2013 GMC YUKON Complaints

View complaints related to 2013 GMC YUKON. The complaints found here are submitted by actual consumers with first hand experience. There are more than 160 complaints submitted for the 2013 GMC YUKON. You can submit your own complaint to the NHTSA or call the Hotline, Monday-Friday 8am to 8pm at (888) 327-4236, TTY: (800) 424-9153.

  • 2013 GMC YUKON
    - Royal Palm Beach, FL

    UNKNOWN. Truck would not move out of gear as the gear shift was just moving up and down and not catching any gears

    Source: NHTSA WEB SITE
  • 2013 GMC YUKON
    - Cincinnati, OH

    Stopped at a light and went to pull off when the light turned green and the car would not move at the speed of gas I was giving it coasted into the Intersection. I had to turn the car off in the middle of an intersection, restart it and shift back into drive as I got down the road it did the same thing I’ll be in drive and go to apply gas and seems as though the transmission slips causing unsafe driving.

    Source: NHTSA WEB SITE
  • 2013 GMC YUKON
    - Ames, IA

    The truck locks start locking and unlocking on their own, the stabilitrac and traction control will cycle between on and off, the motor will shut off, it goes to limp mode, check engine light comes on, traction control light comes on, abs light comes on, it has stalled in drive throughs on the interstate, driving around town, the vehicle is at pat clemons gmc in boone iowa, they replaced the bcm and it is still happening, there is an nhsta campaign #14V61400 for a chassis control module recall, this vehicle vin is not in that, but it does exhibit all the symptoms mentioned in the recall, very much a safety issue as it can happen anytime, especially when it is raining or snowing, started about a year ago

    Source: NHTSA WEB SITE
  • 2013 GMC YUKON
    - Sheboygan Falls, WI

    I call this a "Panic breaking defect" I have experienced this on two different GMC vehicles manufactured 14 years apart. The first was a 1999 GMC suburban with mechanically operated throttle control. The second was my present GMC Yukon XL Denali with electronic throttle control. The defect: The close proximity of the accelerator pedal to the brake pedal makes it possible to have the right foot on both pedals at the same time. This results in high engine RPM and full breaking pressure, however, the anti-lock breaking system releases and re-applies the break pressure repeatedly allowing the vehicle to lunge forward a short distance on each cycle. To remove ones foot from the both pedals so as to apply it to just the break would result in the vehicle, engine being at high RPM, to allow the vehicle to speed forward resulting in a serious collision. True one could use the left foot, if able, on the break and then remove the right foot, allowing the engine to return to idle but on modern automatic transmission equipped cars where the left foot plays essentially no part in driving, such an action is not likely to occur. Also the ignition key could be turned off but with both hands employed to apply maximum pressure on the steering wheel to ensure maximum braking effort, that is not likely to occur either, besides that would result in lack of power steering and vacuum boost to the break system. A proposed solution: In a drive by wire environment it would be simple to send an idle signal to the throttle body every time the break pedal is pressed and this is the condition which occurs in a normal breaking situation. I have related this to the service manager of my local dealer and have also communicated it to General Motors Customer Support even offering to demonstrate the problem but have received no response. After all I am only a lowly customer and it matters not that I am also a retired Engineer!

    Source: NHTSA WEB SITE
  • 2013 GMC YUKON DENALI XL
    - Denver, CO

    The contact owns a 2013 GMC Yukon Denali XL. The contact stated that while at a stop light, the vehicle suddenly started fluctuating while idling. The A/C was activated and the contact noticed that the vehicle was not being cooled inside the cabin. The contact stated that the failure recurred the following day. The contact stated that while attempting to make a right turn, the vehicle lost power steering functionality. The contact turned off the vehicle and shifted into park(P). The contact restarted the vehicle and the A/C unit independently turned off. Additionally, the vehicle regained power steering functionality and the vehicle idled as designed. The contact had not taken the vehicle to the dealer to be diagnosed or repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 138,000.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2013 GMC YUKON
    - Denver, CO

    Monday 5th 2022, (2pm)I was driving with the AC on high as I had just left the mall. The interior was hot. As I left the mall and came to a stop light...the car would rev at stop, and continue to do so until the light changed. I had the oil and transmission fluid changed at 135000. It is currently at 138000. I turned off the AC because it did not seem to work (to cool the car down) and rolled the windows down and open the sun roof. Tuesday 6th, I was leaving the store (4pm) and again I turned the AC on and approached a stop light. When I stopped at the light, the car started revving or idling in pulses again as it did on Monday, however as I went to turn right onto the street, there was no power steering at all. Startled, I pressed the brake, shifted into park, turned the SUV off. Then restarted the SUV and the steering had returned to normal. I kept the AC off and drove home.

    Source: NHTSA WEB SITE
  • 2013 GMC YUKON
    - Hahira, GA

    Was told by my local dealer that they did not have to complete to recall unless I signed a document holding them blameless if they cracked my dashboard or cracked it worst than it already is. I declined to sign until I could investigate why I absolutely had to sign a document absolving GM of their bad design. I believe it to be unjust and insulting that we are required to choose between the safety of our vehicles vs the possible destruction of the interior due to GM's poor design. I did not get a picture of the document before I left the dealer but was told I could bring it back later if I wanted it fixed but I would have to sign the document.

    Source: NHTSA WEB SITE
  • 2013 GMC YUKON
    - Fort Smith, AR

    In my 2013 Yukon Denali XL the dash has cracked. It is very common for these to crack over time and I think they should fix it. Also the seat on the driver side is torn.

    Source: NHTSA WEB SITE
  • 2013 GMC YUKON
    - Garfield , MN

    On Feb.21-2020 cracks were noticed on all four tires [ only 11,000 miles ] and rubber started to fall off [separation] pics att. With side walls cracking, are these tires safe? [ from blow out ]? I am a senior cit. and do not have the $1500. to replace these four tires, is there a recall? Continental Tire needs to pay $1500. to me or replace, balance and install all four tires at no charge to [XXX] INFORMATION Redacted PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6). Tire company wants consumer to pay to have these tire replaced.

    Source: NHTSA WEB SITE
  • 2013 GMC YUKON
    - Reading, PA

    The contact owns a 2013 GMC Yukon. The contact stated that while driving approximately 35 MPH, the air bags inadvertently deployed. The contact stated that there were no warning lights illuminated. The contact stated that he was not involved in any crash and did not know what caused the failure. The contact stated that there was no injury. The contact stated that he then rolled the air bags up in order to be able to see as he drove the vehicle to his residence. The contact stated that he contacted the dealer who informed him that the failure was not related to NHTSA Campaign Number: 21V054000 (Air Bags). The contact stated that he had not contacted the manufacturer. The failure mileage was 190,000.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE