GMC Complaints

View complaints related to GMC. The complaints found here are submitted by actual consumers with first hand experience. You can submit your own complaint to the NHTSA or call the Hotline, Monday-Friday 8am to 8pm at (888) 327-4236, TTY: (800) 424-9153.

  • 2020 GMC SIERRA 1500
    - Byron Center, MI

    At approximately 54,000 miles had a complete engine failure. Lifter blew apart and damaged crank shaft. Complete engine rebuild. Rebuilt in approximately 3 weeks. 2022 At approximately 138,000 miles had another complete engine failure. Lifter blew apart again, Entire engine was replaced. New engine took 10 weeks to get. Installed in 2 days after recieved. 2025 No symptoms or warning lights present prior to failure.

    Source: NHTSA WEB SITE
  • 2019 GMC YUKON
    - Monroe, NC

    Driving out a town 400 miles away, with a young passenger in my car on [XXX] in rush hour traffic, i started hearing a slight ticking sound then moved into a full blown knock on my drivers side ( I recorded it). within minutes, my oil light came on and my dash notification reading "engine overheating idle" with the knocking really load. I had to cross 3 lanes to traffic quickly to get to the shoulder of the road, which was NOT a safe place. I smelled smoke and cut the the engine off. I popped the hood to see that there was now no coolant (that is all I knew to look for). I immediately called OnStar Roadside assistance. 2 hours later, I was towed to a local hotel room. Car completely dead. not lights, couldn't lock it, nothing. I had to pay a large fee (almost $2k) to have my car towed back to NC from AL not to mention having rent a rental car to get us home. the car is now at a GMC dealership in Monroe NC. of course the Powertrain extended warranty doesn't cover the Battery replacement, belt replacement and water pump replacement so now I'm out of pocket $1300 just to get those install to be able to try and start the engine to further diagnose if my I have complete engine failure AND without transportation. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

    Source: NHTSA WEB SITE
  • 2019 GMC ACADIA
    - Carmel, CA

    The contact owns a 2019 GMC Acadia. The contact stated that upon attempting to turn off the vehicle, the vehicle failed to register that the transmission was in park(P) and the vehicle failed to turn off. The contact stated that the vehicle continued to beep. The "Shift to Park" message was displayed. The contact stated that the vehicle required to be turned off and restarted several times, or to be driven to shift to park(P) successfully. Upon investigation the failure, the contact linked the failure to GM Technical Service Bulletins: 18-NA-297 and 19-NA-206. The vehicle was taken to the local dealer, where it was diagnosed with a faulty shift control, and the dealer determined that the shift assembly needed to be replaced. The vehicle was not repaired. The manufacturer was contacted and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 52,280.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2021 GMC YUKON XL
    - Lawrenceville, GA

    The contact owns a 2021 GMC Yukon XL. The contact stated while driving at an undisclosed speed, the low engine oil warning light illuminated. The contact checked the oil dipstick and noticed that the oil level was extremely low. The contact stated that the vehicle was serviced by the dealer a month prior, and the oil change was performed. The contact stated that the oil level required to be topped off several times while driving the vehicle to the dealer. The vehicle was taken to the dealer, where an oil consumption test was performed, and the vehicle was diagnosed with engine failure. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The contact referenced an unknown recall with a similar failure description; however, the VIN was not included in a recall. The manufacturer was not made aware of the failure. The failure mileage was approximately 74,500.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2023 GMC SIERRA 1500
    - Corpus Christi, TX

    ECM - Engine System code P0700 and TCM - Transmission System code U0073. The truck went in to first gear and wouldn't go over 5 MPH on the highway. The dealer is saying it can't be replicated but it's happened multiple times to the vehicle in the past week. The truck was taken to the dealership and inspected but they claim nothing is wrong. The check engine light came on as well as the aforementioned codes.

    Source: NHTSA WEB SITE
  • 2015 GMC YUKON
    - Haslet, TX

    While driving my 2015 GMC Yukon Denali on the highway, the vehicle suddenly began shaking and lost power. I immediately exited the highway for safety and had to “nurse” the vehicle about two miles at 10–15 mph to reach home. The vehicle would no longer run afterward. A mechanic later diagnosed a lifter and camshaft failure. This is a known and common issue with GM 5.3L and 6.2L engines that poses a serious safety risk when it occurs at highway speeds. No warning lights or prior symptoms were present before the failure. I did not report it to the dealer, but the vehicle had to be towed to a mechanic for diagnosis. The vehicle is available for inspection.

    Source: NHTSA WEB SITE
  • 2021 GMC ACADIA
    - Virginia Beach, VA

    The contact owns a 2021 GMC Acadia. The contact stated while driving 75 MPH, the check engine warning light illuminated. Additionally, the accelerator pedal was depressed, but the vehicle failed to accelerate as intended. The vehicle was driven to the shoulder of the road. The contact stated while attempting to start the vehicle, the vehicle failed to start as intended. The contact stated that the failure had nearly caused the vehicle to be run over by a tractor trailer. The contact's wife and three minor children were also occupying the vehicle during the failure. The contact stated that he and his family could have been killed due to the failure. The vehicle was towed to the dealer, where it was diagnosed with fuel pump power control module failure. The contact was informed that the fuel pump power control module needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure and a case was filed. The contact related the failure to an unknown recall; however, the VIN was not included in the recall. The failure mileage was approximately 35,500.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2017 GMC YUKON
    - Ocala, FL

    The contact own a 2017 GMC Yukon. The contact stated that the vehicle failed to shift from 2nd to 3rd gear while driving and remained stuck in gear. There was no warning light illuminated. The vehicle was taken to the dealer, where it was diagnosed and determined that the transmission needed to be replaced. The vehicle was not repaired due to the cost. The manufacturer was notified of the failure and informed the contact that assistance would not be provided because the warranty had expired. The failure mileage was approximately 78,000.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2019 GMC ACADIA
    - Rancho Santa Margarita, CA

    The put in park shows after engine is turned off, have to restart and shift out of park and back to park. This could take several times to accomplish.

    Source: NHTSA WEB SITE
  • 2019 GMC SIERRA 1500
    - Dwight, IL

    It is the same issue with 2021-2024 6.2L engines that have already been recalled. I have to replace lifters and cam because of the issue.

    Source: NHTSA WEB SITE