2025 GMC YUKON Complaints

The contact owns a 2025 GMC Yukon XL. The contact stated that the rear passenger-side second-row seat failed to move or close. The contact was concerned about the warranty expiring soon. The vehicle was taken to the local dealer, where it was determined that the seat needed to be replaced; however, the part was backordered and had not been delivered. The vehicle was not repaired. The manufacturer was not contacted. The failure mileage was approximately 55,000.

On May 6, 2026 while driving on the interstate, the vehicle automatically shifted into Neutral, and lost all engine power. The vehicle would not shift back into drive or even 4x4 neutral to be towed. The vehicle was towed to Sam Boswell GMC in Mt Dora, FL. The engine had seized up, and there were metal shavings in the oil filter which indicated a catastrophic mechanical engine failure.

Driving the vehicle with my family in it on merrit parkway in ct 230 am on May 10 th Car rpm start going up and making noises and felt like gear not shifting in few seconds later car all sudden on its own shifted to neutral as my speed 55-60 mph was during that moment. And screen on dash went blank dark .i was able to move to side of the road safe as possible .road is only two lane and no room to park on side . Immediately turn hazards lights on and try to restart the car and vehicle will not turn on . State troopers came and assisted us till tow truck came and vehicle get towed to dealer

My engine completely failed on March 19, 2026 and it is currently at Sterling GMC in Bryan Texas waiting for a backorder engine as it needs to be completely replaced

Driving 79 mph total engine seizure. Check engine light came on and seconds later a low oil pressure light and turn off engine. Engine died and went into neutral and had to coast to side of highway in middle of nowhere at 11pm at night.

My 2025 GMC Yukon's infotainment system has repeatedly failed. The huge center screen frequently goes black upon starting the car. Once the screen goes black you are unable to control literally dozens of the vehicle's features including but not limited to climate controls, safety features, heated/ventilated seats, gps, lane assist, the radio, no backup camera, etc. When the screen blacks out, the vehicle automatically turns the heat on to 76 degrees every single time and blows hot air from the front windshield defogger vents only. The list of features controlled by the touch screen is quite enormous. I have taken the vehicle to the GMC dealer four (4) times for software updates, none of which solved the problem and they have admitted they have no fix for this issue. The issue is widespread, as I have encountered literally hundreds of owners online like myself dealing with the very same problem; brand new cars that just do not work. GMC has done absolutely nothing to get to the bottom of this.

Im hearing ticking sounds when starting the engine and I reported it to my dealership service department and thay said thay don't see any issue

Engine failure while driving at 60mph that started with a loud knocking sound to eventual engine failure where it wouldnt turn over. Vehicle has 9600 miles and has had issues since day one of leaving lot requiring fuel injector, intake manifold gasket, lifter and rod with last fix being new coil and spark plug that supposedly fixed issue. The most recent engine failure put my family and kids in danager given 100 degree weather in middle of desert on a small highway with very limited cell service. Vehicle provided no warning lights. Vehicle was towed to dealership and I have not received an update. Vehicle has not been inspected by polive or insurance or others.

Engine failed, no check engine lights turned on. Needed to have the truck towed to a dealer

Purchased new August 29, 2025 On 12/3/25- Mileage 4495. Took vehicle in for first maintenance service. Tire rotation and oil change. On 1/7/26- Reported grinding noise we had began noticing when starting vehicle. Engine light Service ESC. Service Traction control. Reported to Ben Mynatt GM. On 1/8/26 Mileage 7120- Took Yukon in for service due to grinding noise. Due for 6 module updates and 3 stand alone updates. On 2/16/26 Noticed ticking noise when heat in on high. Scheduled service for 2/26. On 2/24/26 Smell from car, oil reporting low. Dip stick completely dry. Sent email and photos to Ben Mynatt Service. On 2/26/26 Took vehicle in for service. Service advised to start oil consumption test. Ordered blower motor for the squealing noise. Cyl 3 misfire. Was told by the dealer, possibly needs engine 2/27/26 Took Vehicle in for service Check engine light on. Bearing inside blower motor and blower motor replaced. Replaced coil cyl 3 Tire Rotation 2/28/26 Car shaking, smoking, engine light on. Terrible smell from exhaust. Engine light came on, Service ESC, Service Traction Control, Forward Collision Unavailable, Reduced Acceleration Drive with Care Alert. GMC Alert: Service the engine and transmission system immediately alert, Engine Light on. Vehicle Approx miles. Codes misfires to cylinder 3. Took vehicle right to Service Dept. Codes Cleared. Replaced coil on cyl 3 March 7th - Mileage 11,200 Car shaking vigorously! Engine light flashing. Loud knocking coming from vehicle. GMC alert: Service the engine and transmission system immediately alert. Emission system- service now. Engine and Transmission System Service now. Service antilock braking, Stabilitrack stability control systems and airbag system. Service Air Bag System. Emailed to Service March 9th. Took vehicle in. Cylinder 3 & 8 misfire code cold start rough idle code. Oil consumption using approx1 qt of oil/500 miles. Vehicle unsafe risk of engine seizure, fire risk and loss of acceleration is extreme danger