2008 GMC CANYON Complaints

When sitting at idle, the engine miss & spark knock at times. When start driving down the road the throttle seems hard to Press & takes a little time to reach up to road speed. The truck does not get good gas mileage at all. I had the spark plugs & wires changed still don't help.

Carrier Bearing ( Hanger Bearing) broken off mounts. Bearing is mounted via spot welds. The spot weld were not done properly. Was driving at about 30 MPH slowing down when the bearing broke loose from the mounts. The caused the drive shaft to swing about hitting the floor boards. Breaking the universal joint and drive shaft came apart. There was less that 300 miles on the bearing. The truck typical hauls one bicycle. The truck was not used in any commercial function. I'm retired and like to ride my bicycle. I was very lucky in the that I was slowing down for a light. The road I was one is 55MPH. If the drive shat had hit the ground at that speed I'm certain there would have been a very serious accident involving many vehilces.

BEEN HAVING AN ISSUE WITH THE BRAKE LIGHT SWITCH AT THE BRAKE PEDAL STICKING AND OUR BRAKE LIGHTS STAYING ON. WE NOTICE IT MOSTLY AFTER WE HAVE PARKED THE TRUCK AND TURN IT OFF. THE BRAKE LIGHTS WILL STAY ILLUMINATED, NOT ALWAYS RIGHT AWAY. THE BRAKE LIGHTS STAYING ILLUMINATED HAVE CAUSED OUR VEHICLE TO HAVE A DEAD BATTERY MANY TIMES. THIS ISSUE WITH THE BRAKE LIGHT SWITCH CAUSING THE LIGHTS TO STAY ON HAS ACTUALLY CAUSED US TO HAVE TO BUY 2 BRAND NEW BATTERIES IN JUST OVER A 12 MONTH PERIOD. THIS ISSUE HAS KILLED OUR BATTERY AND LEFT US STRANDED FOR HOURS WHILE WAITING FOR SOMEONE TO COME HELP US JUMP THE BATTERY. THERE IS A RECALL OUT FOR THIS BRAKE LIGHT SWITCH ISSUE, BUT THIS SPECIFIC YEAR IS NOT INCLUDED IN THE RECALL. EVEN THO THIS TRUCK IS HAVING THE EXACT SAME ISSUE THE THE RECALL IS FOR. WE HAVE BEEN DEALING WITH THIS ISSUE FOR OVER A YEAR NOW.

I TOOK MY VEHICLE TO A SMALL BUSINESS OWNER'S GARAGE FOR ROUTINE BRAKE WORK. HE SHOWED ME A CRACK IN THE FRAME ALMOST ALL THE WAY THROUGH EXCLUDING AN INCH. HE FOUND IT WHEN HE TRIED LIFTING THE VEHICLE TO DO THE BRAKES. IT IS BEHIND THE CAB, IN FRONT OF THE BED OF THE TRUCK. ONLY ONE SIDE WAS HOLDING MY TRUCK TOGETHER.

REPAIR SHOP LIFTED VEHICLE TO REPAIR FRONT BRAKES AND THE FRAME BROKE JUST BEHIND THE CAB.

TL* THE CONTACT OWNS A 2008 GMC CANYON. ON SEVERAL OCCASIONS, WHILE DRIVING 55 MPH, THE VEHICLE STALLED WITHOUT WARNING AND WAS ABLE TO RESTART. ALSO, THE DECREASING POWER MESSAGE WAS DISPLAYED. THE CONTACT CALLED BISHOP GMC CADILLAC (400 MACKINAW AVE, CHEBOYGAN, MI 49721, (231) 627-5669) TO NOTIFY THEM OF THE FAILURE. THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE MANUFACTURER WAS NOT CONTACTED. THE FAILURE MILEAGE WAS 56,000.

TL* THE CONTACT OWNS A 2008 GMC CANYON. WHILE UNDERGOING BRAKE SERVICE AT TRADITION CHEVROLET BUICK (847 RTE 5, GENEVA, NY 14456, (315) 789-6811), THE TECHNICIAN DIAGNOSED THAT THE REAR OF THE FRAME WAS ROTTED OUT. THE TECHNICIAN RECOMMENDED THAT THE FRAME BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE FAILURE MILEAGE WAS APPROXIMATELY 143,000.

TL* THE CONTACT OWNS A 2008 GMC CANYON. WHILE DRIVING APPROXIMATELY 70 MPH, THE CONTACT NOTICED A BURNING ODOR. THE AIR CONDITIONER WAS ON SPEED 2 AS SMOKE AND PLASTIC PARTICLES EMITTED INTO THE INTERIOR OF THE VEHICLE. WHILE SWITCHING TO SPEED 1, THERE WAS NO RESPONSE. THERE WAS ALSO NO RESPONSE FOR SPEED 3. THE AIR CONDITIONER FUNCTIONED AT SPEED 4, BUT WAS LATER TURNED OFF DUE TO THE FAILURE. THE VEHICLE WAS DRIVEN TO THE CONTACT'S RESIDENCE AND PARKED DUE TO THE FAILURE. THE CONTACT INSPECTED THE VEHICLE AND NOTICED THAT THE WIRING HARNESS AND RESISTER WERE COMPLETELY MELTED. THE VEHICLE WAS NOT INSPECTED BY A DEALER. THE CONTACT REPLACED THE WIRING HARNESS AND THE RESISTER, AND THE AIR CONDITIONER SPEEDS 1 - 4 PROPERLY FUNCTIONED. THE CONTACT WAS UNABLE TO DETERMINE IF THE PARTS WOULD PREMATURELY FAIL AGAIN. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE AND INDICATED THAT THERE WAS NO RECALL; HOWEVER; THE CONTACT SHOULD TAKE THE VEHICLE TO THE DEALER FOR DIAGNOSTIC TESTING AND REPAIR. THERE WAS A SERVICE CAMPAIGN TO ADDRESS THIS FAILURE, BUT NOT FOR THIS SPECIFIC YEAR, MAKE, AND MODEL. THE FAILURE MILEAGE WAS NOT AVAILABLE. *BF *TR

"FAN BELT PULLEY" I STARTED MY TRUCK AND WAS LEAVING WORK DRIVING ABOUT 10 MPH WHEN THE FAN BELT BROKE. I HAD POWER BUT NO ACCELERATION TO THE TRUCK. LUCKILY I WAS ABLE TO COAST TO A FULL STOP IN THE PARKING LOT. I LOOKED UNDER THE HOOD WHERE I NOTICED THE FAN BELT WAS BROKE. I HAD THE TRUCK TOWED TO MY ACCREDITED MECHANIC WHICH HE SAID THAT THE SHAFT THAT HOLDS THE PULLEY WAS COMPLETELY BROKEN OFF INSIDE THE ENGINE. COST TO ME $600.00

"BRAKE PADS/SHOES" I HAD TO REPLACE THE BRAKE PADS AND SHOES DUE TO THE BINDING, SEQUELING NOISE THEY WERE MAKING. AS A RESULT I HAD TO REPLACE THE ROTORS DUE TO THE DAMAGE. WHEN I FIRST START THE TRUCK AND SLOWLY LEAVE MY DRIVEWAY, I COULD FEEL THE BINDING AND HEAR THE SEQUELING. AFTER DRIVING 20 MINUTES THIS ALL GOES AWAY. REPAIRS $500.00 WHICH IT DRIVES 100 PERCENT BETTER!