of months later a warning light came on saying Hillside assist not available, and then another warning light popped up after that one saying Service advance trac. So I turned the car off and attempted to restart it and the lights stayed on.

Rear view camera intermittently stops working entirely or shows a mirrored image (view is reversed).