2020 GMC SIERRA 3500 Complaints

View complaints related to 2020 GMC SIERRA 3500. The complaints found here are submitted by actual consumers with first hand experience. There are more than 50 complaints submitted for the 2020 GMC SIERRA 3500. You can submit your own complaint to the NHTSA or call the Hotline, Monday-Friday 8am to 8pm at (888) 327-4236, TTY: (800) 424-9153.

  • 2020 GMC SIERRA 3500
    - Evans City, PA

    My truck has been exhibiting hard downshifting at certain speeds, when the powertrain loads up such as a grade change, and requires a downshift. I have complained about this issue to the dealership as early as 2022, and 33,185 miles. The dealership made me pay for a transmission $388.90 flush which did not resolve the issue. The problem has become progressively worse, to the point where the toll road transponder fell of my windshield during a recent harsh downshifting incident. At the same time there was an existing MIL and derating for a DEF heater and NOx sensor failure, so during a warranty visit I asked that this transmission issue be addressed. On Friday March 13, the dealership called and said they confirmed the hard downshifting, albeit not as extreme as I described. The technician said that the valvebody needs to be replaced. At the same time, they performed a TCM flash for the 10L1000 momentary wheel lockup recall. The dealership then said they could not get the truck to set a P0747 code, said that GM refuses to replace the faulty valve body, and recommended I take the vehicle home unrepaired, and to come back when the P0747 code is set. I requested they continue to drive the vehicle. Today March 20 the dealership called and said they could not get the code to set, and that I need to drive the truck and come back when the code appears, despite the truck exhibiting clear symptoms of a progressively wearing feed limit low valve. N242454441 does NOT seem to indicate a P0747 code is required to replace the valve body. This vehicle is not safe for towing a 20,000+lbs and GMC is refusing to repair a transmission with symptoms congruent with N242454441. The dealership still has possession of the vehicle and wants $360+ in diagnostic labor.

    Source: NHTSA WEB SITE
  • 2020 GMC SIERRA 3500
    - Phoenix, AZ

    Known defect with 2019 and now 2020 GMC sierra trucks. Design was updated for 2021+ which has corrected the seal failure defect. GM has issued a service bulletin to dealers about how to repair the problem. Back window is leaking water. Defective seal noted by GM. GM is only covering the cost of repair if. Vehicle is still under 3/36 warranty. If outside your warranty cost from dealer to owner is $2500 to $6000. A known design failure GM recognized and took steps to change the design for future. Vehicles but will not stand behind vehicles that have this defect. Would like the cost to the repair fall back to GM to cover. Bulletin # 18NA383 [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

    Source: NHTSA WEB SITE
  • 2020 GMC SIERRA 3500
    - leavenworth, WA

    the engine seized at 65mph. available for inspection. was left stranded in a limited access area with no cell service. there was no warning, the engine just stopped at highway speed and would not restart. the problem was confirmed by an independent service center. they couldnt identify which component had failed without a costly teardown. occurred at 112,000 miles, past the 100,000 mile powertrain warranty.

    Source: NHTSA WEB SITE
  • 2020 GMC SIERRA 3500
    - Cedar Valley, UT

    The contact owns a 2020 GMC Sierra 3500. The contact stated that while driving at an undisclosed speed, the vehicle inadvertently went into LIMP Mode. There was no warning light illuminated. The vehicle was taken to the dealer, where it was diagnosed that the transmission valve body sensor had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure and referred the contact to the NHTSA Hotline for assistance. The approximate failure mileage was 130,000.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2020 GMC SIERRA 3500
    - Sweetwater, TX

    The contact owns a 2020 GMC Sierra 3500. The contact stated that while driving at 60 MPH, the rear differential seized, in addition, the contact was hauling a median size tracker on top of a flat bed. The flat bed jackknifed and hit the left side of the contact's vehicle. The vehicle was able to come to a stop. The air bags did not deploy. There was no warning light illuminated. A police report was filed. There were no injuries sustained. The vehicle was towed to a towing yard. The trailer was towed to the residence. The tractor was damaged in the accident. The vehicle was diagnosed by an independent mechanic. The contact was informed that the transmission had failed. The vehicle was not repaired. The insurance company was contacted. A claim was filed with the insurance company, and it was canceled a few days later by the insurance company. The manufacturer was not notified of the failure. The failure mileage was approximately 108,000.

    Source: NHTSA WEB SITE
  • 2020 GMC SIERRA 3500
    - Exeter, MO

    The contact owns a 2020 GMC Sierra 3500. The contact stated that while driving 45 MPH with passengers seated in the rear seats, the passengers became aware that water was entering the vehicle between the window and frame. There were no warning lights illuminated. The vehicle was taken to the local dealer, who informed the contact of Technical Service Bulletin: 18-NA-383. The vehicle was not diagnosed or repaired. The manufacturer was contacted and confirmed that there was no special coverage or warranty coverage on the vehicle. The contact was referred to the NHTSA Hotline for assistance. The failure mileage was approximately 50,000.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2020 GMC SIERRA 3500
    - Zebulon, NC

    LT275/65R20 While driving Westbound on I87/US64/US264 at the on ramp of US64 business at highway speeds, the driver’s side rear tire tread de-laminated from the belts of the tire. Observed the entire tread airborne in rear view mirror. Pulled over to shoulder and observed for damage to other vehicles, no vehicle was hit but drivers did have to make evasive maneuvers to avoid debris. Tire remained at required PSI, thus did not deflate. Drove vehicle ¼ mile to ** exit to look for safe parking. Called AAA and had vehicle towed to residence. No police report filed. Reported incident to insurance agent in the event of a subsequent damage claim by other drivers. Tire was inspected by ** Tire and confirmed tread had indeed de laminated from tire core. Clear failure of factory tire mounted on factory wheels with no suspension or drive train modifications. Vehicle was totally stock at time of the incident. The safety of the other drivers on the road could have been significantly impacted had the tread hit their windshield or front tire. The violence of the tire separation was similar to an impact with large road debris. The vehicle suffered significant damage to the drivers side truck bed, bumper, sensors and wheel-well. Local tire company confirmed failure mode of tire. Vehicle had received required annual NC State safety inspection, by certified inspection station, including tires on April 30, 2025. There were no warnings prior to incident, visual or audio. The tire(s) involved are available for inspection, as owner has retained all 4 tires at time of replacement.

    Source: NHTSA WEB SITE
  • 2020 GMC SIERRA 3500
    - Raceland, LA

    Engine started skipping, then service parking brake light came on, then service engine light came on and speed dropped to 44 mph.

    Source: NHTSA WEB SITE
  • 2020 GMC SIERRA 3500
    - Fort White, FL

    My IntelliBeam function stops working sometimes, I can still use the lights as normal but the IntelliBeam function stops every so often and starts working after about 2 to 10 mins. Lane departure warning stops every so often and will start working after 1 to 10 mins, I have noticed that when it stops working at night time then the IntelliBeam function stops working also. When I press the on/off button for lane departure then it will say that lane departure is unavailable right now. I have been getting a p20ee code showing something is wrong with SCR nox sensor 2. Scan tool reveals that the sensor works normal and then stops. Once I clear the code then it works good for a few days.

    Source: NHTSA WEB SITE
  • 2020 GMC SIERRA 3500
    - Belton, TX

    Valve body failed while pulling my camper down the interstate. Transmission began to have issues and locked up on us while driving. Luckily i was able to avoid any accidents. Had truck towed to a private Transmission shop to have the transmission repaired. Shop advised the failure was due to the faulty valve body.

    Source: NHTSA WEB SITE