GMC Complaints

March 29th 2026 my 2021 Yukon XL engine stalled while driving at 45mph (No prior warning lamps or messages, restart engine came on dash) causing me to immediately pull over and come to a stop still in traffic, it shifted my vehicle into park, I was in an in an un-safe spot and was stuck in park (conditions not correct for shift on dash) because my vehicle would not allow me to shift to neutral and push it to the side of the road, (could not jump start) Had towed to dealership and mentioned Engine Failure and Fuel pump control module Recalls but according to them it was a starter issue, I asked them to still check the fuel pump control module regardless. Picked up vehicle and a week later April 14th the exact same thing happened vehicle stalled while driving dash said Restart Engine while coasting (No prior warning lamps or messages) forcing me to pull over where it rolled to a stop and locked itself into park leaving me in unsafe conditions again. Had towed back to the same dealership and waiting to hear back from them.

The contact owns a 2025 GMC Sierra 2500. The contact stated that the front driver’s side door handle failed to operate as needed, and the contact was unable to exit the vehicle through the driver’s side door. The vehicle was taken back to the dealer, and a new handle was ordered. The part was replaced under warranty. Soon after the repair, the liftgate failed to open or close as needed and became inoperable. The vehicle was taken back to the dealer for the liftgate to be serviced under warranty. The manufacturer was not notified of the failure. The vehicle remained with the dealer unrepaired. The failure mileage was approximately 300.

The engine coolant temperature sensor has failed on my 2019 GMC Canyon. The check engine light is illuminated, the temperature gauge does not register correctly, the air conditioning has been disabled by the vehicle's computer, and the engine cooling fan continues to run after the engine is turned off. These symptoms are consistent with the vehicle entering fail-safe mode due to loss of a valid coolant temperature signal. The problem was confirmed by an independent mechanic who diagnosed a failed coolant temperature sensor. The mechanic attempted to source a replacement part through GMC but was informed the part was unavailable. The reason for the parts unavailability is unknown, though in his experience, it typically means that the manufacturer is stocking up and preparing for a recall This issue appears to be widespread across 2017–2020 GMC Canyon and Chevrolet Colorado V6 trucks based on extensive owner forum documentation. The safety concern is significant: without reliable coolant temperature monitoring, there is no assurance the engine is operating within safe thermal limits, and the driver has no warning if overheating occurs. The disabled A/C also creates a safety risk during periods of extreme heat. The vehicle has approximately 60,000 miles. The problem has been present for approximately three months and is ongoing.

This is the 4th time my vacuum pump has “broke” my brakes become hard and stiff and my brake assist light comes on. It happens EVERY winter when it drops below freezing. This is the second time this winter it has broke and now my check engine light is on. It is not cheap to fix and a major safety issue. Would like to add I was only backing out of my drive way this last time it happened. I was going maybe 5-10 mph.

My engine starting making a knocking/ticking noise out of no where. I was traveling alone on the highway so I stopped to check it. I got to a gas station and google searched it and it came up that the LS 6.2 engine that is in my vehicle was recalled on other models because of this issue. I did have a mechanic look at it as well and he agreed it is that same issue that was recalled in other models.

The 2018 Yukon has been at the dealership several timeswaiting for a valve body for the transmission. There are valve body recalls for other year GM vehicles with the same transmission, but not for the 2018 model even though it appears to be the same part number. I don’t understand how this 2018 model apart of the recalls when it’s got the same issues as the newer ones. This is the second Yukon I’ve bought in the last seven years and the other one had the exact same issue.

I was driving down the road at 55 mph on 4/12/2026 and had let off the gas for a 45 mph zone when I experienced a violent downshift of the transmission that squealed the tires momentarily and felt like someone had hit me from behind. It startled me and caused me to lower my speed down to 20 mph. I continued driving to my destination and when I let off of the gas doing 45 mph for a slight curve I had another violent downshift that felt again like someone hit me from behind. I contacted a GMC dealer on 4/13.2026 to see if there was a recall on the transmission that I wasn't seeing online and was told no. I described what I experienced to their service department and was told to flush out the transmission fluid and replace the filter. I did experience another bad downshift at a slower speed (about 25 mph) on 4/13/2026. There wasn't any warnings or lights that came on when these three incidents occurred. When looking online I did see there was a similar recall for 2020-2022 GMC Sierra's where customers were experiencing similar violent transmission downshifts and am wondering if this issue is affecting more than just those three model years.

Coolant control valve failed. Seems to be a known issue with year make and model but not all vin have been approved for special warranty despite occurring on same vehicle.

Hello. I got a recall and fixed in July 2021 for Blind Spot Sensors/Modules on my 2016 GMC Acadia SLT. Now 3.5 years later Im having the same issue with these sensors that are located in the rear bumper of the car, they get water damage, corrosion, and then fail. A very poor design. And seems like the recall didn't fixed the issue either. This must to be a common issue for this car, lots of complaints online even after the recall. And the car dealership wont cover it because it was already fixed at that time and my warranty on my car expired not to long ago. They said it would be about $2000 to fix. I feel like this prematurely failed and it was recalled once for the same issue but now failed again is crazy after 3.5 years. This shouldn't be a on going thing especially after a recall. I shouldn't have to pay for this outta my own pocket for a flawed design and would like my repairs for this to be covered again. Please help. Attached is a invoice from July of 2021 recall that was repaired. I only got a verbal estimate from the dealership (text messages) which I do have. saying that it would be a $2000 fix this time. I didn't go through with it because I feel like it should be covered. Attached pictures of sensor/module in rear bumper that is corroded. Lights on both side mirrors will come on and stay on. Won't shut off. Messages on dash saying "Service Side Dectection System". Blind zone setting won't shut off.

The article below appears online, 4/13/2026. I have the exact same problem with my 2020 GMC Terrain Denali and I would like other GM vehicles added to their Chevy recall. They use the same parts within GM's product lines. As background info, I went to the dealer, Matick Buick GMC, 29300 Telegraph Rd, Southfield, MI 48034 on Jan. 14, 2026 for repair. I was told water infiltrated my backup camera and its harness. Matick said very few parts are available in the USA. Still not fixed and it is dangerous. Yes is the answer to the 1st 4 general guideline questions. The 5th question is NO. READ MORE TRENDING NEWS: Chevrolet has recalled 271,770 vehicles over an issue with the rearview camera. Some 2023 to 2025 Chevy Malibus were recalled because the camera screen may show a distorted or blank image, the National Highway Traffic Safety Administration said. Dealers will replace the camera at no cost to correct the issue. Owners will get letters in the mail alerting them to the problem after May 18, the agency said. For more information, call Chevrolet at 800-222-1020. The company’s internal recall number is N262551720. The vehicle identification numbers can be searched on NHTSA.gov.