2024 GMC YUKON XL Complaints

6/16 Vehicle issues while driving home from work. Rough idle, multiple check engine lights coming on, Multiple warnings display on dashboard. Vehicle in limp mode from work to home. 6/20 While driving in Roanoke rough idle began. Vehicle check engine light appeared, limp mode only lasted for less than 30 seconds before it went back to normal. 6/23 Vehicle issues began again while driving to work. Pulled into parking lot, turned vehicle off and restarted. Vehicle seemed back to normal. Made appointment through GMC App for first available on 6/29. Leaving work vehicle check engine lights came on again and went into limp mode. 26,764 miles. Drove straight over to Hart GMC (2 miles away) and dropped it off. 6/30 Picked up Vehicle at Hart GMC. Miss fire on cylinder #3. Replaced spark plug #3 and cleared all dtcs codes. 8/6 Oil Change with Consumption Test started 29,072 miles 8/28 Engine Oil Low-Add Oil alarm. Instructed by dealer to not tamper with Test. Must drive 2000 miles before returning vehicle to validate consumption test. 29,728 miles 8/30 Pulling into drive way rough idle began. Vehicle check engine light appeared, limp mode, multiple lights. Scanned with OBD2 scanner- P0303 code. Misfire cylinder 3. 8/31 Vehicle towed from home to Hart motors 29,860 miles. Scanned by service showing P0300 codes along with other codes. I have documented all events with this engine since owning. Concerned the engine would run out of oil before validating consumption test (2000 miles). Dealer told me to keep driving even if it says add oil. Engine historically 2 qts low when add oil warning flashes.

On August 20, 2026, while driving my 2024 GMC Yukon XL Denali equipped with the 6.2L V8 engine at approximately 70 mph on the interstate, the vehicle experienced a sudden and complete loss of motive power without adequate warning. The vehicle unexpectedly shifted into neutral and would no longer accelerate or maintain highway speed. This occurred in active interstate traffic and almost resulted in a serious accident as I attempted to maneuver the vehicle out of the flow of traffic. The engine would not restart, and the vehicle had to be towed to a GMC dealership. The GMC dealership subsequently diagnosed that the engine had locked up and determined that the engine requires complete replacement. This failure created an immediate and significant safety hazard for me, my family, and surrounding motorists. My vehicle is affected by the 6.2L engine recall, and I am extremely concerned about the safety and reliability of the proposed replacement engine. I have become aware of reports from other owners alleging failures involving replacement engines as well, including similar sudden losses of propulsion. I am concerned that replacing the engine may not adequately address the underlying safety risk if replacement engines are experiencing similar failures. I am requesting that NHTSA investigate not only the original engine failure, but also whether replacement engines used as a remedy are adequately correcting the defect. A sudden engine lockup and complete loss of propulsion at interstate speeds presents a serious risk of collision, injury, or death.

My vehicle "passed" the engine recall only to have the engine blow at 33,000 miles. My vehicle was at the dealership for 52 days most of the time was spent waiting for the new engine. Dealership was amazing, GMC however is the worst. My new engine has about 1,000 miles on it and it stutters occasionally when the auto start turns on.

On the freeway in the middle of nowhere Denali jerked, went into neutral, and stopped completely. Needed to get towed and it was complete engine failure. Dealership needed to completely replace engine and radiator

The contact owns a 2024 GMC Yukon XL. The contact stated that upon taking the vehicle to the dealer to be repaired under NHTSA Campaign Number: 25V274000 (Engine and Engine Cooling), the contact was informed that the vehicle passed the inspection and no repair was needed. However, the vehicle experienced engine failure approximately seven months later. While driving 50 MPH, the vehicle lost motive power. There was no warning light illuminated. The driver pulled over, restarted the vehicle, and resumed normal driving. The vehicle was taken to the dealer the following morning, where the Electronic Control Module was replaced under warranty; however, the failure recurred while driving 70 MPH three weeks later. No warning light was illuminated. The driver pulled over, restarted the vehicle, and resumed driving; however, the vehicle failed to exceed 40 MPH and shut off. The vehicle failed to restart and was towed to the dealer, where it was diagnosed and determined that the engine, radiator and seal kit needed to be replaced. The vehicle was not yet repaired. The contact was concerned that the recall remedy failed to prevent the failure. The manufacturer was notified of the failure and a buyback was requested, but the request was denied, and the contact was referred to the dealer for additional assistance. The failure mileage was approximately 27,800.

Driving on highway, engine stopped while driving 70+ mph. Had to get to the side of the multilane highway. Was towed to nearest GMC dealership. Dealer said the engine was locked up, and they have many vehicles right now with similar problems. They will have to replace the engine due to complete engine failure.

6.2 engine seized again after oil change 3 days after This is my 3 rd Yukon that has done this and I’m not agreeing this shouldn’t be a recall I’ve been through this before

We're in the waiting period for our 3rd engine. 1st engine failure, while driving on interstate at 70+ MPH, engine stopped running, causing a very unsafe condition for family and surrounding vehicles. Engine failure 2 days later, towed to dealership for inspection, replacement engine was installed ~4 weeks later. 2nd engine failure, while driving on interstate at 75+ MPH, engine seemed underpowered and would rev upwards of 6000+RPMs, not exactly unsafe, but not usual operating conditions either. Returned to dealer, upon inspection, total engine replacement was recommended.

Cameras go black and become inop randomly. Been in shop multiple times for concern. Software updates have been performed, modules replaced, cables, and now it’s back for the same concern.

Driving on highway at 80 MPH and accelerator stopped working and car turned off. We had to coast off toll rd and hope for the best. No warning and happened with our whole family in the car. I had a recall notice from manufacturer but last time I tried contacting manufacturer/dealer they said no resolution was available to repair recall yet and that I couldn’t drop off my vehicle.