2018 FORD FUSION Complaints

The contact owns a 2018 Ford Fusion. The contact stated that the check engine warning light was illuminated. Additionally, there was white smoke coming from the exhaust pipes. The vehicle was taken to an independent mechanic several times, and the contact was informed that the engine was consuming antifreeze. The ignition coils and spark plugs were replaced; however, the failure persisted. The mechanic associated the failure with the engine. The vehicle was taken to a dealer, where it was diagnosed and determined that the short block was warped and that the engine needed to be replaced. The vehicle was scheduled to be repaired. The contact researched the failure and stated that it was a known issue that the manufacturer had failed to correct. The manufacturer was notified of the failure via telephone; however, no assistance was provided. The failure mileage was approximately 122,000.

We have coolant intrusion in cylinder 2 of our engine. This can cause highway failure of engine cuts out, car runs rough and it can become a fire hazard. We paid for a diagnostics through a ford dealer. Who we uses all the time for our warranty needs. We noticed car was starting to run rough and check engine light came on 8/5/26

my 2018 ford fusion has catastrophic engine failure. Engine stuttering and misfires with check engine light. Low coolant levels with no visible puddles under the car. Engine overheating, could possibly catch fire. Car recently had a tuneup was told no issues at the time. Failure mileage at 109,000.

The 1.5L EcoBoost motor has coolant intrusion problem on cylinder 3. The 1.5L EcoBoost motor sputters while driving causing the engine to be sluggish and not get up to speed when turning and might cause an accident on the highway due to the motor failing due to coolant intrusion design flaw in Ford Motor. Yes, Ford dealership confirmed the coolant intrusion problem on cylinder 3 and check engine light keeps coming on and off. Yes, the Ford dealership inspected the 1.5L engine in the vehicle and ran test to confirm the coolant intrusion problem on cylinder 3. There was no other warning lamps or symptoms prior to the failure/degrade of engine

On August 10, 2026, I was driving my 2018 Ford Fusion at approximately 40 mph under normal driving conditions when, without warning, the hood unexpectedly released and flew completely backward into the windshield. The hood had been closed prior to driving and there was no warning before the failure. The hood struck the windshield with significant force, shattering it, immediately blocking my forward visibility, and sending broken glass into the passenger compartment and onto me. Because I suddenly could not see the roadway, I lost control and the vehicle left the road. Fortunately, no other vehicles or pedestrians were involved and I did not require medical treatment. This was not a hood that simply became loose or partially opened. The hood fully opened and struck the windshield. Based on what occurred, it appears the primary hood retention/latch and the secondary safety retention mechanism both failed to prevent the hood from fully opening. The exact mechanical cause requires inspection. The impact caused extensive damage to the hood and windshield and tore/deformed metal around the windshield/A-pillar/roof area. An independent eyewitness across the street personally witnessed the incident occur in real time, and I have photographs documenting the aftermath. The vehicle has approximately 156,000 miles, was in good operating condition, and remains unrepaired and unaltered following the incident so the hood latch, secondary safety catch, striker, hinges and related components can be inspected. Ford was notified immediately and opened case CXH-08862363-V8C8X7, which Ford advised was escalated to its Office of General Counsel. I am reporting this because this apparent hood-retention safety failure created an extremely dangerous situation. Had this occurred at highway speed, at a higher speed, in heavy traffic, or near pedestrians, the consequences could have been catastrophic.

The leather-covered dashboard panel, in the approximately 4-6 inch section between the base of the windshield and the first seam across the dash, has shrunk, rippled, and pulled away from the underlying substrate. This area also houses the driver-assist camera housing and the defrost vent. The vehicle was purchased new and has been Ford-maintained, professionally detailed, and garage-kept throughout ownership; the leather has been regularly cleaned and conditioned as part of routine dealership detailing, ruling out lack of care as a cause. The vehicle's build date is January 2018, which falls within the range covered by Ford Technical Service Bulletin 18-2283 ("Instrument Panel Sagging at the Windshield Glass"), issued for vehicles built between October 13, 2014 and February 2, 2018, describing the instrument panel sagging and separating near the windshield. I am filing this complaint because this appears to be a documented, recurring defect pattern affecting this vehicle's dash generation, rather than isolated cosmetic wear. Ford Customer Relations has twice declined goodwill assistance, citing the vehicle's age (just over 8 years) as the sole basis, without physical inspection or evaluation of the underlying condition. An independent repair estimate to replace the dash panel and remove/reinstall the windshield for access was quoted at approximately $3,100.

There is a recall for the transmission cable bushings for years 2013-2106. The recall came out in 2022. This same bushing is used in the 2018 ford fusion model that was not fixed. The bushing on my vehicle which is a 2018 complete failed while I was driving and left me immobile until I searched for a fix and found the bushing completely gone. Ford Escape: Model years 2013–2019, Ford C-Max: Model years 2013–2018; Ford Fusion: Model years 2013–2016; Ford Transit Connect: Model years 2013–2021; Ford Edge: Model years 2015–2018. Each model besides the fusion went past the 2018 model in which the 2018 fusion should be apart of

Transmission/cracked flexplate started approximately 12 months prior with vibrations getting progressively worse, complete failure needing replacement along with shift cable bushing causes vehicle to select wrong gear position when another is commanded by driver. Shrapnel from case or components could be expelled during flexplate/converter failure. Incorrect gear selection could lead to potential injury or damage from improper gear selection.

There is a known coolant intrusion into the engine that caused the engine to suddenly only go to a certain speed while on the freeway. It could have caused an accident on the freeway by suddenly going at such a slow speed. It is now found out that the problem is known by Ford and is part of a technical service bulletin, but no recall has been issued on this known problem. The TSB associated are 19-2139, 19-2375, 20-2100. By not making this a recall, Ford is knowingly putting lives at risk with potential sudden loss of speed in these engines. It is lucky this was late at night when not many cars were on the road.

Vehicle would not recognize car being in Park. Displayed warning messages: Shift Sys Fault Confirm Park Brake Before Exiting Vehicle. Transmission Not In Park