2025 GMC YUKON Complaints

The contact owns a 2025 GMC Yukon XL. The contact stated that while driving 15 MPH, there was an abnormal grinding sound coming from the engine. There was no warning light illuminated. The vehicle was taken to a local dealer to be diagnosed, and the contact was informed that there was a catastrophic engine failure caused by the thrust bearing. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The contact referenced Technical Service Bulletin: 25-NA-307; as a possible cause for the failure. The failure mileage was 16,184.

Engine (L87) blew up on I-80 in passing lane with no warning 14,635 miles. Almost got hit by several cars trying to get off the interstate. Sat alongside the road for 1 1/2 hours until tow truck arrived in 101 degree weather. GM provided no roadside assistance since it was a Sunday. They were incorrect with their information which caused us to walk to nearest Walmart several miles. We were 5 1/2 hrs from home and our son picked us up. GM dealer installed new engine and we were without our vehicle 45 days with no alternative transportation provided. Our repurchase was denied and was incorrectly done so by Iowa State Lemon Law (purchased in Iowa)

The contact owns a 2025 GMC Yukon. The contact stated that while driving at an undisclosed speed, the engine seized. No warning lights illuminated. The vehicle was towed to a dealer, where it was diagnosed that the engine, radiator, and an unknown belt needed to be replaced. The vehicle was repaired; however, the failure recurred. While driving at an undisclosed speed, several unknown warning lights illuminated, and the engine seized upon arriving at the dealer location. The vehicle failed to restart. The dealer diagnosed that the generator and air conditioner failed and needed to be replaced. The vehicle was in the process of being repaired. The manufacturer was notified of the failure, and a case was opened. The failure mileage was approximately 33,018.

As my wife was driven she heard some noise and notice she was losing power. She pull off the side of the road and the car shut off. Could not restart. This happen about 11:30 am on 8/14/26 Got towed to Salida Dealer called Faricy GMC about 3:30 pm. Dealer said it was a complete engine failure and engine needed to be replaced.

Vehicle loss of power on the Interstate at a high rate of speed. Vehicle would not start and could not be put in Neutral to safely remove from road.

During first oil change at 1200 miles, found a lot of metal flex in the oil filter element after cutting the oil filter open.

The progressive failure of the factory steering wheel adhesive on my 2025 GMC Yukon creates an immediate, active safety hazard during vehicle operation. The material failure and sticky glue are localized directly around the integrated heating element of the steering wheel. This failure severely impacts driving maneuvers as well as a potential electrical fire hazard. The liquefied glue residue is incredibly sticky and continually transfers to the driver’s hands, resulting in a compromised, slippery grip on the steering wheel. During active driving maneuvers, such as hand-over-hand turning, navigating sharp curves, the loose edges of the peeling leather and separating trim physically catch on the driver's palms. This restricts smooth wheel rotation, disrupts natural hand movement, and threatens a sudden, temporary loss of steering control. This manufacturing defect introduces severe driver distraction and physical interference with critical steering components while driving, compounded by a potential thermal or electrical defect in the steering wheel heating assembly.

GM performed a vehicle wide Over the Air reprogramming of the modules incorporated in the VIP/Global B electronics platform in April, 2026. Following that my vehicle became totally dead. Key fob would not unlock the vehicle. Had to use the metal key, open the drivers door. Opened the door, nothing moved. No lights, no movement from anything on the vehicle. Opened the hood, charged the battery and tried to crank it. Would not budge. Starter would not engage. Disconnected the negative battery cable. Tried again. Still would not budge. After an hour of so of trying and using jumper cables from our other vehicle, still would not budge. I disconnected the negative battery cable from the right front fender ground and reattached it. It then cranked. Drove the vehicle 30 miles at interstate speed. 8 miles in city traffic. Drove home and parked it in the garage. Drove it abput 10-12 days later to get breakfast. Parked it, locked it with the key fob. Came back after getting food, key fob would not work. Opened it with the button on the door handle. Got In tried to crank it. Would not budge. Disconnected the negative battery cable twice, before it cranked, but would not drive. Message in dash said vehicle could not be driven. Finally got it cranked. GM never advised that the battery must have a 70% charge at all times for the electronics to work. Owner's manual contains no such statement. Vehicle is defective to the extent that it will leave me stranded in wherever the battery power is less than 70%. Dangerous to get stranded at night on a lonely road or highway, away from cities with tow trucks and competent service personnel. Vehicle in shop 32 days before dealer advised resolution. Modules bricked requiring engine control module and telematics module replacement.

The contact owns a 2025 GMC Yukon. The contact stated that while the vehicle was shifted into reverse, the rear-view camera displayed a black screen. The image in the rear-view camera was not visible, specifically in areas where there were reflective lights. The dealer was contacted and assisted the contact with the brightness options on the rear-view camera and stated there was no failure with the camera. The camera was not repaired or replaced. The manufacturer was made aware of the failure. The failure mileage was approximately 16.

On multiple occasions the center screen has been non operational when we start the car and just shows a black screen. The volume knob and screen power button are non-responsive. When this occurs the backup camera is inoperable, which is mandatory safety equipment. the HVAC also cannot be adjusted which could cause a windshield fogging condition which is a safety concern. The vehicle has been to the dealer 3 times for screen problems and the issue has not been resolved. When this occurs the problem persists for a few ignition cycles or for up to a couple of days and then will start functioning again. We have not been able to determine any specific condition that is causing the failure.