2024 GMC SIERRA 3500 Complaints

Windshield issues. Small debris creates significant chips and cracks on windshield. In 30 years of owning vehicles I have never had a chip. Had this vehicle one year and 3 significant cracks and three chips. Anything that hits the windshield does damage. Very dangerous issue that needs addressed. A windshield is a safety issue and one that cracks so easily is completely unsafe!

The contact owns a 2024 GMC Sierra 3500. The contact stated that the exterior lights of the vehicle were flashing erratically, and the tailgate was opening unintendedly. The contact stated that while driving at various speeds, the vehicle experienced erratic transmission shifts, and the vehicle was jerking and made an abnormal clunking sound. The check engine warning light was illuminated. The contact pulled over to a truck stop and parked the vehicle. The contact stated that the battery became fully drained while parked with the windows rolled down in snowy weather. The contact stated that after waiting 6 hours for AAA to arrive, the vehicle jump-started. The contact stated that the battery had drained on several occasions. The vehicle was taken to the dealer, where it was diagnosed that the two batteries needed to be replaced. The vehicle was repaired; however, the failure persisted, and the vehicle overheated while driving. The contact stated that GMC OnStar was contacted and informed the contact that diagnostic trouble codes related to the transmissions were retrieved. The vehicle was taken to another dealer Weston Buick GMC (22555 SE Stark St, Gresham, OR 97030) to be diagnosed. The vehicle was being diagnosed. The vehicle was not repaired and remained out of the contact's State of residence. The contact related the failure to an unknown recall; however, the VIN was not included. The manufacturer was notified of the failure and covered vehicle rental expenses that allowed the contact to return to their residence. The contact stated that the vehicle was used for load transportation, and the failure had caused both the contact and her husband to be stranded while delivering loads, which caused lodging expenses and loss of wages. The failure mileage was unknown.

The contact owns a 2024 GMC Sierra 3500. The contact stated that while driving at various speeds, there was an abnormal knocking sound coming from the vehicle. There were no warning lights illuminated. The vehicle was taken to a local dealer where it was diagnosed; however, the cause of the failure was not yet determined. The contact was advised by the local dealer that the engine might need to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 100,000.

The contact owns a 2024 GMC Sierra 3500. The contact stated that while driving at 30 MPH, there was a loud pop and the vehicle jolted, after which the vehicle started to lose motive power. The contact was able to pull over to the shoulder of the roadway, where the failure persisted. The check engine warning light was illuminated. The vehicle was towed to the dealer, who diagnosed a failure with the transmission valve body. The vehicle was not repaired due to a lack of parts availability. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the NHTSA Hotline for assistance. The failure mileage was 63,000.

Transmission has a bad vibration at low RPMs under acceleration as well as slipping and hard shifts. A few times the transmission has locked up the briefly. It also runs very hot between 180 and 249 degrees. Have been researching this when I came across all the problems and recalls however nothing listed for my VIN

The Vader Chrome on the front of vehicle is peeling. This includes the grille and surrounding areas. This area has been inspected by a representative at GMC and at a dealership. GMC refuses to stand by their product.

Nothing has happened so far but I believe they have an issue with the Allison transmission. When you first start off in the morning driving slow the transmission shifts hard with a thump. I've taken it in to the GMC dealership in Ft. Walton Beach, Florida and they kept the truck overnight and said everything seems to work as it should. I just traded my 2021 gmc 3500hd dually with 130k miles on it and never heard that or ever had an issue so I'm not sure what changed since then? I'm not sure what you guys can do to look into it? Thank you [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Car will not turn off and will display "Shift to Park". Similar recall on other models. This has gotten worse and happens most of the time now.

Breaks and/or drive train. It is available for inspection. 1) Breaks sink causing slowed break time and decreased breaking ability. If the breaks are "pumped", more often than not, they will come back up to full pedal. However, in an emergency breaking situation, there is not time to "pump" the breaks. I was nearly in an accident recently when the break pedal would not stop the truck in time, due to the soft break pedal. I literally had to steer to the shoulder of the road. 2) When placing transmission in Drive or Reverse from the park position, then taking foot off of break pedal, there is about a 1 - 2 foot roll, then the truck stops as if the e-break has been engaged (but it is not engaged). By tapping the accelerator, it will "break free" (with a popping sound and a slight "jerk" in the truck) and then roll fine. This does not always happen ~ guestimate of about 10% of the time. 3) I don't know if this is related, but when I set the Drive Mode to "Normal", it automatically goes to "Off Road" ~ this happens no matter the driving conditions. This isn't safety related necessarily, however, it may be a part of the total problem.... It also decreases my fuel economy. I took the truck to the local GMC dealer/shop. They said the truck had 2 recalls and they took care of those. They believed one of the recalls would help solve the "sticking" when placing in Drive or Reverse ~ it did not. They also (supposedly) checked the breaking system and took it for a test drive. They said the breaks were fine. I doubt this happened as the soft break pedal and the need to "pump" the breaks to bring them to full pedal is completely obvious. I took the truck home after the inspection and recall. The same issues continued, so I took it back to the shop where it was inspected again. Again, I was told everything was in working order ~ it is NOT! There are no warning lights that I can find to indicate there is an issue. I'm begining to think that I should have bought a Ram Truck...

First incident we were driving on the interstate towing a fifth wheel RV, and several warning lights illuminated before everything just shut down. Manage to get to the side of the road. Vehicle finally restarted and the rest of the trip was uneventful. Second incident, vehicle had not run for two days, got in and while the starter cranks, the engine will not start or run. Engine/Transmission service and fuel system service messages showing on app and on email from OnStar. Vehicle requires towing to dealer.