2016 FORD MUSTANG Complaints

My cars head gasket blew at only 45,000 miles. Replaced my a local well known mechanic for around $3500.00. Now my car at 96,000 miles has blown the head gasket again. I believe the car needs a whole new block. I have seen several lawsuits regarding this and just would love my car running again. This is NOT cheap to fix for me.

On 12/06/2025 I filled the vehicle with gasoline. As I was driving home I noticd a strong odor of gasoline. When I arrived home I parked the car in my carport. A short time later I went outside and noticed that I could still smell gasoline and I looked under the car, which was approximately 3 feet from my house and saw a puddle under it. This could have caused a fire, so I immediately took the car to a repair shop. Approximately one hour later I received a call from the shop informing me that the tank was broken at the top and it would cost approximately $2,600 to replace the tank. The problem was confirmed by Gemba Automotive, Surprise, AZ. I am unaware of whether they have the part available for inspection. There were no warning messages or lights displayed on the driver information system.

From what I can remember its always been an issue with cylinder 3. I was always repaired by Ford Auto Nation of Fort Worth and Auto World Repair 2021 Engine Failure: Confirmed and repaired blown head gasket 2022 Check Engine Light code P303 - Found faulty as well as ignition coil on cylinder 3 2025 Engine Failure: code P303 - Found faulty as well as ignition coil on cylinder 3 Excessive smoke during idle Cracked engine block due to coolant leak through cylinder wall

The contact's daughter owns a 2016 Ford Mustang. The contact stated that the rearview camera was inoperable while reversing. The owner received notification of NHTSA Campaign Number: 25V572000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The vehicle was taken to the dealer, where the contact was informed that the vehicle had passed the recall test, even though the part to do the recall repair was not yet available. Additionally, the contact stated that the rearview camera failure persisted. The vehicle was taken back to the dealer, where the contact was informed that the rearview camera needed to be replaced. The dealer advised the contact that the VIN was not included in a related recall; however, the VIN was included in NHTSA Campaign Number: 25V572000 (Back Over Prevention). The vehicle was not repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The failure mileage was approximately 86,000.

Display screen went out after first back up, camera recall. Camera is fixed under the recall by the dealership shortly after the display screen was intermittently going out until the screen became completely black.

Component/system: Engine (Coolant intrusion into cylinder 1); Inspection available: Yes; Safety risk: Sudden power loss on road; Reproducibility/Confirmation: Dealer verified coolant in cylinder 1 after engine inspection; Manufacturer, police, insurance representatives or others inspections: No; Warnings/symptoms: Check Engine light turned on, error code P0301, higher than normal engine temperature, low coolant in reservoir, white smoke, rough idle at turning of engine; First appeared: Around 100,000 miles.

Coolant intrusion into the cylinder head. This caused a sudden halt of he vehicle which could have caused an accident and loss of life. The engine coolant overheating temperature warning light came on. Vehicle was inspected by ford dealership and found to have blown head gasket. The car is vat for inspection.

Took car to dealership per recall. Touch screen flickering on and off. Can't depend on back up camera. According to dealer "Recall 22a06a was previously completed on TSB 19-2273. and no other repairs were neede at this time. Note, Sync MyTouch screen is blinking on and off at all times and recommend Diag." they replaced APIN and Screen. According to the repair bill. It was still flickering and replaced FDCIN. Screen no longer flickering. it seems to me this is a safety hazard as it affects the viewing of the back up camera with any accuracy and could cause an accident no matter how careful a person is. It also seems to me that Ford knew extra parts my be needed to rectify the situation they should have been included in the orginal recall

My tire is a 255 / 40 ZR 19 model, speed rated 100W. While rotating my tires I noticed catastrophic tread separation on the inner sidewall of the tire. The separation is scattered, not all in one section, and in total covers about 1/4 of the total diameter. The underlying belt package has separated and steel wire is plainly visible at distance. The tire was still holding normal pressure at the time of discovery and there was no indication of the separation from any pressure devices or anything other than visual identification of the issue, which was only possible due to a routine tire rotation. Driving conditions since installation of the tire have been ~85% dry weather at speeds no greater than 85mph. A long haul trip from San Jose, CA to Los Angles, CA (~675 miles round trip) occurred 1.5 weeks prior to discovery.

• What failed & is it available for inspection? Air-conditioning system failure. Loss of cabin cooling; dealer recommends compressor replacement (may include related components pending contamination check). Vehicle is at a Ford dealer now; no repairs performed yet. I requested the dealer retain failed parts for inspection. • How was safety put at risk? I live in Las Vegas; ambient temps ~112°F-120 degrees. This is my primary vehicle for transporting my [XXX] and for my work schedule. With no A/C, cabin temps become dangerously high within minutes, creating a heat-related illness risk (child and driver), impaired concentration, and fatigue during necessary trips. • Has the problem been reproduced/confirmed? Yes. An independent shop first advised compressor replacement. A Ford dealer subsequently confirmed loss of cooling and produced an A/C repair estimate after diagnosis. • Inspected by manufacturer/police/insurance? Inspected/diagnosed by an authorized Ford dealer. I opened a Ford Customer Relationship Center case (XXX) and requested goodwill/after-warranty review. No police/insurance inspection. • Warning lamps/messages/symptoms & onset? No warning lights. Symptoms began with weak/intermittent cooling in early August 2025 and progressed to no cold air. Mileage at failure ~87,279. A/C clutch cycles but cabin air remains hot. (Owner context: original owner, [XXX] Vehicle: 2016 Ford Mustang GT 5.0.) INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)