2025 GMC YUKON Complaints

Vehicle went into limp mode while driving on the highway. Onstar said it was the transmission. Checked the oil and smoke was billowing out of the dip stick and there was no oil. None of the sensors indicated that there was low oil. After sitting and waiting for a tow truck rechecked the oil with the dipstick and there was oil in it. Now requires a new engine.

The car was purchased on 8/15/2026. On November 6th 2026 with 3051 miles on all the gauges, electronic dashboard, gps , climate controls, heads up display failed while car was in driving. There was no way to tell what speed the car was going, the gas level, rpms, engine temperature, etc. Navigation failed, Cruise control failed, I was unsure if the emergency braking system failed. The dealership responded there was over 27 error codes on the car computer. There was no way of knowing if the signal lights were working. There was no prior warning to this failure. The GMC service department at the dealership confirmed the failure and said it needed to replace the radio control module. It took 70 calendar days for a replacement module to be provided, and a new software patch was uploaded after several attempts. After the vehicle was repaired the dealership acknowledged that they have been seeing this problem. GM has failed to provide any other assistance.

The contact owns a 2025 GMC Yukon. The contact stated that while driving at an undisclosed speed, the vehicle unexpectedly went into LIMP Mode with a limited speed availability message displayed. The vehicle was restarted; however, the failure recurred. The vehicle was taken to the dealer, where it was diagnosed with engine failure. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 8,837

The 3.0L diesel motor failed around 5700 miles. The thrust bearing failed and the engine and the turbo needed to be replaced.

Engine started knocking and developed slow acceleration out of the blue. In addition car has locked up on freeway despite not having any cars around me. Its been in the shop for 3 days and still no diagnosis.

While driving on a highway, the vehicle intermittently suffers a sudden loss of engine power during acceleration, accompanied by a flashing check engine light. The most serious event occurred while merging into traffic when the vehicle failed to accelerate normally and briefly lost power, creating a risk of being struck by faster-moving vehicles. Pulling over and restarting temporarily restores normal acceleration, but the problem recurs. The malfunction appears consistent with an engine misfire/powertrain fault. An OBD scan has shown misfire-related diagnostic codes (random/multiple misfire and a cylinder-specific misfire). The condition is intermittent and often occurs after approximately 10–45 minutes of driving. The vehicle remains available for inspection. The vehicle has been presented to authorized service departments multiple times. Dealers reported they were unable to duplicate the issue during road testing and no lasting repair has been completed. The manufacturer has been contacted and the vehicle has been evaluated through authorized service channels, but the underlying cause has not been identified. This remains a safety hazard because it reduces acceleration in traffic. Incident list: • 10/25/2025 (~12:25 PM; ~3,108 miles): Loss of power while merging; flashing CEL; restart temporarily resolved. • 10/27/2025–11/04/2025: Intermittent recurrence, usually lasting a few minutes then clearing. • 11/05/2025 (~8:01 AM; ~3,641 miles): Flashing CEL and misfire/loss-of-power symptoms; taken for service. • 11/26/2025 (~10:06 AM): Another episode consistent with the same pattern. • 12/17/2025 (~8:21 AM): Another episode, including during travel to a service visit. • Ongoing: Episodes after ~10–45 minutes; sometimes requires restart to restore drivability. Observed codes: P0300 and P0301. Safety risk: loss of power during acceleration/merging increases risk of rear-end or side-impact collision.

While driving on a highway, the vehicle intermittently experienced a sudden loss of engine power during acceleration, accompanied by a flashing check engine warning light. The most serious event occurred while merging into traffic, when the vehicle failed to accelerate normally and briefly lost power, creating a risk of being struck by faster-moving vehicles. After pulling over and restarting the vehicle, normal acceleration temporarily returned, but the problem has recurred multiple times. The malfunction appears to be related to an engine misfire or powertrain fault because the check engine light flashes during the events and an OBD scan has shown misfire-related diagnostic codes (random/multiple misfire and a cylinder-specific misfire). The condition is intermittent and typically occurs after the vehicle has been driven for approximately 10–45 minutes. The vehicle remains available for inspection. The vehicle has been presented to authorized service departments multiple times for diagnosis. The dealerships have reported that they were unable to duplicate the issue during road testing and no lasting repair has been completed. The manufacturer has been contacted and the vehicle has been inspected/diagnosed through authorized service channels, but the underlying cause has not been identified. The failure continues to occur intermittently and is a safety hazard because it affects acceleration in traffic. Incident list 10/25/2025 (~12:25 PM; ~3,108 miles) — While accelerating to merge onto a highway, the vehicle lost power and the check engine light flashed. The driver pulled over, shut the vehicle off, restarted, and the condition temporarily resolved, allowing the trip to continue. 10/27/2025–11/04/2025 — The same loss-of-power/misfire behavior recurred intermittently, typically lasting a few minutes before clearing. 11/05/2025 (~8:01 AM; ~3,641 miles) — The check engine light flashed again and symptoms consistent with misfire/loss of power were present. The

The infotainment and instrumentation cluster will reboot while driving. This has happened multiple times while on the express way and while using super cruise. When the event happens the infotainment and instrument cluster will turn black for multiple minutes rebooting. At times they do not successfully reboot and forces the vehicle to pull over stop and force a system reset.

suddenly went into limp mode on the highway, engine had to be replaced due to bearing failure sending metal through the engine

This has happened twice. Once in November 2025 and then in January 2026. With super cruise engaged while going around a curve super cruse disengages and the steering wheel turns to driving straight. You have about one or two seconds to take control or crash. This happened while driving about 70 mph on interstate I 70 and next on Ohio 122 going about 45 mph. On I 70 it was a gentle curve and on 122 it was a much sharper curve. Super cruse must give a warning that it about to disengage that is much longer than one or two seconds.