2021 GMC SIERRA 1500 Complaints

On the afternoon of 01/20/26, I was merging onto the highway in my 2021 GMC Sierra 1500 when a loud bang was heard from the engine compartment at approximately 60 mph. Immediately after the ban was heard, several indicator lights on the dashboard were illuminated, including the ESC, check engine light, and parking brake light. A power loss was felt when attempting to accelerate and the banging noise worsened anytime the accelerator was depressed. I was able to drive the vehicle to the nearest GM dealership that coincidentally was at the closest exit off of the highway I was traveling on. The dealership performed diagnostic and determined that the damage was caused due to the ongoing GM recall associated with Safety Recall N252494000. My vehicle had previously been inspected as part of the recall and was found to have passed. Vehicle had been driven approximately 4,000 miles after recall was performed.

The engine has a knocking sound. I took it into the dealer and they replaced the exhaust system thinking that was the problem. However, the knocking still happens intermittently. I have video documentation of the noise.

1-At approximately 40,000 miles, my transmission was replaced under warranty. It had been failing since approximately 2000 miles having a very hard time shifting between first and second gear. It was finally replaced at 40,000 miles. 2- At approximately 45,000 miles I took my truck into the dealership for this latest recall on the 6.2 L failure for inspection. Vehicle is inspected and I was told I would need to have an engine replacement. I was told that there was no ETA on when a replacement engine would be available and that I would be contacted when one was. Afterwards I was sent back home in the truck they just inspected for potential engine failure and said had a bad engine. As of now, I’m still waiting on a word of a new engine and my truck is still operating, but leaves me concerned that it could fail at any moment while driving it.

For the second time since I have owned the vehicle that was purchased brand new. The engine seized during driving on the highway and began making loud noises that was knocking and jerking the vehicle. The issue occurred initially around 15,000 miles and was diagnosed as lifter failure, was repaired and returned in July 2022. At 64,000 miles on January 15, 2026, while on an interstate the engine did the same thing and the vehicle went into limp mode. It has been diagnosed as lifter failure this second time and is awaiting appropriate repairs. Both incidents put myself in passengers at danger due to the nature in which the vehicle entered limp mode on the highway.

There is an active recall for the 6.2 L engines, which is what I have and it’s an issue with burning oil and catastrophic engine failure due to rods and bearings. And I just got this vehicle in November and I have already went through 15 quarts of oil in two months so I’m waiting for my engine to blow up going down the road to cause a wreck like has happened to multiple vehicles already and I also have a rod knock now due to this issue so it could be any time now that my engine fails and I end up getting hurt or my family I took it to the Chevy dealership and I have called GM to do an oil consumption test and to put in a claim so that way if it does fail, then it has paperwork to follow, but it is a major safety concern but something needs to be done considering there’s already 600,000 recalls on this issue already there needs to be more for the rest of the people that are having this issue like myself and I’m spending $50,000 on this truck for the engines to fail and me end up dying before something‘s done. and it’s also very distracting as you’re driving down the road and your vehicle tells you that you’re low on all so you have to try to find a way to get off the highway to have someone bring you all so you can continue to drive and it’s not just a cordial. It is up to 5 quarts of all at a time.

Truck went in service 9/17/2025 because the wheels locked up while driving. Transmission was replaced. Picked up truck and 2 hours later the truck shut off while driving and was started back up and was limp mode. Was told wire chaffing and they taped and rerouted wires. Picked truck back up and next day it did the same thing. Took back to the dealer and they said wires again. They taped wires back up and we picked up the truck. We had it 7 days and while driving down the expressway the whole truck shut off and would not start up again. Clearly that is a safety issue. After sitting on the side of the expressway for 10 minutes it started up again and was in limp mode and taken to the dealer again. I don’t know what has been done to it yet as they are not great at communication but they have had our truck for 4 months minus the 7 days we had it before it had to go back to the dealer.

The contact owns a 2021 GMC Sierra 1500. The contact stated that while driving 5 MPH, the vehicle lost proper steering ability, and the steering wheel became loose and spun around in a circle. The air bag message was later displayed on the instrument panel. Upon inspecting the vehicle, the contact discovered that the bolt connecting the steering shaft was missing. Due to the failure, the vehicle was towed to a dealer, where the cause of the failure was confirmed. The contact was then informed that there were no recalls or warranties on the vehicle. The manufacturer was notified several times about the failure and agreed that the part should never fail. However, the manufacturer then stated that the owner of the vehicle was responsible for the repair. The vehicle remained with the dealer unrepaired. The failure mileage was approximately 80,000.

Unexpected rear wheel lock-up at 29000 miles. While engine braking from highway speed onto an off-ramp at approximately 50 mph, the rear wheels unexpectedly locked up. Due to prior rear brake actuator issues, I suspected the emergency brake had activated without my input. It was only momentary, and no fault codes or warnings were displayed. It happened again under the same circumstances two months later, with no fault codes. On May 9, 2025, the check engine light came on, and I scheduled service. The dealer addressed a recall regarding the transmission by installing software. In August 2025, I received a letter from GM regarding recall N242454440 for excessive wear in the transmission control valve, which was causing rear-wheel lockup. On October 31, 2025, while towing a small enclosed trailer at 70 mph on the highway with cruise control engaged, the truck suddenly decelerated, and I was nearly rear-ended by a semi-truck (no brake lights to warn them). The truck would not go over 50 mph unless I was going downhill. The transmission would not shift into higher gears. I returned it to the dealer, who checked the computer and found no record of the incident, so they said there was no problem. They informed me that the new software was designed to limit the truck's speed if a potential lockup was detected. This recall did not fix the transmission problem or the safety issue. It was simply a way to avoid costly repairs. There is a problem with the physical transmission valve that, for me, resulted in an extremely dangerous situation. The NHTSA needs to take this issue seriously and require GM to replace the prematurely worn valves in the affected vehicles.

Left rear parking brake actuator malfunction. The truck would brake unexpectedly. The brake would not completely release at times. Took it to the dealer on June 6, 2024 and they replaced the rear rotors and pads. I asked them if the parking brake actuator was faulty and may have caused the premature wear. They laughed and said no, it wasn't possible. On Aug 7, 2024 I returned the truck to the dealer with the fault codes C1114 & C060B caused by a failure of the parking brake actuator. It was impossible to use the emergency brakes when the codes were present. For several months after the repair, brake faults would appear and disappear randomly. Took it to the dealer, and they found nothing wrong. Electric-actuated emergency brakes should be illegal.

The front camera stopped working, causing the safety systems to shut off. Codes U026A & U0078 "no communication failure". The camera was ordered and replaced.