2016 FORD FUSION Complaints

View complaints related to 2016 FORD FUSION. The complaints found here are submitted by actual consumers with first hand experience. There are more than 1,610 complaints submitted for the 2016 FORD FUSION. You can submit your own complaint to the NHTSA or call the Hotline, Monday-Friday 8am to 8pm at (888) 327-4236, TTY: (800) 424-9153.

  • 2016 FORD FUSION
    - Madison, AL

    Ford has a recall on 2016 Ford Fusion transmission cable shifter. My car is not under the recall but displays the issues the recall states. My car jerks during acceleration and difficult to park. Can please help me resolve the issue with Ford. They refuse to fix the issue because my car VIN# was not placed under the recall. It is not fair for me to pay for an mechanical issue that was defective by Ford causation.

    Source: NHTSA WEB SITE
  • 2016 FORD FUSION
    - Fishers, IN

    Driver side seat belt suddenly stopped working. Initially it was stuck and would not deploy. Eventually it released and was able to be drawn and buckled, but does not restrain passenger when tested manually; driver was not restrained when the car was braked quickly. rom 35 mph to a full stop. There is a December 5, 2016 NHSTA recall on front seat belts May not restrain Occupants (NHSTA Campaign number 16V875000) and and a Ford Recall number 16S42. Car was purchased from a Ford dealer in 2018-2019 as a used vehicle. Current dealer indicates it may cost from $400-1200 to replace the seat belt.

    Source: NHTSA WEB SITE
  • 2016 FORD FUSION
    - Yonkers, NY

    purchased a used vehicle. At the time of purchase, there were no visible issues with the car. However, approximately 20 days later, a significant jerking and knocking problem related to the transmission appeared. Due to this issue, I stopped using the vehicle for a while. After consulting with a mechanic, I was informed that the transmission needs to be replaced. As of now, the car is struggling significantly to move. When I turn the ignition, the engine starts, but the vehicle does not move. If I turn the ignition off and restart it, it may move slightly after shaking the vehicle, but then it quickly stops and displays an error again. In this condition, the vehicle is not drivable. Unfortunately, the person I bought the car from refused to accept any responsibility or take the car back, despite my clear communication about the issue. Additionally, the following issues have also started to occur: The steering wheel becomes stiff suddenly. This resolves temporarily after turning the ignition off and on again. The brake pedal sometimes vibrates as if it’s losing pressure. I can clearly feel this under my foot while braking. Sensor malfunctions have also started to appear. The current condition of the vehicle poses serious safety and functionality concerns. Unfortunately, I am not financially able to cover any additional repair costs. Therefore, I would like to know if there is anything legally or technically that can be done regarding this matter. Otherwise, I will be forced to sell this vehicle as scrap. Thank you in advance for your support and assistance. Sincerely,

    Source: NHTSA WEB SITE
  • 2016 FORD FUSION
    - Santaquin, UT

    The contact owns a 2016 Ford Fusion. The contact stated that while driving at various speeds, an abnormal knocking sound was coming from the vehicle. The contact's husband changed the spark plugs; however, the failure persisted. The failure persisted, and the check engine warning light illuminated. The vehicle was taken to an independent mechanic where it was diagnosed with coolant intrusion into the cylinder, resulting in engine failure. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. Several dealers were notified of the failure; however, each dealer informed the contact that there were no recalls related to the VIN. The manufacturer was made aware of the failure and provided a case number. The contact was referred to the NHTSA Hotline for further assistance. The failure mileage was approximately 117,000.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2016 FORD FUSION
    - Council Bluffs, IA

    I purchased a 2016 Ford Fusion S new from the dealership in 2016. Earlier this year, multiple indicator lights turned on including "Service AdvanceTrac", ABS light, steering and hill assist lights. As time progressed, the Power Steering has become more of an issue to a point now that it is difficult to make tight turns going at low speed. I never received a recall notice, but when I did a search of the 2016 Ford Fusion S vehicle, there is an outstanding recall on similar models in 19V632000. The list of states include the state of Missouri which is where the vehicle was purchased from. At the time the recall notice was sent out (August 28, 2019), the vehicle would have been registered in Kansas. A search by the VIN number does not show a recall notice for it. Presently, the vehicle is registered in Iowa. I hope to get review of my VIN number to see if this recall should have included my vehicle as there are similar models distributed in similar states, with exact issues pertaining to my vehicle which was not included in the initial recall. I have service scheduled for this vehicle at an authorized Ford dealership on July 17th, 2025 which was the earliest I could get the car in. I'm concerned as this is a substantial issue that puts the vehicle at risk for a serious malfunction should the power steering fail completely while being operated. This is a relatively low mileage vehicle for the year which likely why the issue hasn't arose until this point. I appreciate your time and consideration on this matter.

    Source: NHTSA WEB SITE
  • 2016 FORD FUSION
    - Minden, LA

    Started car and out of nowhere it began sputtering. Then Engine light came on and when tested the diagnostic said “cylinder 2 misfire. I didnt drive anywhere and light was off today when I crank it. well started driving and light is flashing. Ford dealership said this is a common issue from poor design engine but my car only has 40,000 miles. This seems to happen to ALOT of the 2016 eco models. Says coolant goes into engine. I’m aware most of these models have recalls but not 2016 why!!!!! It’s clearly a faulty engine problem if so many people are having the exact problem and code.

    Source: NHTSA WEB SITE
  • 2016 FORD FUSION
    - Lula, GA

    While backing up, the rear came will show a black screen on the display or a message to contact the dealership. This isn't a constant issue, but comes whenever. I took it to the dealership a few years ago, but because it wasn't happening then, they said there was nothing they could do.

    Source: NHTSA WEB SITE
  • 2016 FORD FUSION
    - Pacoima, CA

    The contact owns a 2016 Ford Fusion. The contact stated while the vehicle was parked, the steering wheel failed to function as intended. The contact stated that the assist fault error and an unknown warning light was illuminated. The vehicle was towed to the dealer where it was diagnosed with steering gear failure. The contact was informed that the steering gear needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure. The contact was advised to contact the NHTSA Hotline to report the failure. The failure mileage was approximately 38,263.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2016 FORD FUSION
    - Indianapolis, IN

    The contact owns a 2016 Ford Fusion. The contact stated that when the vehicle was started, there was smoke coming from the exhaust. The check engine warning light was illuminated. Additionally, the contact stated that on several occasions while driving at undisclosed speeds, the vehicle was shaking abnormally before losing motive power. The vehicle was towed to a dealer, where it was diagnosed with a faulty engine block. The contact was informed that the engine block needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 145,000.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2016 FORD FUSION
    - Oracle, AZ

    Rear passenger seat belt will not release lock/tension/broken. Will not allow rear occupants to buckle in. Safety issue. Seems to happen on most 2013+ ford vehicles specifically trims like titanium with a 'inflatable belt" This issue should be recalled free of charge, It is a major safety issue not to be able to use a seatbelt. The best remedy would be inspect and replacement of broken components. Both occurred over 80k miles one being a truck (entirely different vehicle)

    Source: NHTSA WEB SITE