2012 FORD FUSION Complaints
View complaints related to 2012 FORD FUSION. The complaints found here are submitted by actual consumers with first hand experience. There are more than 2,500 complaints submitted for the 2012 FORD FUSION. You can submit your own complaint to the NHTSA or call the Hotline, Monday-Friday 8am to 8pm at (888) 327-4236, TTY: (800) 424-9153.
-
2012 FORD FUSION- York, SC
I got a 2012 ford fusion se 2.5 4l power steering gone out in it,I put in the vin number to see if mine was recalled it said 0 but my car has the part in the car that made the car recalled ,on the dash its says power steering service its dangerous and I had my child in the car vin number on my car is [XXX] I seen where other 2012 ford fusion se 2.5 4l was recalled for the power steering going out INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Source: NHTSA WEB SITE -
2012 FORD FUSION- Vancouver, WA
While I was driving my 2012 Ford Fusion on August 3rd the steering cut out. I parked the car and re-started it and it worked again. It went to the shop (Extra Mile Automotive) on XXX where they informed me of the 2015 recall on the steering. Recall number 15S18 and program 15N01 When I spoke with [XXX] Ford in [XXX], they said they replaced the electrical piece of the recall on December 7th 2015, but not the steering shaft. [XXX] (the westlie ford employee) said because the electrical was completed, the recall procedure was marked as completed, even though [XXX] said that this is very much tied to the original recall. I asked him to submit a Special Service Support Center request to get this fixed and he did submit that on XXX. On XXX it was denied. On XXX I also requested to speak to [XXX] supervisor and was connected to [XXX] (id # XXX) who also said there was nothing she could do because this was already "solved" in 2015. This is not a new or unrelated repair request, it is the unresolved second half of a federally mandated safety recall. Ford's own dealership confirmed that my steering gear failure is directly connected to the original defect covered under Recall 15S18, and Ford's own extended coverage program, 15N01, exists specifically to remedy this exact scenario. Despite this documented connection, Ford has now denied a remedy twice, once through the dealer's SSSC request, and once directly through Ford Customer Service, without providing any technical explanation for why a known, recall-covered defect is being treated as ineligible for repair. My vehicle experienced a complete loss of steering assist while in motion. This is an active, unresolved safety hazard on a vehicle currently in use on public roads, and I am filing this formal complaint because Ford has failed to meet its obligation under federal law to remedy a safety defect without charge to the owner. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Source: NHTSA WEB SITE -
2012 FORD FUSION- Sacramento , CA
Vehicle experienced loss of power steering so it was hard to steer.When I called a ford dealership I was told my vehicle didn’t qualify for any power steering recalls so I would have to pay full price which is unaffordable
Source: NHTSA WEB SITE -
2012 FORD FUSION- Waxahachie, TX
The contact owns a 2012 Ford Fusion. The contact stated that while driving at an undisclosed speed, the brake pedal was depressed; however, the vehicle failed to stop as intended. The contact stated that the brake pedal was soft and spongy. The brake pedal was depressed to the floorboard before the vehicle stopped. No warning lights were illuminated. The vehicle was taken to an independent mechanic, and the contact was informed that the failure was not duplicated. The contact was informed that an inspection was completed, and the brake pads and rotors were in good working order. The contact stated that the failure had occurred two months after the brake pads and rotors were replaced by an independent mechanic. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The manufacturer was not made aware of the failure. The failure mileage was approximately 149,000.
Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE -
2012 FORD FUSION- Lakewood, WA
I am submitting this formal complaint against Ford Motor Company and its authorized dealership network for falsely reporting a safety recall repair as "resolved" while applying an unauthorized, temporary workaround that left the primary safety defect active. In 2023, I brought my vehicle to an authorized Ford dealership to perform mandatory safety recall service regarding the Electric Power Assist Steering (EPAS) failure. The dealership subsequently updated Ford’s central database (OASIS) to show that the safety recall was fully resolved and completed for my VIN. However, the official Repair Order / Invoice provided to me by the technician explicitly documents that a permanent remedy was not performed due to a lack of replacement parts. The technician’s exact written notes state: "Customer states power steering is not working. Tech and advised verified concern finding that the ground wire pin on the high current wiring harness to PSCM had backed out of the connector. Reconnected pin and cleared codes finding issue resolved. Issue will continue to happen until the harness is replaced. Harness is unavailable at this time. Glued pin into connectors."Because the dealership glued the loose pin rather than replacing the backordered wiring harness, the temporary repair failed shortly thereafter, resulting in a total loss of power steering assist. For the past three years (approximately 47,698 miles driven), I have been forced to operate this vehicle without functional power steering. Every attempt to have Ford or its franchised dealerships address this safety hazard has been denied because Ford’s internal system incorrectly lists the recall as "The Harness Powers the Recalled Module: The "high current wiring harness to PSCM" is the primary electrical supply to the exact module being recalled. Reprogramming software on a module while leaving a damaged, glued power connector defeats the entire purpose of restoring power steering safety.see photoes of invoice below
Source: NHTSA WEB SITE -
-
2012 FORD FUSION- Papillion , NE
I had purchased these tires P225/50R17 for my son‘s car in 2022. They have an 85,000 mile tread life warranty in April of this year. He had a blowout on the left rear tire where the tread separated from the tire and in late July this year is preparing for a 3500 mile trip as I was inspecting his car before his trip. I noticed the tire on the right rear looked to be defective. It looks like the tread where it meet the sidewall is separating from the tire on the inside with a tear about 8” long where the metal is showing. Two tires out of 4 losing their tread is disturbing and a concerning safety issue with these tires, see the Photos I have supplied.
Source: NHTSA WEB SITE -
2012 FORD FUSION- Greenville, SC
The contact owns a 2012 Ford Fusion. The contact stated that while driving at an undisclosed speed, the steering wheel became difficult to turn. The message "Power Steering Assist Fault" was displayed. The failure was a recurring failure. The first failure was serviced by the dealer under NHTSA Campaign Number: 15V340000 (Steering); however, a year later, the failure reoccurred. The vehicle was then taken to an independent mechanic where the rack and pinion was replaced but the failure persisted. The manufacturer was made aware of the failure. The failure mileage was approximately 138,000.
Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE -
2012 FORD FUSION- Red Oak, IA
No check engine, light or anything lost my electronic steering capabilities I’m going down the road
Source: NHTSA WEB SITE -
2012 FORD FUSION- Monongahela, PA
The power steering system, failure. completely without warning I see recalls on this model. But do not see it on the website. Nor will ford repair it
Source: NHTSA WEB SITE -
2012 FORD FUSION- Azusa, CA
My car does not always respond when the brakes are tapped. They are soft/squishy at times and I have to push the pedal all the way to the floor for the car to stop. This issue has been occuring off & on for approximately 3 years though it's been more frequent since June of 2026. I have never seen any warning or failure light/notification any of the times this has happened. The issue was determined to be a faulty master cylinder by the service department at Colley Ford in Glendora, CA.
Source: NHTSA WEB SITE