2016 FORD MUSTANG Complaints

THE REAR CAMERA HAS GONE OFF AND ON FOR MONTHS NOW IT DOES NOT WORK AT ALL..THE DEALERSHIP HAS TOLD ME THERE HAVE BEEN MANY WITH THIS PROBLEM THE HARNESS IN THE TRUNK GOES UP AND DOWN WITH THE OPENING AND CLOSING OF THE TRUNK CREATING STRAIN ON THE WIRES CAUSING CAMERA FAILURE.. DEALERSHIP WANTS 1000 TO FIX THIS AND MY CAR HAS 32000 MILES ON IT THE EMERGENCY BREAK STICKS BECAUSE THE SLEVING AROUND IT GETS STUCK NOT ALLOWING THE RELEASE OF THE BREAK

THE HEATED AND AIR CONDITIONED SEATS STOPPED WORKING ALTHOUGH THE DASH INDICATOR SHOWS THAT IT IS ON. A SEARCH OF THE INTERNET SHOWS THAT IT IS A VERY COMMON PROBLEM ON 2015-2016 MUSTANG MODELS. THE CONNECTOR UNDER THE PASSENGER SEAT SHOWS A SEVERELY BURNED CONNECTION AS INDICATED IN THE ATTACHED PHOTO. THIS APPEARS TO BE A VERY SERIOUS AND POTENTIALLY DANGEROUS PROBLEM THAT NEEDS TO BE ADDRESSED VIA A RECALL.*DT

HEATED AND COOLED SEATS STOPPED WORKING. I CHECKED SOME FORUMS AND FOUND OUT IT WAS A VERY COMMON PROBLEM. THIS PIN FOR THE GROUND ON THE WIRE ASSEMBLY THAT CONTROLS THE SEAT IS THE ONLY ONE, AND IT IS COMMON FOR IT TO COMPLETELY BURN OUT AS SEEN IN THE PICTURE. AS IT'S IN THE CABIN, UNDERNEATH THE PASSENGER SEAT, IT IS VERY DANGEROUS FOR IT TO BE BURNING THIS WAY.

TRANSMISSION WILL GO INTO NEUTRAL WHILE TRAVELING ON HIGHWAY 280 A HIGHLY TRAVELED STATE HIGHWAY IN ALABAMA, CAUSED BY A BAD TRANSMISSION OUTPUT SENSOR

HEATED COOLED SEATS ARE NOT WORKING. CHECKED THE CONNECTOR PAN UNDERNEATH THE SEAT AND THERE'S A BURNT AREA ON BOTH THE PIN AND ON THE MODULE

IN MY 2016 FORD MUSTANG ECOBOOST CONVERTIBLE, THE PASSENGER DOOR HAS OPENED (UNLATCHED) MANY TIMES WHILE I HAVE BEEN DRIVING. THE CAR HAS NOT BEEN WRECKED DUE TO MY KNOWLEDGE AND THE CARFAX. THIS DOESN'T OCCUR OFTEN, BUT WHEN IT OCCURS, IT HAPPENS MULTIPLE TIMES IN THAT DAY. IT USUALLY OCCURS WHEN DRIVING ON THE INTERSTATE. THERE IS A RECALL OUT FOR 2015 FASTBACK MUSTANGS FOR THIS ISSUE. BUT I PRESUME THERE IS A SIMILAR ISSUE WITH 2016S.

UPDATE INFORMATION THE PROBLEM IS THE BACKUP CAMERA. POOR DESIGN AND INSTALLATION WITH POSSIBLE SHORTNESS OF LENGTH OF WIRING CREATING TOO MUCH TENSION. ANY DEVICE SAFETY DEVICES NEEDS TO BE CORRECTED. THE OTHER PROBLEM LAST MARCH I HAD TO PAY IS THE THIRD BACKUP LIGHT BECAUSE OF POOR WIRING DESIGN.

L LAST MARCH 2020 I TOOK MY CAR IN FOR INSPECTION AT MY FORD DEALERSHIP (WYNNE FORD HAMPTON VA) AND INSPECTOR FAILED MY STATE INSPECTION BECAUSE OF THE BACKUP LIGHT NOT WORKING. THE ELECTRICAL WAS REPAIRED. NOW MY BACKUP CAMERA IS NOT WORKING. SAME PROBLEM WITH THE ELECTRICAL WIRING. OSHA STD HAS A QUALITY WORKMANSHIP. FORD HAS MADE A POOR WORKMANSHIP FOR THESE SAFETY DEVICES. NEED A RECALL AT NO EXPENSE FOR CONSUMERS FOR THEIR POOR WORKMANSHIP RELATED TO SAFETY. TOO MANY INDIVIDUALS REPORTED WITH THE SAME ISSUES.

APPROXIMATELY 31,000 MILES BUT WARRANTY HAS EXPIRED DUE TO LAPSE OF TIME - HE A/C HAS FAILED DUE TO WHAT THE DEALERSHIP CALLED A KNOWN ISSUE; HOWEVER, EVEN THOUGH MILEAGE WOULD STILL BE UNDER WARRANTY BECAUSE THE CAR IS GREATER THAN 3 YEARS OLD THEY WILL NOT COVER THIS COSTLY REPAIR

BURNED ELECTRICAL CONNECTER CONTROLLING FRONT SEAT HEATING AND COOLING. THE FOLLOWING IS FROM THE REPAIR WORK ORDER: #1 91MBZS SEATS INTERNAL GUEST STATES HAVC FOR FRONT SEATS NOT GETTING COLD OR HOT BURN CONNECTOR GOING TO THE HVAC CONTROL UNIT UNDER THE FRONT PASSENGER SEAT. I STARTED OFF MY CHECKING POWER TO THE HVAC MODULE TO SEE IF THERE WAS A SHORT BEFORE THE CONTROL UNIT. I REMOVED THE SEAT AND HVAC MODULE TO CLEAN THE PINS ON IT THAT WERE AFFECTED BY THE CONNECTOR. AFTER THAT I REPLACED SEAT HARNESS THAT GOES TO THE HVAC CONTROL MODULE. I THEN PUT THE SEAT BACK IN AND CLEARED THE CODES. BOTH THE HEATED AND AIR CONDITIONED FUNCTION OF THE DRIVER AND PASSENGER SEAT WORK. QTY PART NUMBER DESCRIPTION UNIT TOTAL 1 MBEU5Z14A699C WIRE ASSY INTERNAL TOTAL PARTS: 0.00