2025 GMC YUKON Complaints
View complaints related to 2025 GMC YUKON. The complaints found here are submitted by actual consumers with first hand experience. There are more than 80 complaints submitted for the 2025 GMC YUKON. You can submit your own complaint to the NHTSA or call the Hotline, Monday-Friday 8am to 8pm at (888) 327-4236, TTY: (800) 424-9153.
-
2025 GMC YUKON- Waterford, WI
My vehicle, with only 2,400 miles on the odometer, has been diagnosed as requiring a full engine replacement. While driving on the interstate, a warning message appeared indicating reduced acceleration. I was able to exit the freeway safely, but the vehicle could no longer maintain adequate speed to match traffic flow. Prior to this, the check engine light came on, but no issues were reported in the vehicle’s status system. I contacted OnStar, and they advised me to take the vehicle to a dealership within seven business days. It has since been at the dealership awaiting parts. Upon further research, I discovered that this issue appears to be widespread. General Motors has issued a technical bulletin addressing the problem, which involves complete engine replacement. Additionally, the audio system intermittently emits a loud crashing noise that is startling and potentially dangerous—it has caused me to veer off the road due to its intensity. This issue also seems to affect other 2025–2026 Yukon and Tahoe models.
Source: NHTSA WEB SITE -
2025 GMC YUKON- Atlanta, GA
While traveling on the interstate at 10:30p, 6 hours into a highway trip, the vehicle shuttered violently and lost propulsion and powered systems control. We were traveling at 75 mph on cruise control and immediately had to take evasive action to avoid other vehicles traveling at highway speed as our vehicle rapidly decelerated to a stop. We were barely able to get to the shoulder of the highway before the vehicle came to a complete stop and all dashboard lights illuminated. There was no warning or indication of immanent failure or engine issue. The catastrophic engine failure did not allow for the attempted restart. After opening the engine bay we noted that the coolant reservoir was empty but there was no indication of any leaking fluid in the engine bay or on the ground. The coolant levels were normal at the trip start. We were stranded on the side of the busy interstate for approximately 2 hours awaiting OnStar assistance and were forced to exit the vehicle due to its proximity to the edge of an active lane, leaving us exposed and without any protection for 2 hours, in the middle of the night, until assistance arrived. It was a harrowing experience and we are lucky that we were not injured or killed. The vehicle could not be disengaged from park and had to be dragged onto the flatbed. It was taken to the local GMC dealership and left for diagnosis. It was determined that the #2 piston rod broke, smashed valves and sent metal into all engine systems. Bothe the engine and coolant system were replaced. In addition, the torque converter locked up and had to be removed during servicing. All parts were retained by GM.
Source: NHTSA WEB SITE -
2025 GMC YUKON- Sun City West, AZ
After less than 2000 miles, the OnStar module failed, which removed the capability for emergency assistance, GPS, advanced cruise control, etc. The part is on back order with no ETA, and it appears, based on my research, that this is a common problem with GM vehicles for the past several years. Not having the emergency assistance phone system available is an extreme safety issue, as there are many areas of the US that do not have adequate cell coverage to get assistance in an emergency. It seems as though GMC does not care.
Source: NHTSA WEB SITE -
2025 GMC YUKON- sour lake, TX
The 6.2 engine in our 2025 Yukon Denali with 3,200 miles just locked up. It needs to be replaced. They said they fixed the problem and it was only affecting 2021 to 2024, but it is carrying over into 2025. They should just buy this vehicle back.
Source: NHTSA WEB SITE -
2025 GMC YUKON XL- Saint Petersburg, FL
The rear view camera is not sufficient for full time use. The camera is positioned too low and during times of dawn/night/dusk if a truck of similar size pulls up behind you, your camera is completely blinded by headlights. Leaving you unable to see anything in the rear view camera. This is a serious safety concern as you are unable to see if anyone is approaching your vehicle to cause you harm. The low camera placement also does not allow for an acceptable/comparable view as using the rear view mirror. The zoom does not pull out far enough to see multiple lanes of traffic and even during the daylight, if someone is approaching the vehicle to cause you harm, it would not be visible. The camera placement only allows you to view the front grill or hood of the vehicle behind you.
Source: NHTSA WEB SITE -
-
2025 GMC YUKON- SALEM, OH
While engaged, Super Cruise failed to detect lines on road on a bend and launched the vehicle in the opposite lane without warning. This has occurred two separate times. First time was in late June 2025 on the PA Turnpike. Traveling at 70 mph. It was a left hand bend in the road where it failed to detect lines on road and thrust vehicle into the right hand lane. Happened so fast there was no time to react. In addition Lane Keep Assist was active as well. Also note lines were present on the left and right side of vehicle. Luckily no one was beside me. Second time was one a two lane road going 45 mph. Same scenario as first. Vehicle DIC stated it had lost road lines and threw me into the left lane without warning. Luckily no car was coming or it would have been a head on collision. Same message o display vehicle lost lines on road.
Source: NHTSA WEB SITE -
2025 GMC YUKON XL- Vincent, OH
Transmission malfunctioned 4 separate times. Engine and service transmission light came on. Vehicle shifted hard and became immobile at certain times. 4 tropes to a dealer for repair. Latest repair was replacing ECM and problem still persists.
Source: NHTSA WEB SITE -
2025 GMC YUKON- Cave Creek, AZ
The console screen that control many vehicle functions will often not boot up when the vehicle is started. Screen crashes have also happened while underway. The screen will be unresponsive to both touch and physical controls. Systems unable to be controlled include safety cameras and sensors, climate control, navigation, gauges, infotainment and others. I have attached a diary of specific issues and work arounds attempted. The dealership and GM do not appear to have methods of fixing the issue at this time.
Source: NHTSA WEB SITE -
2025 GMC YUKON XL- Bauxite, AR
keep quit working when i was driving , i just pick up from delearship for i another issue with on-star and is not part available is been there for over month not fix and now the brakes issue
Source: NHTSA WEB SITE -
2025 GMC YUKON XL- Fairfield, CA
On August 9th at 5:30PM roughly, while attempting to park using the vehicle’s Park Assist feature, the system failed to function properly—specifically, it failed to detect a pole at the rear of a parking space, did not slow or brake the vehicle, and was not even aware it would contact the pole. It then collided with the pole. Also, intermittently the forward collision alert system either does not alert for similar circumstances as it just previously did. Seem untrustworthy. Scary. GM's product allegation team (PAC) had all of the necessary information to show the system does not work 100% of the time (I have it all on video and submitted that) and they denied my claim and refused to admit a system failure even when given the videos showing the park assist failing to engage properly ON VIDEO.
Source: NHTSA WEB SITE