2016 FORD FUSION Complaints
View complaints related to 2016 FORD FUSION. The complaints found here are submitted by actual consumers with first hand experience. There are more than 1,610 complaints submitted for the 2016 FORD FUSION. You can submit your own complaint to the NHTSA or call the Hotline, Monday-Friday 8am to 8pm at (888) 327-4236, TTY: (800) 424-9153.
-
2016 FORD FUSION- Klamath Falls, OR
2016 FORD FUSION TITANIUM BACK UP CAMERA WORKS INTERMITTENTLY. THE VIEWING SCREEN GOES BLANK WHEN IN REVERSE.
Source: NHTSA WEB SITE -
2016 FORD FUSION- COLUMBUS, GA
A few years ago our camera on our 2016 Ford fusion started acting up. Going in and out, sometimes blank. I actually filled a complaint out before. I have noticed recalls on cameras but not our vehicle or even year. Now I saw one yesterday or this morning that listed my year but not model. I forgot to mention above that it also goes completely opposite. This is a major issue and concern. It has almost caused accidents especially in parking lots. No incidents YET. People love walking behind cars backing out and this is a deadly combination waiting to happen
Source: NHTSA WEB SITE -
2016 FORD FUSION- Connellsville, PA
Had head gasket done at 78600 for misfire in cylinder 4 for coolant intrusion 11000 miles later I have misfire in cylinder 4 again with coolant intrusion
Source: NHTSA WEB SITE -
2016 FORD FUSION- Trabuco Canyon, CA
I read this following article: [XXX] My 2016 Ford Fusion experiences this issue. I was curious why the Fusion is not included in the recall? Thank you. [XXX] c- [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Source: NHTSA WEB SITE -
2016 FORD FUSION- Syracuse, NY
The contact owns a 2016 Ford Fusion. The contact stated that the back over prevention camera had malfunctioned. While reversing, the screen image was blank. Occasionally, the camera worked as needed for a day or two. There were no warning lights illuminated. The contact linked the failure to NHTSA Campaign Number: 25V442000 (Back Over Prevention). The local dealer was not notified of the failure. The vehicle was not diagnosed or repaired. The manufacturer was not contacted. The failure mileage was approximately 160,000.
Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE -
-
2016 FORD FUSION- sheffield lake, OH
The 1.5l engine is having known issues with coolant intrusion into the engine under 100,000 miles. Many people are bringing up their issues staying ford is confirming the mass amount of engine issues with intrusion and quoting $6,000 for new engines. This is absurd because these vehicles should not have an engine known to fail at 100,000 because of leaking coolant into the cylinder. I started losing coolant at 90,000 miles and having to fill it back up.
Source: NHTSA WEB SITE -
2016 FORD FUSION- Sandwich, MA
Backup camera has failed. Again. It was first replaced in 2020 under extended warranty. Now it has failed again.
Source: NHTSA WEB SITE -
2016 FORD FUSION- Ware, MA
Backup camera inverts and blanks out. Other ford vehicles have this issue and have recall notices. 2016 Ford Fusions do not have this recall.
Source: NHTSA WEB SITE -
2016 FORD FUSION- Oxford, WI
132,582 miles 2016 SE AWD Ford Fusion 2.0 EcoBoost. About Two wks ago Driving car at 55mph warning indicator Engine temperature High came on. Pulled over turned off AC left engine run on side road for approx 2min thermostats went from just above mid line back down to normal level drove 10miles home engine coolant empty in reserve had just checked two days prior when checking all other fluids and it was at Max. Filled back up with Orange premixed Coolant no leaks observed engine light went off drive two days check and coolant stayed third day noted coolant down under min check engine light on again filled back to max vehicle sputtering when starting then idled down and no stutter Husband ran diagnostic and misfire cylinder 3. Changed all 4 plugs and cylinder 3 coil pack no antifreeze noted in any cylinders at that time. Car started up fine no check engine light drove two more days checking coolant level in resivor stayed at Max driving third day 55mph for 3miles after just checking level engine temp high alert on pulled over shut off car checked revisor due to recent issues. Revisor Empty, allowed to cool Depressurized by unscrewing resivor cap minimal coolant back flowed from radiator. Filled resivor to full restarted car engine light on drove 8 miles checked coolant level little under min line, cooled engine topped back off drove home 11miles. Parked car Husband ran diagnostic and misfire cylinder 3 again. Compression test all cylinders were at 148 accept cylinder 3 at 150 due to antifreeze in it. Checked oil no antifreeze in oil. Noted excessive white smoke from dual exhaust. Coolant pressure test done and noted antifreeze observed in cylinder 3. Technical bulletins and recalls checked noted multiple forums with coolant induction issues due to poor design of ecoboost engines by FORD. Still owe $10k on this car FORD should be responsible for all manufactured years with issues due to ecoboost. Unable to find anything for 2016 Fusion 2.0. Please Help!
Source: NHTSA WEB SITE -
2016 FORD FUSION- Elkhart, IN
I was driving on the expressway. My car Went into limp mode it didn’t stall completely out, but I was not able to accelerate any eventually the wheel became tight. every light came on.. I made it safely off the expressway. My car would not start the ODB port is not reading. I’ve taken it to several mechanics all of them say that it’s my PCM. They said my PCM needs to be reprogrammed. There’s currently an active recall from my exact car but when I search my vin It tells me I have no active recalls.
Source: NHTSA WEB SITE