2016 FORD FUSION Complaints

The contact owns a 2016 Ford Fusion. The contact stated that while her son was driving at approximately 65 MPH, the "Low Brake Fluid" warning light was blinking. The contact attempted to slow down and depressed the brake pedal, and the brake pedal was depressed to the floorboard and the vehicle failed to respond as needed. The contact stated that her son was able to stop the vehicle and called for assistance. The contact stated that she drove to his location had a quart of brake fluid and refilled the brake fluid reservoir. The vehicle was driven back to her residence. The contact noticed that brake fluid was forming a puddle underneath the driver's side rear wheel well. The contact stated that NHTSA Campaign Number: 23V162000 (Service Brakes, Hydraulic) repair had been completed in November 2023; for the front brake lines. The contact related the failure of the rear driver’s side brake failure to the recall. The vehicle was not taken to a dealer or an independent mechanic. The vehicle was not diagnosed or repaired. The manufacturer was not informed of the failure. The failure mileage was unknown.

The contact owns a 2016 Ford Fusion. The contact stated while driving at an undisclosed speed, the engine seized. The contact stated that the failure had occurred two times since July of 2023. The vehicle was taken to an independent mechanic where it was diagnosed with coolant intrusion and engine failure. The contact was informed that the engine needed to be replaced. The manufacturer was made aware of the failure. The contact was made aware of Customer Satisfaction Program: 21N12 (Short Block Replacement After Coolant Intrusion); however, the vehicle was not included. The contact was advised to contact the NHTSA Hotline to report the failure. The failure mileage was approximately 120,000.

Coolant leaked into a cylinder due to a failed head gasket at 61,000 miles. Ford replaced head gasket, but the issue is due to poorly manufactured engine, and I had the same issue starting again at 99,000 miles. Ford refuses to fix engine since it is out of warranty, but the issue is due to poor manufacturing, not customer negligence.

There is a " design flaw" with the vehicle where coolant leaks into the cylinder heads and you have to replace the whole engine. I have read about it in the Internet when my check engine light came on and gave me cylinder 2 misfire code.I started the car and the check engine light was off. I tried to get to work that morning and the car shut off on the middle of Interstate 81 with no warning. It was a very dangerous situation where I got stuck until it came to a complete stop and turn it back on. White smoke poured out of the tail pipe, I went home. I spoke with a Ford representative who said it is a design flaw in this engine and the whole thing needs to be replaced, with engines starting at $5,000 plus 4 days labor. He advised that the problem could happen again with the replacement. I know there is nothing you guys can do but my car died in 2 days.i have a $20,000 to pay off and only had this car a year and I am going to have to give it back and keep paying for it, for 5* years. I feel so upset and cannot believe Ford is doing this to people and getting away with it. This ruined my life and I will probably lose my job now cause I have no means of transportation. This needs to be recalled! It's not right

The contact owns a 2016 Ford Fusion. The contact stated while driving 70 MPH, the check engine warning light illuminated with the engine overheated message displayed. The contact pulled over to allow the engine to cool down. The vehicle was drivable. The contact was constantly adding coolant to the coolant reservoir and the engine overheating message was displayed. The vehicle was taken to the dealer and was diagnosed with an internal coolant leak in the engine. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The contact researched online and became aware of NHTSA Campaign Number: 17V209000 (Engine and Engine Cooling) however, the VIN was not included in the recall. The manufacturer was contacted and confirmed that the VIN was not included in the recall. The contact was referred to the NHTSA Hotline to report the failure. The failure mileage was approximately 80,000.

Component failure: Engine -- Catastrophic engine failure due to coolant leakage onto the engine block. EcoBoost engine. Dealership confirmation that car engine will need full replacement - car essentially scrap metal without new engine. At the time of this failure car had approximately 40,000 miles odometer read total on it and maintenance was up to date. Personal safety - I was driving the car on a Freeway with other vehicles at approximately 65 mph and the entire car began to shudder and I lost the ability to accelerate. The road was on an uphill trajectory and I was in the middle lane - I had to navigate my vehicle to the right hand lane and off the freeway at the next exit - I and others were at high risk of a collision due to the severity and sudden failure of the engine while on a busy road. Dealer confirmation: Dealership had specific codes on the diagnostics decribing this issue. Repair offered was replacement of the long block with a Ford engine that had been modified to fix the coolant leakage problem. Essentially Ford was offering a new TYPE of engine instead of a fix with the same model the car originally had. Dealership was aware of this engine coolant issue with Ecoboost, they revealed Ford was aware of the issue but never issued a recall. We were given the customer complaint line and were told FORD has been offering SOME people new engines at no cost. We were rejected by Ford customer line and told to file a complaint here. Essentially described by dealership repair as need to replace the long block (entire engine) to fix the problem or replace the short block only to expect it to happen again. The cost to replace the long block was quoted at 9500.00. Inspection and repair worksheets available from owner. Warning signs: NONE. Check engine light came on approximately 30 seconds AFTER symptoms on freeway began.

Loss of power steering and multiple codes light up on dash about an hour prior to loss. Experienced a slow escalation of having difficultly steering of approx 1-2 days where steering did not seem as responsive. Was able to return home, but upon restart i had no power steering steering and multiple diagnostics failure lights coming on [Steering Loss Stop Safety, Service Advance Trac, Hill Start assist not available]. This currently is in a state of not being able to drive. Losing power steering assist puts safety at jeopardy at any speed to not allow for any fine movement or directional control. If this happened at any rate of speed this is a concern. It being the weekend I will need to discuss with my local mechanic as well as local dealership on course of action. I have tried to restart several times with the warnings and still lack of steering

The contact owns a 2016 Ford Fusion. The contact stated that while driving at various speeds, the engine started overheating, and the coolant level dropped significantly. The contact stated that there was a sloshing sound inside the cabin of the vehicle, coming from under the dashboard. The vehicle was taken to an independent mechanic who diagnosed the vehicle with a coolant intrusion into the combustion chamber. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 128,000.

The ABS System light , The traction off and on at the same time, the advanced track light, and finally the tire pressure monitor fault I belive is what it says. The lights came on one day when I crossed over railroad tracks that were a little rough nothing that should damage anything on a vehicle. one after another the lights began coming on. The steering is very tight and makes it hard to drive. When I go over bumps or any uneveness in the roadway the car will shift making the steering wheel jerk and the car to swerve. When you push on the brakes at times it feels like they are skipping and making a weird skipping sound as well. I thought it was needing the brakes so I got all for sides new brakes and rotors. That did not help either. I had a diagnostic scan done the car but it did not pick up anything but an h20 sensor so I got that repaired. I don't know why this is happening and I'm a single mother/grandmother. I cannot afford to spend a lot of money trying to fix these issues.

My car has about 120k miles on it. The issue is that the coolant leakes into the cylinders. Tried replacing cylinders but problem came back. Dealership says the engine needs repair. The safety issue I had was I was driving on the hwy at about 60. The car suddenly went from 60 to 30. If a car had been behind me I would have been hurt. The manufacturer ford will not pay. I have seen many of this exact same issues on your website. This IS a safety issue. What can you do?